Report discussing an experimental investigation was carried out on air- and vacuum-melted M-252 and S-816 alloys to find conditions of heating and hot-working which resulted in abnormal grain growth. The experiments were mainly limited to normal conditions of heating for hot-working and heat treatment and normal temperatures of solution treatment were used to allow grain growth after susceptibility to abnormal grain growth was developed by various experimental conditions. Results indicated that small reductions of essentially strain-free metal were the basic cause of such grain growth.

From Introduction: "The data included in this report for Nimonic 80A alloy, for instance, represent experiments carried out to help clarify a production problem of grain-size control in an alloy which has been extensively used. The general procedure of the investigation was to carry out controlled laboratory experiments on samples of bar stock to find conditions of heating and hot-working which resulted in abnormal grain growth."

From Introduction: "This report describes some measurements of these quantities obtained by crashing fighter aircraft under circumstances approximating those observed in service."

Memorandum presenting an experimental study of the effects of several variations in configuration geometry on the aerodynamic characteristics of flat-top wing-body combinations. Generally, the configurations consist of one half of a body of revolution mounted beneath a wing of essentially arrow plan form. Results regarding the effect of trailing-edge sweep, effect of the addition of auxiliary bodies, effect of tip-flap deflection, effect of dihedral, effect of leading-edge sweep, effect of fuselage fineness ratio, effect of fuselage profile shape, and static longitudinal stability characteristics are provided.

From Introduction: "The configuration described in this paper represents one approach to such an airplane and the results of the wind-tunnel and tank evaluations are presented. In the present investigation, the aerodynamic longitudinal characteristics over a Mach number range from 0.6 to 1.97 were obtained."

Report presenting an investigation at Mach number 4.06 on a typical supersonic airplane model with a 40 degree sweptback wing. The purpose of the investigation was to determine the effectiveness of using wedges on the body and on the vertical tail to increase the static directional stability. Results regarding the longitudinal characteristics and lateral characteristics are provided.

"The basic aerodynamic characteristics of a 0.04956-scale model of the Convair TF-102A airplane with controls undeflected have been determined at Mach numbers from 0.60 to 1.135 for angles of attack up to approximately 22 deg in the Langley 8-foot transonic tunnel. In addition, comparisons have been made with data obtained from a previous investigation of a 0.04956-scale model of the Convair F-102A airplane. The results indicated the TF-102A airplane was longitudinally stable for all conditions tested" (p. 1).

From Introduction: "The present report is concerned with the characteristics of a body in the two-dimensional flow field of a circular-arc wing of rectangular plan form."

"Pressure-distribution and force tests of a circular cylinder have been made in the Langley 11-inch hypersonic tunnel at a Mach number of 6.88, a Reynolds number of 129,000, and angles of attack up to 90 degrees. The results are compared with the hypersonic approximation of Grimminger, Williams, and Young and a simple modification of the Newtonian flow theory. An evaluation of the crossflow theory is made through comparison of present results with available crossflow Mach number drag coefficients" (p. 1).

Report discussing an investigation of the aerodynamic characteristics of a model of an escape capsule with and without stabilizing fins for a supersonic bomber-type airplane. Lift, drag, longitudinal and lateral stability characteristics, and photographs of the capsule model are presented.

"An investigation has been made in the Langley 4-by-4-foot supersonic pressure tunnel to determine the aerodynamic characteristics of a series of missile configurations having low-aspect-ratio wings at a Mach number of 2.01. The effects of wing plan form and size, length-diameter ratio, forebody and afterbody length, boattailed and flared afterbodies, and component force and moment data are presented for combined angles of attack and sideslip to about 28 degrees. No analysis of the data was made in this report" (p. 1).

"A supersonic wind-tunnel investigation on store interference has been conducted in the Langley 4- by 4-foot supersonic pressure tunnel at a Mach number of 1.61. Forces and moments were measured on a large ogive-cylinder store in the presence of a 45 degree swept-wing-fuselage bomber configuration for a number of store locations below the fuselage center line. Results of the investigation show that large variations of store lift, drag, and pitch occur with changes in store or airplane angle of attack, store vertical location, and store horizontal location" (p. 1).

