Introduction: In conjunction with the final design and development of a 70 MW sodium intermediate heat exchanger and a sodium steam generator, an analysis is required which can be used as a basis for a determination to scale up or scale down the designs. Included in this analysis are those considerations leading to the recommendation of the best prototype test unit and to some of the limits imposed on scaling up or down when considering future applications of designs other than those actually tested. In addition, these considerations include aspects required to accurately predict the performance, operation, mechanical reliability, and feasibility of fabrication of the 70 MW design.

Report discussing the progress made on various chemistry research projects at Ames Laboratory during the period from October 1, 1950 to March 31, 1951.

Twelve neutron activation analyses for naturally occurring technetium-98 were performed. Positive results were obtained in ten cases. Precautions were taken to avoid interference by molybdenum and technetium-99. the cross section for the reaction [formula] as found to be equal to 4 +- 2 mb for the neutron spectrum of the vertical thimbles of the Argonne CP-5 reactor. The chemical state of molybdenum (VI) in basic solution was studied by an anion-exchange technique. Evidence was obtained for the existence of polymeric species at pH-values up to 14. Preliminary work on the stability of Domax-1 anion exchange resin in perchlorate media indicates rapid deterioration even at 0.2F ClO4-.

This document describes required laboratory space and lists major equipment items necessary for a routine water quality laboratory in the P. R. T. R. Building. During discussions with R. D. Widrig and V. L. Rooney about the analytical sample program for the Plutonium Recycle Test Reactor, the author was asked to summarize equipment and space needs for a water control laboratory to provide routine analytical coverage on some of the water systems. Based upon 1706-KE-KER experience, some operating personnel may be used to provide analytical coverage on those routine analyses that are needed on around-the-clock basis with a savings of both time and money.

Uranium has been successfully forged using a Lobdell-Nazel forging hammer and a forging temperature range of 500 to 650 degrees centigrade. Using standard forging techniques, the metal readily flowed at the temperature chosen. A noticeable increase in tensile strength, yield strength and percent elongation was obtained in forged metal as compared with cast metal. To obtain complete recrystallization and uniform grain size, a minimum of approximately 75 percent reduction in cross section by forging followed by an anneal within the range of 500 to 600 degrees C is required.

Previous investigations that the pancreas is a radioresistant organ. Ivy in 1924 noted the presence of a fibrotic atrophic pancreas in a dog which had received one erythema dose to the epigastrium. Fisher in 1923 reported that four to five erythema doses delivered in a single application caused complete disappearance of the irradiated pancreatic remnant in about two months. These dogs died because of uncontrolled diabetes. One dog that received four erythema doses (possibly 200 r) was sacrificed after five months. At autopsy the irradiated pancreas had disappeared, but 275 mgm of regenerated pancreas were found at the base of the main duct and 100 mgm at the base of the accessory duct. Leven in 1933 implanted radon seeds into the pancreas. Dosages varied from 528 to 1584 millicurie hours. At postmorten the pancreas surrounding the seeds demonstrated fibrous atropy and foci of necrosis. The islets appeared normal but were relatively larger in size. Rauch in 1952 reported that dogs given 200 r in air over the pancreas on alternate days until a total of 1600 r was received failed to show any histological changes after two months. Lushbaugh and Spalding and Lushbaugh reported that over 1500 r of whole-body …

Abstract: "A radioactive tracer, Fe^59, was used to determine the disposition of iron as a result of the excitation of a U3O8 matrix in a d - c arc. Two different spectrographic procedures, both using carrier distillation excitation techniques, were compared as to the percent of iron volatilized, the percent of iron diffused into the electrode and the percent of iron remaining in the residual charge."

Early in the U.S. gas-cooled reactor program, it was recognized that a considerable research and development effort would be needed to utilize the full potential of gas cooling. Hanford Laboratories contribution to this program began in August, 1958 when a graphite studies program was initiated. The primary objectives of the Hanford program are: (1) to secure improved knowledge of the reaction of gas coolants with protected and unprotected graphites over a range of conditions of practical interest for gas cooled power reactors with tolerable damage to the graphite moderator.

Recent measurements of the pion-proton total cross section, taken with small statistical errors, have shown the existence of two new maxima in the momentum range between 2 and 3 BeV/c. Measurements of comparable statistical accuracy, covering the momentum range from 2.5 to 8 BeV/c are reported in the present paper. In addition to the total cross sections for π± mesons on protons, their total cross sections on deuterons have also been determined. Some data were also taken on the total cross sections for K+ mesons on protons and deuterons and for K- mesons on protons.

Technical report investigating the distribution of rare earth elements between a liquid bismuth-uranium solution and fused KCI-LiCi mixtures. Report warrants further research on the liquid bismuth-uranium-fused salt system due to the benefit of continuous fission removal processes.

This document presents the bases for those PRTR Process Specifications involving considerations of heat transfer and fluid flow. It will be noted that some of the bases incorporate information gained from laboratory experiments with electrically heated test sections simulating PRTR fuel elements. These experiments are described in some detail elsewhere.

This paper will first note briefly the place and status of radiobiotopical investigations with fast neutrons. The monoenergetic (fast) neutron technique employed at this laboratory will be then described and results of studies with various criteria-of-effect in the mouse will be reviewed. Finally, certain general patterns of response for these systems will be pointed out as functions of neutron energy.

Summary: "The problem of evaporation of secondary radioactive wastes resulting from waste disposal studies at Mound Laboratoy has been studied experimentally to determine the fundamental design characteristics of a plant size unit. Emphasis, of course, was on decontamination, but the factors affecting foaming and scaling also had to be investigated and evaluated. Generally speaking, the final design is a standard type of evaporator, the only unique feature being the relation of the two effects. Where critical, as affecting performance, the particular design features have been specified."

