Data were obtained in non-flowing and flowing (continuous) batch adsorption systems to serve as a guide to the operating conditions that should be used in a resin-in-pulp adsorption system for the recovery of uranium from ores.

The use of diffusion theory to attempt to reproduce the chemical data of Hicks and Stevenson for the spatial distribution of neutrons in a solid block of uranium that is bombarded by 190 Mev neutrons is described.

A study of the variables involved in regeneration was undertaken to determine means of improving the regeneration efficiency and increasing the useful life of a reactor. Information gained from regeneration studies on a 4-inch-diameter by 8-foot-high column indicates that the present regeneration procedure is optimum as to quantity, concentration, and rate of addition of regenerant solution. It appears feasible to restore a plugged reactor by washing off all the silver nitrate from the packing and recoating by a normal regeneration cycle. Such a procedure could be utilized only if there is sufficient dead space in the bottom of the reactor to hold the wash solution.

It is recommended that self-concentration of Purex wastes should not be started until much more complete knowledge is obtained of the conditions and reactions in these wastes. The presently planned tests in the Semi-Works will be a practical demonstration of the problems but will be of little value on the initial Purex wastes as these tests are being run almost concurrent with the filling of the first Purex storage tank.

Calculations are presented regarding the effect of delayed neutrons in reactors fueled with mixtures of Pu²³⁹ and U²³⁵. Results are plotted to illustrate the change in thermal flux as a function of time for various positive or negative step changes in reactivity.

The basic investigation of transistor feedback amplifiers has proven mathematically simple and of great practical value. The behavior of single-stage common-emitter amplifiers is described and provides a building block with which cascaded feedback amplifiers can be analyzed and designed. From the results of this analysis the conditions for minimum drift for cascaded single-stages and cascaded loops have been derived.

An improved continuous ether extractor is described. The modifications include a means of safely disposing of the active raffinate and a means of positivity checking the raffinate for completeness of uranium extraction. The results obtained on synthetic samples and on dissolver solutions are given. This work was undertaken because of a need for the determination of uranium in dissolver solutions with an accuracy of 0.1 per cent. After a review of available methods it was decided that a gravimetric determination would meet the requirements of precision and accuracy.

Abstract: This technical report contains a description of the nuclear analysis performed upon the SM-2 core and vessel for the period September 1, 1958 to December 31, 1959. Calculations are given for core reactivity, power distributions, lifetime, reactor control, kinetics, radiation problems, fuel and poison burn-ups, and the nuclear effects of poisons, temperature, and geometry. Wherever possible, experimental data is included in order to test the validity of the analytical models. The SM-2 nuclear analysis was performed by Alco Products, in. under Tasks 1, 8, and 10 of Contract No. AT(30-2)-326 for the Atomic Energy Commission.

The following report discusses laboratory investigations of the suitability of some commercially available limestone for neutralization of slightly acidic distillates.

Technical report detailing expansion of the Aircraft Nuclear Propulsion at the Oak Ridge National Laboratory. Major facilities completed at this time were the Shielding Rector, the ANP Critical Facility, and the 86-in. Cyclotron. Outlines further need for radiation damage studies. [From Summary]

The letter E. R. Irish/W. H. Swift to R.E. Burns and H. H. Hopkins, dated August 15, 1956, subject Plutonium Concentration Problems, requested information on corrosion of stainless steel, titanium, and tantalum in plutonium nitrate-nitric acid solution, with and without sulfate ion. Experimental conditions and results of tests designed to yield the requested information are given below.

The angle errors of a rotary table can be accurately measured by stepping off the angles with an optical caliper and computing table error from (1) the error readings at each angle measured and (2) the cumulative caliper error that will be evident when the circle is closed at 360', eliminating the necessity of adjusting the caliper to the exact setting.

This report analyzes the separation of ions using the velocity of the ion measured through a long evacuated drift tube.

This report provides an overview of a gridded ionization chamber, instructions on how to operate the instrument, and then discusses the performance of the instrument so far.

First 31 pages of a quarterly report discussing the progress made on research projects during the period from October 1950 to December 1950. This section of the report discusses progress on studies of the metabolic properties of various elements.

Technical report. From Abstract : "Thermal, metallographic, and vapor pressure data were obtained to establish the phase boundaries and the standard free energy, enthalpy, and entropy of formation for the compounds in the yttrium-zinc system."

The subject of this paper is the experimental and technical aspects of the measurements of nuclear resonance parameters. I will confine my remarks to those reactions induced by low energy neutrons, i.e. neutrons of less than approximately 100 kilovolts. The bulk of these measurements have been performed by neutron time-of-flight techniques, and I will direct my attention to these techniques. The first half of this discussion will concern the apparatus with which these measurements are made; the second part will be a discussion of the various experiments by which these parameters are measured, with an emphasis in both areas of discussion on relatively recent developments in the field.

"The injection of the E-layer electrons into the Astron reactor is described by following the electrons as they emerge from the anode of the 1-Mev electron gun through the various steps up to their injection in the reactor volume. Several problems are imposed by this injection process and their solutions are discussed briefly. The detailed mathematical theory and calculations will be presented in a separate paper now in preparation."

This report analyzes two high-current linear accelerators, the A-54--a 48.5 megacycle resonant cavity accelerator--and the A-48, that is under construction during the time this report is written.

A bibliography on the subject of air sample activity vs flow rate has been prepared. The findings in two documents reviewed have been applied directly to this problem. It is concluded that air sample activity is not dependent on flow rate when sampling particles whose average diameter in 0.06 micron or greater.

Surface contamination with beryllium becomes a hazard to health only when the potential exists for resuspension in air in enough quantity and for enough time to exceed the prescribed standards for airborne exposures. There are several factors governing the rate and nature of resuspension phenomena. These factors include: the quantity and properties of the particular beryllium compound causing the contamination, the nature of the surface, activities in the vicinity, ventilation in the area which might affect the dilution of resuspended particles, and the presence of other control measures such as respiratory protection and use of wet methods. Generally, it has been found that the problem is minimal and can be easily controlled by exercising good judgement based upon consideration of pertinent factors governing resuspension, and a knowledge of the nature of beryllium toxicity.

Abstract: "The effects of a number of ternary additions on the constitution, casting, and fabricating characteristics and the physical properties of aluminum-35 w/o uranium were investigated. Initial investigations were concerned with the effects of 3 w/o ternary additions on the microstructure and press-forging characteristics of the alloy. It was found that additions of this magnitude often introduced extrinsic phases in the alloy. At the 3 w/o level, additions of germanium, silicon, tin or zirconium inhibited the formation of UAl4 and thereby increased the content of the aluminum matrix in the alloy. It was also noted that these additions decreased the pressures required for extruding, and the tin addition also improved the homogeneity of cast shapes. Lead and palladium also improved the homogeneity of the cast material; however, neither of these was an effective inhibitor of UAl4 and free lead was detected in the alloy to which lead had been added at the ternary. From these studies it appears that tin and zirconium are as effective as silicon in enhancing the fabricating characteristics of aluminum-35 w/o uranium alloys, and may prove superior when evaluated on the bases of casting qualities and recycling characteristics."

Abstract: This report gives the results of a radiochemical analysis of particles collected by electrostatic precipitation from ventilation air of the "B" plant at Hanford Works.

"Characteristics of a pulsed, occluded-gas ion source, operating in a magnetic field, have been investigated. Mass spectra of hydrogen- and deuterium-loaded sources are presented. Constructional details of the source and its operating characteristics are discussed."