None

None

The purpose of this report is to describe the recent tests of D-12A-2. The tests of D-12A-2 began on April 30 and ended on May 8. The unusually long test period was a result of an extensive series of magnetic field measurements in which we attempted to determine the shielding affects of a sextupole compensating coil and the decay of the currents induced in this coil. This report is short, but much of the data from the tests are included or summarized. We begin with a description of the coil and conductor, continue with the training history, the results of magnetic measurements, including the use of a sextupole compensating coil and then describe the results of heater induced quenches including estimates of axial and transverse quench propagation velocities.

The purpose of this note is to provide phase reference values for klystrons in the first ten linac sectors to be used as tentative start-up values next September and to point out the degree of long term phase stability of the klystrons as well as the possibility of implementing closed loop feedback stabilization.

Identification of the elements of typical hazardous waste facilities (HFWs) that are the major contributors to the risk are focussed on as the elements which require additional considerations in the design and construction of low-level nuclear waste management repositories and HWFs. From a recent study of six typical HWFs it was determined that the factors that contribute most to the human and environmental risk fall into four basic categories: geologic and seismological conditions at each HWF; engineered structures at each HWF; environmental conditions at each HWF; and nature of the material being released. In selecting and carrying out the six case studies, three groups of hazardous waste facilities were examined: generator industries which treat or temporarily store their own wastes; generator facilities which dispose of their own hazardous wastes on site; and industries in the waste treatment and disposal business. The case studies have a diversity of geologic setting, nearby settlement patterns, and environments. Two sites are above a regional aquifer, two are near a bay important to regional fishing, one is in rural hills, and one is in a desert, although not isolated from nearby towns and a groundwater/surface-water system. From the results developed in the study, it was …

A gap between a neutron sonde and the wall of a borehole can have a significant effect on the observed count rate. This effect was determined experimentally to be linear with gaps as large as 2.5 cm. The count rate is given by N/sub N/ = K/sub 0/ + K/sub 1/g where K/sub 0/ is the count rate that would be observed at zero gap, and g is the gap. The parameters K/sub 0/ and K/sub 1/ are dependent on both water (ie. hydrogen) content and bulk density. In many situations failure to correct the count rate for this gap effect can result in a significant degradation in the accuracy of the water content calculated from the count rate. In a dry borehole, K/sub 1/ is small at zero formation water content, and increases with formation water content. In a water-filled borehole, K/sub 1/ is large at zero formation water content, and tends to decrease with increasing formation water content, becoming zero, as of course it must, if the formation is pure water. The absolute value of K/sub 1/ increases with increasing density. A representation was determined for K/sub 0/ and K/sub 1/ from experimental data. This representation can be …

Attempts were made to run materials compatibility, volcanic gas collection, and heat transfer experiments during the 1977 Kilauea eruption. Preliminary results from the recovered samples showed that Fe, Ni, and Fe-Ni alloys were the most heavily oxidized. The Mo and W alloys showed some attack and only neglible reaction was seen on 310 stainless, Hastelloy C, Inconel 600, Inconel 718, Rene 41, and Nichrome. Results are qualitative only. (DLC)

Plutonium(III), (IV), and (VI) carbonate; plutonium(III) fluoride; plutonium(III) and (IV) oxalate; and plutonium(IV) and (VI) hydroxide precipitation methods were evaluated for conversion of plutonium nitrate anion-exchange eluate to a solid, and compared with the current plutonium peroxide precipitation method used at Rocky Flats. Plutonium(III) and (IV) oxalate, plutonium(III) fluoride, and plutonium(IV) hydroxide precipitations were the most effective of the alternative conversion methods tested because of the larger particle-size formation, faster filtration rates, and the low plutonium loss to the filtrate. These were found to be as efficient as, and in some cases more efficient than, the peroxide method. 18 references, 14 figures, 3 tables.

A fundamental parameter in the design of the Effluent Treatment Facility (ETF), the effluent composition, has recently been investigated by analyzing samples from both separations areas. As a result of this characterization program, we can now project the composition of the ETF feed stream. The anticipated feed composition is presented here for the purpose of making system projections; and a formula is provided for a simulant to use in testing evaporation, filtration, and reverse osmosis (RO) equipment. The components in these waste streams which present potential fouling problems for reverse osmosis are calcium, iron, manganese, barium, and aluminum, in combination with carbonate, silicate, and sulfate. Organics, probably in the form of TBP and kerosene, are also present in the combined effluent, which is otherwise dominated by NaNO{sub 3} and HNO{sub 3}. 3 refs., 3 tabs.