The purpose of this Note is to point out the advantages of the sideband technique over the derivative method in wideline NMR spectroscopy. In the sideband technique the absorption spectrum is recorded directly and the modulation amplitude is no longer a determining factor in the resolution.

Abstract: Various procedures for extracting uranium from fiberglass air filters have been tested and compared. Satisfactory results which involve the least amount of handling are obtained by simply washing the material with hot 1:1 hydrochloric acid.

A series paired explosions in a salt mine near Winnfield, Louisiana, has been conducted to test a theory by A.L. Latter concerning seismic decoupling by underground cavities. The theory predicted a decoupling of 132 Free-field and surface measurements from an explosion in either a 6-ft- or a 15-ft-radius spherical cavity were compared with similar measurements from a completely tamped explosion of equal size. Shot sizes were from 20 pounds up to a ton. Surface measurements were made out to 100 km and covered the frequency range from 0.05 to 100 cps. The experiments confirmed that decoupling does occur. For explosions that produce an average cavity pressure up to one-fifth and possible more of the lithostatic overburden pressure, seismic waves were decoupled by the 100, i.e., two order of magnitude. Even for explosions producing an average cavity pressure of six times the lithostatic overburden pressure, the seismic waves were decoupled by 20 -- more than a full order of magnitude. Minimum decoupling factors as a function of frequency are presented.

Removal of particles from air is discussed in terms of three classes of filtering media--air-sampling, respirator, and air-cleaning. Plots of efficiency versus filtering velocity are presented. The pressure drop characteristics of the filters are discussed in terms of initial pressure drops of the clean filters, variations in pressure drop of the individual filters, and comparison of loading rates.

A summary of the available literature on the development of the various processes for the separation of uranium and thorium from aqueous nitrate solutions is presented. Flowsheets are given corresponding to the various stages in the development of the Thorex processes.

Report describing how the neutralized aqueous waste from the TBP Metal Recovery Process will be concentrated by evaporation to minimize the requirements for underground storage tank capacity.

Most books on the subject of gas discharges describe the multiple banded structure which appears in the flow between two electrodes. This structure is actually due to the difficulty in getting electrons out of the cathode to support the discharge. These electrons are obtained by having a large enough potential drop near the cathode so that the positive ions may strike it hard enough to product secondary electrons. If one substitutes a hot cathode to produce a copious quantity of electrons, the banded structure will be radially changed. Hence the banding is not a pure property of the discharge, but is a complication brought on by the presence of electrodes.

This report is a corrected copy of the authors "rapporteur talk" at the 1959 Kiev Conference on High Energy Physics. It contains data on the rapporteur system and on interactions of strange particles with protons and neutrons, using data from bubble chambers, counters, and emulsions.

Purpose: "To study the value of electrical induction methods for the measurement of liquid and interface levels."

The following report calculates how many neutrons are produced by the O-16([alpha]-n) reaction in a thin and uniform polonium oxide layer.

The design of the Argonaut (Argonne Nuclear Assembly for University Training) was initiated by the Reactor Engineering Division of Argonne National Laboratory to satisfy needs for a low-power reactor facility within the Laboratory, and for training uses within the international School of Nuclear Science and Engineering (ISNSE). It was intended primarily for instruction and research in reactor physics. It was also considered as a possibility that it would fulfill the requirements of universities engaged in a program of nuclear science. The cost of the facility was to be kept to a minimum consistent with the high degree of inherent safety and a great amount of flexibility in the system. The basic design stemmed from the Knolls Atomic Power Laboratory Thermal Test Reactor* (TTR), now called Nuclear Test Reactor (NTR). Modification during the course of the work justified the new name "Argonaut".

The general purpose of this report is to present the major characteristics and design of the Consolidated Edison Thorium Reactor (CETR) core

A study has been performed to determine the corrosion product and water impurity activities in the CETR Chemical Process System. A simplified mathematical model is used to represent the physical situation; however, the magnitude of the activities, taken at the end of the core life to represent the most conservative case, is considered sufficiently accurate for engineering calculations.

A monthly report summarizing work performed by Babcock & Wilcox personnel for the U.S. Atomic Energy Commission. In this monthly report the R&D budget was reviewed, two-dimensional calculations were performed, analysis work was started on control rods and their housing, as well as continued work on the development of the LMFRE reactor.

