Work was completed on the high-temperature, high efficiency air filter. Technical assistance was given at a large-scale, privately financed run of an all-glass medium. Full-size filers have been produced in quantity and are offered by manufacturers; it is considered that commercial manufacture has been established. A survey was made of air sampling practices at 37 laboratories. Analysis of the survey results indicated that 22 different kinds of air-sampling filer media were in use among the laboratories questioned. We have recommended that air-assay practice be simplified by use of fewer media. A group of five media has been proposed as adequate for meeting all requirements. Laboratory work was done on the development of a high-efficiency, low-ash, all-purpose, air-assay paper. Two methods of approach were tried. In one an effort was made to produce cellulose fibrils in sufficient quantity and quality to act as the fine-fiber component of a filter. Only moderate success was attained. Better promise was shown by combining synthetic organic microfibers with cellulose fibers in a wet-formed sheet. No plant work was undertaken on this item.

"The effect of correcting quadrupole lenses on the betatron oscillation characteristics of an AG synchrotron was studied, and general formulas are given for the fractional changes of the amplitude and phase functions. Calculations performed for different setups of different numbers of lenses for the CEA synchrotron structure point out that one may correct for sizable errors in the n- value by means of 8 pairs of quadrupole lenses in two consecutive straight sections with the focusing lens between defocusing sectors and vice versa. An increase of BETA /sub max/ of about 5% is obtained for DELTA n/n approximately 0.04. It was found that the necessary corrections can probably be obtained satisfactorily with lenses of 6 in. length. "

The purpose of the survey was to determine the radiation levels in the 1 D Boiler Chamber during plant operation. The conclusion of this survey is that the radiation level in the 1 D Boiler Compartment with the 1A, 1B, and 1C Main Coolant loops in service at approximately 100 per cent power ranged from .03 MR/HR to 6.0 MR/HR.

"The resonant frequencies of the magnet power supply are investigated. It is found that there are eleven resonant modes in addition to the desired mode of operation with six additional resonant frequencies. From measurements of the choke model, it appears that the frequencies of some of the spurious modes may lie in the same range as the desired mode of operation."

From the point of view of predicting melting behavior of fuel elements containing fission products after 50 percent burn-up, the fuel can be considered to consist of 2000 moles Th, 150 moles U, 55 moles of rate earth metal, 31 moles of Zr, 25 moles of Mo, 20 moles of Rh-Ru-Tc, and 15 moles of alkaline earth metal. All other fission products are present in too small amounts to have any important effect upon the melting point or will have vaporized. However, the presence of alkali metal vapor should be considered.

The statistical theory of pressure broadening is developed for any interaction law in which the potential energy is inversely proportional to some power of the distance between the molecules, including cases in which the forces change sign. This note is intended to prove two propositions: A. When a spectral line is broadened by single impacts of perturbing molecules and the half-width of the line is delta infinity, the statistical theory of broadening is applicable provided delta infinity . R >> 1. In this criterion T is a time comparable to the interval in which the perturbed traverses a distance equal to the impact parameter. B. Far in the wings of a line the statistical theory is always applicable.

The purpose of the test was to determine if the 1A Canal Water System Demineralizers can be satisfactorily charged with resin. The 1A Canal Water System Demineralizer was satisfactorily charged with resin and conductivity of the demineralizer effluent was less than 0.1 microbes as specified in the Test Procedure.

The purpose of the test was to obtain data on the decontamination factors for Cesium-136, Cesium-137, Strontium-92, one hour gross iodine and Iodine-131. This data will be used to determinate efficiency of lithium hydroxide resin for removing radioactive cations and anions. The denomination factors for a particular demineralizer using lithium hydroxide resign were found to vary for different radioisotopes. This variation was from 2.3 for Cesium136 to 77,000 for gross iodine.