"The unsteady aerodynamic forces, [based on two-dimensional incompressible flow considerations], are determined for an unstaggered cascade, the blades of which are vibrating in phase in an approach flow parallel to the blades" (p. 1).

Report presenting testing of a modified 1/10-power nose shape in free flight at Mach numbers up to 6.7. Measured heating rates were presented and compared with calculated values. Results regarding transition and comparison with previous investigations are provided.

From Introduction: "The heat-transfer data calculated from measured temperatures are compared with values calculated by the theory of Van Driest for a flat plate with laminar and turbulent boundary layers. In addition, the heat-transfer data from the flight tests are compared with data obtained from the Langley Structures Research Division of ground tests of an identical wing at a Mach number approximately equal to 1.99 in the pre-flight jet of the Langley Pilotless Aircraft Research Station at Wallops Island, Va. The stream static pressure is maintained at about 1 atmosphere, the free-stream temperature at about 75^o F, and the stagnation temperature at approximately 500 ^o F (ref.1)."

From Introduction: "In the present paper, the emphasis is placed on calculating the variations of total forces and moments with angles of attack and sideslip for a number of slender plane and cruciform wing-tail combinations and for some airplane-type arrangements of a plane wing and a horizontal and vertical tail."

Report discussing an investigation of a 45 degree swept-back-wing-body combination with flap spoiler ailerons, deflector ailerons, and a spoiler-slot-deflector aileron. The pressures were measured from Mach numbers 0.60 to 1.03 and at various angles of attack.

"Results are presented for the loads and moments acting on the individual tail surfaces of a body-tail combination over a wide range of angles of attack and sideslip. The effects of forebody length and panel-panel interference on the characteristics are included. It is shown that large nonlinear variations in these loads and moments, which occur at some combinations of angle of attack and sideslip, cannot be predicted by low-angle theory" (p. 1).

Memorandum presenting a study to determine locations of pressure sensors for controlling the spike position of a blunt-lip, axisymmetric inlet with internal contraction. The inlet performance was determined at Mach numbers of 0.63 and 1.5 to 2.0 for airflow schedules corresponding to those of a given turbojet engine over a wide range of ambient temperatures. The use of the ratio of a throat static pressure to either a local total or the spike-tip total pressure provided a signal that could set nearly maximum pressure recoveries at Mach numbers of 1.7 to 2.0 and within 6 percent of maximum recovery at Mach 1.5.

Memorandum presenting a discussion of oscillating flap-type and all-movable controls with particular emphasis on the aerodynamic forces and moments at transonic speeds. Hinge-moment results from recent wind-tunnel and rocket-powered-model tests are summarized for trailing-edge flap-type controls to illustrate the effects of control hinge-line position and profile shape on one-degree-of-freedom flutter of this type of control.

Report describing the design and flight evaluation of an air-borne target simulator using precomputed relative kinematics for use in tracking studies of fighter aircraft equipped with scope-presentation type fire-control systems. Testing occurred in an F86D airplane equipped with a Hughes E-4 fire-control system. Results regarding relative kinematic programming considerations and restrictions to system evaluation are provided.

Report presenting a sample of data on atmospheric turbulence on Lockheed U-2 airplanes during research flights. The intensity, amount, and extent of atmospheric turbulence observed in the United States is in good agreement with data from England and Western Europe. Results regarding overall gust distribution, intensity of turbulence, percent of rough air, and size of turbulent areas are provided.

From Introduction: "The objective of this report are (1) to describe the complete fuel system, (2) to discuss the procedure used for transitions between JP-4 fuel and hydrogen, and (3) to present and discuss engine performance obtained with both fuels, and (4) to review the reliability of the fuel system."

From Introduction: "The feasibility of closed-loop control of ram-jet-engine thrust is demonstrated in references 1 and 2. The dynamic behavior of a 28-inch-diameter ram-jet engine designed to operate in Mach number range of 2.35 to 2.70 is evaluated herein."