Abstract: "An experimental study was made to determine the effective shielding provided by a modern reinforced-concrete office building (AEC Headquarters building) from nuclear fallout. Pocket ionization chambers were used for measurement of the radiation-field strength. Fallout was simulated with distributed and point-source configurations of Co-60 and Ir-192 sources. Four typical sections were selected for study, and experiments were performed on each. These included an external wing with exposed basement walls and an external wing with a buried basement. Roof studies were made on an internal wing with a full basement and on the east end of wing A, which has a thin-roof construction. The thick-roof construction of 8 in. of concrete and 2 in. of rigid insulation covers all the building except the east end of wing A, which has 4 in. of concrete and 2 in. of insulation."

Abstract: "The reflections of microwaves from the walls of a plasma-containing vessel are studied. The probable cause of the reflections is discussed, and several suggestions are made for eliminating the reflections from the waveguide in the vessel and particularly from the pyrex vessel wall and copper tubing surrounding the pyrex. Quarter-wave-thick carbon-filled plastics or glasses having a very low vapor pressure room most promising when placed inside the pyrex cylinder. BaTiO3 appears to be an excellent material when placed outside the vacuum."

This memorandum is an outline of the principles and methods employed by 5100 Human Engineering Personnel in consultation on test equipment panel layout. The process of control panel layout is partially formalized with particular emphasis on test equipment panels. An experimental method is proposed for selecting an optimum panel layout. The essential role of experimentation is pointed out. The optimal layout for a nonrepetitive procedure is deduced and generalized to give methods of layout solution for the general repetitive procedure.

The purpose of this program is to determine the effects of neutron radiation and reactor gaseous atmospheres on the structural integrity of candidate materials for the PRTR gas-cooled loop. An exploratory investigation is being conducted to select a high temperature resistant alloy for the fabrication of tubes and supporting appliances for the PRTR gas-cooled loop. In addition to a low neutron cross section, the material must be able to withstand the operating conditions outlined in Table 1.

Abstract: "In experimental studies, decontamination factors of 1000 to 3000 were obtained by electrostripping deposited radioactivity from stainless steel surfaces, used as the anode, in 2% sulfuric acid at current densities as low as 0.01 amp/in.-2. Stainless steel cathodes were used. The method was successfully applied to contaminated equipment."

The index of refraction of PuO2 made by thermal decomposition of PU(C2O2, 6H2O gradually increases from a value < 1.9 to 2.40 as the decomposition temperature is increased from 150 degree to l000 degree C. This change in refractive index parallels a gradual change in the x-ray diffraction pattern from weak, diffuse lines for PuO2 ignited at 150° to sharp, well resolved lines for PuO2 ignited at 1000°C. Similar results are observed for PuO2 made by thermal decomposition of Pu2(C2O4)3*11H2O. The refractive index of PuO2 made from Pu metal at 170°C is 2.40 and is not affected by further ignition at higher temperatures, although crystal growth does occur. The rate of solution of PuO2 in an HCl-KI solution is greatest for samples prepared at low temperatures and decreases markedly for oxides ignited at higher temperatures. These observations hive been interpreted to mean that ignition at higher temperatures causes a gradual perfection of the originally highly distorted and impurity-containing PuO2 lattice obtained by low temperature decomposition of the oxalates and promotes the slow growth of crystallites. Both factors decrease the reactivity of the PuO2.

The index of refraction of PuO2 made by thermal decomposition of PU(C2O2, 6H2O gradually increases from a value < 1.9 to 2.40 as the decomposition temperature is increased from 150 degree to l000 degree C. This change in refractive index parallels a gradual change in the x-ray diffraction pattern from weak, diffuse lines for PuO2 ignited at 150° to sharp, well resolved lines for PuO2 ignited at 1000°C. Similar results are observed for PuO2 made by thermal decomposition of Pu2(C2O4)3*11H2O. The refractive index of PuO2 made from Pu metal at 170°C is 2.40 and is not affected by further ignition at higher temperatures, although crystal growth does occur. The rate of solution of PuO2 in an HCl-KI solution is greatest for samples prepared at low temperatures and decreases markedly for oxides ignited at higher temperatures. These observations hive been interpreted to mean that ignition at higher temperatures causes a gradual perfection of the originally highly distorted and impurity-containing PuO2 lattice obtained by low temperature decomposition of the oxalates and promotes the slow growth of crystallites. Both factors decrease the reactivity of the PuO2.

Results of an initial examination of non-fuel-bearing materials for the Marine Gas Cooled Reactor are presented. Areas given specific attention include structural and cladding materials and graphite moderator. Other areas not included because of classification include zirconium hydride moderator and control materials. In each report section, available pertinent information is summarized and a plan for future work is given.

"Several multiplier phototubes produced by England, Russia, or Switzerland were evaluated for amplification, photocathode sensitivity, photo-electron collection efficiency, cathode uniformity, and dark current. A description of the various tubes by designation numbers is given, along nth a description of techniques and equipment used in testing."

Equipment lists and operating procedures are present for a laundry designed to wash contaminated clothing.

The surfaces of cold rolled, half hard, nitric acid treated, autoclave etched, 2S aluminum coupons were studied by optical and electronoscopic methods, before and after exposure to hot water alone and hot water and neutron bombardment. The non-exposed aluminum surfaces have a characteristic pattern which is absent in the exposed coupons. All of the exposed coupons were corroded. In general the coupons exposed to the higher flux intensities of irradiation were more severely corroded than those exposed to the lower flux intensities of irradiation or to the hot water alone. Representative photo-and electron micrographs illustrate the various types of surface structure observed on the control and experimental coupons.