Since the 25 content of the uranium to be used in a MTA multiplying lattice is quite uncertain at present, it is necessary to assume various degrees of depletion in order to estimate the multiplication constant K-o and the production of 49 in an infinite uranium-graphite lattice

Zirflex cladding waste is to be neutralized to pH 10 before transfer to waste storage tanks. This treatment causes the precipitation of zirconium oxide or hydroxide, which may lead to flow difficulties during transfer. The purpose of this investigation was to determine the physical properties and flow characteristics of the neutralized slurry to assist in the selectin of satisfactory transfer equipment and storage conditions.

"The previously found maximum in the cosmic radiation energy spectrum is discussed, and the possibility that it arises in part from a misinterpretation of the data due to oversimplifying assumptions about the composition of the beam is examined. The importance that lack of recognition of isotopic composition may have is pointed out, and it is clear that this importance is strongly dependent on the measurements made and on the cut-off rigidity."

The in-plie slurry loop work is now being considered as a joint program between the PAR project and ORNL. It is proposed that PAR design, fabricate and test the in-pile loops and that ORNL operate the loops in-pile, dismantle the loops after irradiation and made the appropriate measurements to determine the radiation effects. This report gives the objects of the slurry in-pile program and outlines the facilities and operations required to execute ORNL's part of this program.

The following report calculates how many neutrons are produced by the O-16([alpha]-n) reaction in a thin and uniform polonium oxide layer.

In calculating diffusion coefficients for gases diffusing from solids, the numerical solutions tabulated by Darken and Gurry, were found to lack the required precision, and the intervals between the arguments were too great to permit precise interpolations. Consequently the diffusion equation solutions of interest (diffusion from a sphere, cylinder, and plate, for the condition that the concentration of the diffusing species initially uniform) were re-evaluated. Computer programs for the three cases were written in FORTRAN for the IBM 7090. The solutions programmed are given in Crank. Values of the fractional completion were computed at approximately 0.01 increments, to the nearest 0.00001, and are tabulated in Table 1 to the nearest 0.0001. The table covers the fractional range from about 0.04 to 0.99. For smaller fractions satisfactory approximations are available. The table may be conveniently interpolated by plotting points about the region of interest and drawing a curve.

Due to laboratory interest in devices capable of production of high current with short rise times in gaseous discharges (plasmas), an experimental machine has been built and tested to obtain data applicable to the design of a high gradient magnetic induction machine. This machine consists of a condenser type energy storage bank air core coupled to a toroid in which the plasma is produced. It has been used to determine circuit parameters and the effect of these parameters on the plasma.

Space has been reserved near the southeast corner of the 100-N Area for the 122-N Decontamination Facility. Previous correspondence between Burns and Roe, Inc and General Electric bae discussed various facilities which might be needed in the building. The concepts of the decontamination processes are under active development by research groups at Hanford. At present, there are several workable processes known; each one has one or more fairly serious drawbacks.

A stimulation study of the deign as of June 1960 of the gas-cooled ORR Loop No. 1 was made using the ORNL analog computer. The proposed method of temperature control is evaluated, and the dynamic behavior of the loop for accidents and component failures is presented in graphical form.

As previously reported, zirconium undergoes large dimensional increases after scaling in air in a critical temperature range, 700 degree-1050 degree C. This finding was observed with specimens of a constant thickness (0;062 in.) To study the thickness effect, a number of specimens ranging in thickness from 0.020 to 0.200 in. were scaled in air at a temperature (900 degree C) where the growth is a maximum for a given time. Both cold rolled iodine sheet and forged iodide bar stock were used. to determine the effect of orientation, specimens from the forged bar were obtained such that the scaling surface was either parallel to or perpendicular to the long axis of the bar.

The amount by which the field of a magnet bends the path of a charged particle is proportional to the integral of Btds along the trajectory. Instead of making tedious point by point measurements of B in magnets and performing the integrations numerically, it has been found useful to measure directly, by using a search coil whose winding consists of long and narrow turns extending through the magnet gap from z1 and z2 in the direction of the trajectory. It should be noted that the integral Iy is taken along a straight x=constant, y=constant lines and not along the actual curved trajectory path; for small curvature the difference is small.

The reason for initiating the compact drive study for the T7 tanker was to investigate control rod drive size, location, and removal space requirement factors and select the control rod drive mechanism which would allow optimization of the over-all size of the containment vessel. Approximately twelve mechanical/hydraulic control rod drive arrangements were considered during this study.

