Report discussing a new instrument is described which is capable of simultaneously recording the position of the three controls of an airplane. The records are taken photographically on a standard N.A.C.A. film drum and the instrument can be quickly installed in any airplane.

From Introduction: "A model of the F-5-L seaplane was made, verified, and tested at 40 miles an hour in the 8' x 8' tunnel for lift and drag, also for pitching, yawing and rolling moments. Subsequently, the yawing moment test was repeated with a modified fin. The results are reported without VL scale correction."

Note presenting a determination of the relative merits of various fuels for use in high compress engines. The main purpose is to discuss a phase that has not been given much attention in previous studies; specifically, the standpoint of the influence of charge temperatures and pressures on the temperatures and pressures after combustion.

"It has been customary to calculate the strength of the rear wing beam for the 'high speed' condition on the assumption that the center of pressure was at 0.50 of the wing chord. It can be shown that this assumption is not justified, regardless of the utility of a 'high speed' condition in strength calculations" (p. 1).

The favorable speed of an airship is chiefly determined by the condition of the consumption of the least amount of fuel per unit of traveled distance, although other conditions come into play. The resulting rules depend on the character of the wind and on the variability of the efficiency of the engine propeller units. This investigation resulted in the following rules. 1) Always keep the absolute course and steer at such an angle with reference to it as to neutralize the side wind. 2) In a strong contrary wind, take a speed one and one half times the velocity of the wind. 3) As a general rule, take the velocity of the wind and the velocity of the course component of the wind. Add them together if the wind has a contrary component, but subtract them from each other if the wind has a favorable component.

Thin metal diaphragms form a satisfactory means for comparing maximum pressures in internal combustion engines. The diaphragm is clamped between two metal washers in a spark plug shell and its thickness is chosen such that, when subjected to explosion pressure, the exposed portion will be sheared from the rim in a short time.

In order to determine an approximate formula giving the weight of a dead load as a function of the volume (V) of the envelope and of the maximum velocity (v), we will take the relative weight of the various parts of the airship (P(sub v), M, V, A, T(sup 34)), adopting a mean value of the coefficients determined. This formula may be adopted both for semi-rigid airships with suspended nacelle and non-rigid envelope, with or without internal suspensions. It may also be adapted to airships with rigid longitudinal beam, with power units on external supports or in nacelles, and with non-rigid envelopes, with or without internal bracing cables.

On of the most important characteristics of an airfoil is the rate of change of lift with angle of attack, (sup dC)L/d alpha. This factor determines the effectiveness of a tail plane in securing static longitudinal stability. The application of the Gottingen formulas given here for calculating the variation of (sup Dc)L/d alpha with aspect ratio should be of interest to many aeronautical engineers. For the convenience of the engineer, a set of curves calculated by the method set forth here are given in graphical form. Also, the observed values of (sup dC)L/d alpha for the same airfoil at various aspect ratios follow the calculated curves closely.

"Free flight tests were carried out to show whether the longitudinal oscillations of a standard S.E.5A airplane are noticeably affected if its longitudinal moment of inertia is increased. These oscillations were taken by means of a self-recording instrument, the airplane having first its ordinary moment of inertia and then one increased by 14 percent. The period of oscillation was slightly longer after the increase of the moment of inertia, but the damping was not affected" (p. 1).

"This investigation was undertaken to determine the relative effects of those factors which may interfere with the rudder control of an airplane, with especial reference to the process of landing. It shows that ground interference is negligible, but that the effects of a large rounded body and of the slip stream may combine to interfere seriously with rudder control at low flying speeds and when taxiing" (p. 1).

"In several instances where control flaps are placed in the trailing edges of thick sections, it has appeared that a dead center (slackness or lack of control) exists about the neutral position. The condition was also experienced in the rudder action of the XB1A observation airplane. Examination of smoke pictures of the airflow around struts and airfoils indicates what may be the cause of the phenomenon" (p. 1).

Comprehensive tests were made to compare the performance of the F-5-L Boat Seaplane fitted with direct drive and Liberty engines. Details are given on the test conditions. The conclusions of the comparison tests follow. 1) An F-5-L with geared engines takes off in approximately 90 percent of the time required for the same airplane with standard direct drive engines. An F-5-L with geared engines climbs in 20 minutes to an altitude approximately 20 percent greater than that obtained with the standard direct drive on the same airplane.

Performance characteristics for the F-5-L Boat Seaplane are given. Characteristic curves for the RAF-6 airfoil and the F-5-L wings, parasite resistance and velocity data, engine and propeller characteristics, effective and maximum horsepower, and cruising performance are discussed.

The speed, barometric pressure, and number of revolutions of the engine of a seaplane were measured, including tests with stopped engine. The mean data obtained are given in the following note; the results of the gliding tests are used for the computation of the lift and drag coefficients, and by making use of them the results of the engine flights are used for the computation of the propeller efficiency.

Note presenting experiments with cylinders of different shapes and some of the strange phenomena that manifested in connection with the cylinder.

An airship model made by the Goodyear Rubber Company was filled with water and suspended from a beam. The deformations of the envelope were studied under the following conditions: 1) both ballonets empty; 2) forward ballonets filled with air; 3) rear ballonets filled with air; and 4) both ballonets filled with air. Photographs were taken to record the deflections under each of these conditions, and a study was made to determine the minimum head of water necessary to maintain the longitudinal axis of the envelope under these conditions. It was concluded that any pressure sufficient to keep the airship full may be used. It appears that a pressure of one inch of water would provide a suitable factor of safety, and therefore it is the pressure that is recommended.

Although it is well known that the strength of wood depends greatly upon the time the wood is under the load, little consideration has been given to this fact in testing materials for airplanes. Here, results are given of impact tests on clear, straight grained spruce. Transverse tests were conducted for comparison. Both Izod and Charpy impact tests were conducted. Results are given primarily in tabular and graphical form.

This report is broken up into two sections: one about the regulators for speed of wind tunnel drive motor and one about a vernier manometer with adjustable sensitivity.

"A new instrument known as the NACA three component accelerometer is described in this note. This instrument was designed by the technical staff of the NACA for recording accelerations along three mutually perpendicular axes, and is of the same type as the NACA single component accelerometer with the addition of two springs and a few minor improvements such as a pump for filling the dash-pots and a convenient method for aligning the springs. This note includes a few records as well as photographs of the instrument itself" (p. 1).

Thus far, all attempts at the quantitative determination of drag, on the basis of the theory of viscous fluids, have met with but slight success. For this reason, whenever a more accurate knowledge of the drag is desirable, it must be determined by experiment. Here, a few experimental results are given on the drag of a cylinder exposed to a stream of air at right angles to its axis. It is shown that the drag depends on the absolute dimensions of the body and the velocity and viscosity of the fluid in a much more complex manner than has heretofore been supposed.

"The laws of curvilinear motion are established and the transverse forces on elongated airship hulls along a curved path are investigated" (p. 1).

"The results of the two preceding notes are applied to airships and checked with wind tunnel tests" (p. 1).

"The study of the motion of perfect fluids is of paramount importance for the understanding of the chief phenomena occurring in the air surrounding an aircraft, and for the numerical determination of their effects. The author recently successfully employed some simple methods for the investigation of the flow of a perfect fluid that have never been mentioned in connection with aeronautical problems. These methods appeal particularly to the engineer who is untrained in performing laborious mathematical computations, as they do away with these and allow one to obtain many interesting results by the mere application of some general and well-known principles of mechanics" (p. 1-2).

The different kinds of energy losses of the propeller and the values of the constants determining them are discussed.