Due to laboratory interest in devices capable of production of high current with short rise times in gaseous discharges (plasmas), an experimental machine has been built and tested to obtain data applicable to the design of a high gradient magnetic induction machine. This machine consists of a condenser type energy storage bank air core coupled to a toroid in which the plasma is produced. It has been used to determine circuit parameters and the effect of these parameters on the plasma.

Document HW-33176, "A Proposed Scope of the 100-K Sulfuric Acid Addition Facilities", presented the justification and bases for a sulfuric acid addition facility at the 183-K headhouses and included a system for adding the acid to the raw water. Since the issue of this document several factors to consider in such a system have been brought to light by experience gained both at K and at other areas. The alternate system presented here eliminates several of the troublesome points in the previously proposed system.

A fifth in-pile loop experiment, L-4-8, was completed. The loop operated in-pile for a total of 1637 hr, during which time the LITR energy output was 4377 Mwhr. The average fission power in the loop based o cesium analyses was 622 w when the LITR was at full power (3 Mw). Based on oxygen data, the generalized corrosion rate for the first 300 hr was 4.0 mpy; the rate for the remaining 1357 hr was 0.7 mpy. The nickel data gave parallel results. The corrosion of the type 347 stainless steel, Zircaloy-2, and Ti-55AX [unintelligible] exposed in the core and in in-line holders was generally consistent with that observed in previous in-pile loop experiments. Some differences with steel were attributed to the fact that this was the first loop containing steel specimens operated with 0.04 m H2SO4 present in the uranyl sulfate charge solution (0.17 m UO2SO4, 0.03 m CuSO4). Stress specimens, made from the alloys Zircaloy-2, type 17-4 PH stainless steel, and Ti-C-130-AM, were exposed in care, in-line, and pressurizer locations. Microscopic examination and average weight loss gave no indication of effects attributable to the stressed condition of the specimens.

The Irradiation Test Program for the Consolidated Edison Thorium Reactor was conducted to obtain confirmation of the stability and performance of the reference fuel element materials and of test assemblies under design operation conditions. The irradiated specimens were tested to determine mechanical properties and corrosion resistance to borated water.

Summary: The use of dimensionless-parameter frequency response diagrams to determine accuracies of lumped-parameter approximations is demonstrated by two examples: calculation of the heat flux at the surface of a semi-infinite solid due to temperature fluctuations of an adjacent fluid; and the response of a counterflow heat exchanger to inlet fluid temperature perturbations. Dimensionless system parameters make it possible to use general-purpose plots to find the error in particular approximations as a function of the frequency of perturbation. Such plots are directly applicable to control-system stability problems, where the highest frequency of interest is usually apparent.

An improved continuous ether extractor is described. The modifications include a means of safely disposing of the active raffinate and a means of positivity checking the raffinate for completeness of uranium extraction. The results obtained on synthetic samples and on dissolver solutions are given. This work was undertaken because of a need for the determination of uranium in dissolver solutions with an accuracy of 0.1 per cent. After a review of available methods it was decided that a gravimetric determination would meet the requirements of precision and accuracy.

In 1949 Barad presented two solutions to the general diffusion equation. Basic in both solutions is the assumption that in very stable atmospheres a point source may be replaced by a vertical area of uniform concentration at a short distance downwind. This vertical area is considered to exist at the distance at which the plume finally "levels-off" and assumes a flat ribbon-like appearance. In addition if the distance over which diffusion takes place is limited to one or two miles and if only the stable atmosphere with its narrow range of eddy sizes is considered, the average diffusion co-efficient (K) has a signficance which it does not have in the case of neutral equilibrium.

The writer has initiated a comprehensive program of equipment development designed to give the maximum practical aid to the physicists and technicians who are carrying out track measurements. Some attention has also been given to developing systems of data handling using International Business Machine (IBM) equipment and Keysort cards. In addition, some of the steps to insure the accuracy of the emulsion data are taken long before the emulsion is studied under the microscope.

A preliminary study of dispersing agents for thorium oxide has been completed and several of the dispersants have possible uses. Also many of the industrial dispersing agents tested are not usable with thorium oxide due to induced behavior causing balling and caking. The effects of nitric acid concentration have been observed to also effect each dispersing agent.

This report describes the development and design of a large bakeable valve that is based on a unique seat arrangement and a novel motion seal.