ABSTRACT. When solutions of high specific alpha activity are to be assayed for product, it is often difficult to obtain reproducible results by diluting the solution sufficiently to remove a small volume from which a sample can be prepared and counted at 52% geometry. In order to assay such a solution, most reproducible results have been obtained with minimum effort in sample preparation by making use of low geometry chambers. Two types of low geometry chambers are described: 1) The air-screen type which reduces the geometry simply by placing screens of various transparencies above the sample; and 2) The vacuum low geometry chamber which accomplishes geometry reduction by increasing the distance between sample and collecting electrode thus decreasing the solid angle subtended by the sample and aperture through which the particles pass into the ionization chamber. This type chamber was developed concurrently by this group and the instrument group of Chemistry Section C-I at the Metallurgical Laboratory. Because the geometry of the air-screen type chamber is quite critical to sample spreading and be- cause 12 mm sample plates are required, it has found very little use. On the other hand, the vacuum chamber, because it is noncritical to sample spreading …

Well-type scintillation counters have found use in many radiochemical laboratories. A gamma scintillation well counter has been used to measure the gamma activity of liquid samples in the 325 Building counting room for about a year. This well counter has been built and calibrated so that gamma activity measurements made with it can be easily compared with measurements made with the gamma scintillation counter (GSC). The well counter is electronically identical to the present GSC and differs only in the shape of the crystal used and the physical arrangement of the lead shield. The crystal contains a well which allows a tube containing the sample to be inserted in the crystal. The physical arrangement of the detector greatly simplifies the preparation of liquid samples for activity measurement. The 325 Building well counter and its application to chemical research and plant process analysis will be discussed in the following paragraphs. An operating procedure is also included.

The rate of uranium sorption by a strong-base anion-exchange resin (Dovex 21K) from a uranyl sulfate solution (U 0.005 M, H2SO4 0.02M, SO4 0.2 M) was studied using a stirred vessel technique and measuring the U235 gamma radiation on each bead. Resin initially in the chloride form and the sulfate for was studied.

Progress report of the Brookhaven National Laboratory Nuclear Engineering Department providing updates on various projects, experiments, and other work. This report includes a summary of scholarly output from the reactor physics division, the applied chemistry and chemical engineering division, and metallurgy division.

This report for the month of July, 1949 discusses progress regarding work on the carbonate process and the recovery of uranium and vanadium from carbonate liquors.

Uranium extractions from carbonate solutions were effective and phase separation rates were rapid using a new commercial quaternary extractant, Alamine 336. Extraction coefficients were approximately proportional to the quaternary concentration. Addition of -0.5 mole tridecanol/mole quaternary to the solvent gave optimum extraction efficiency and phase separation rates.

This is a progress report compiled by the chemical development department of the Carbide and Carbon Chemicals Corporation's Y-12 plant, discussing work on the carbonate (Monticello) process, as well as the recovery of uranium and vanadium from carbonate liquors.

The following document is a note describing the building process of an improved nuclear density gauge in comparison to previous gauges, within the interval of June 1 to July 1, 1959.

This report discusses the concept of an improved mass gauging technique with a scintillation counter as the radiation detector in order to meet industrial requirements.

The method of detecting unpaired electrons in liquid and solid systems by electron spin resonance is discussed. The significance of the hyperfine structure in electron spin resonance is discussed and the possible use of these structural features of the electron spin resonance spectrum to elucidate the nature of the photoproduced unpaired electrons in photosynthesizing systems is introduced.

This work was performed to develop a general chemical method for the determination of small amounts of plutonium in solution. The work showed that a coulometric titration based on the preliminary oxidation of the plutonium to Pu (VI) followed by titration with electrolytically-generated ferrous ion to Pu (IV) was such a general method and was subject to few interferences. The significance of the work is that a chemical determination of plutonium can be made for amounts of plutonium heretofore determined only by radioassay methods, and the chemical determination of larger amounts are made more readily and with higher precision than with previous methods. The work also extends the application of coulometric titration methods to a new substance.

Abstract: "This report describes work done to improve the casting characteristics of methyl methacrylete resin under CMR-6-18 authorization. The experimental program was initiated with the objectives of decreasing casting time, bubble formation and shrinkage. It has been found that by use of a common solvent for monomer and polymer concentration in monomer can be attained greater than any previously reported in preparation of a methacrylate casting resign. Incorporation of this greater amount of polymer has produced the desired effects. A bibliography of relevant literature is included to which reference is made in the text."