Investigation conducted to determine the cause of cracking, during tension, on the surface of tensile specimens of uranium-molybdenum alloys.

From abstract: This report presents information generated during a six month feasibility study of an engine which uses a supercritical working fluid as the secondary portion of nuclear powered electric generating system.

Quarterly report describing the progress and development of improved zirconium alloys for service in superheated water and steam. This report covers the period between October 1 to December 31, 1961 and was conducted by the United States and the European Atomic Energy Community (EURATOM).

Quarterly report describing the progress and development of improved zirconium alloys for service in superheated water and steam. This report covers the period between July 1 to September 30, 1962 and was conducted by the United States and the European Atomic Energy Community (EURATOM).

The following document describes the usage of the LRL 9-ZOOM code, a neutron diffusion theory reactor code for the IBM 709. The code has been modified to solve configuration of a series of stacked cylindrical disks, designating a new geometry case.

Abstract: "Discussion is directed toward eventual optimization of the largest diffusion-pump systems. Less than 100 diffusion pump fluid molecules per cm 2/sec are possible to detect using an accumulation method. Optimization discussed demands highest possible system speed compatible with the above contamination rate. Bakeable oil diffusion pump systems, with equal orifice valve-tap units, without conventional baffling, permit theoretical through-put speeds up to 0.3 of the system orifice. The average backstreaming rate of oil in two unconventionally baffled commercial pumps of 6-in. and 10-in. size is reduced to < 3 x 10-(-4) g/cm-2/24 hr, including heating and cooling the pump boiler. A Ho factor of >0.4 is maintained. Results on trapping with activated alumina, retained by a wire mesh, at both liquid-nitrogen and room temperature are included. A variety of pumping speed measurements and bakeable combination valve-trap units are discussed."

From foreword: The primary purpose of this document is to set forth the current status of the 630A Nuclear Steam Generator, under development for the U.S. AEC.

From abstract: Seismic waves resulting from a 5 kiloton nuclear detonation 1200 feet deep in a salt bed near Carlsbad, New Mexico were measured by strong-motion seismographs operated by the Coast and Geodetic Survey on the surface in the distance range from 0.5 to 8.8 miles and underground in a potash mine 8.7 to 11.2 miles distant.

Critical mass experiments to be conducted at HAPO will require dilute and concentrated plutonium solutions. Since very high plutonium concentrations (~2,000 g/l) cannot be attained in pumpable solutions, solid plutonium compounds will be utilized for this phase of the work. Mixtures of plutonium oxide and polyethylene, methyl methacrylate or paraffin compacted in containers have been considers for use in highly-concentrated plutonium systems of known hydrogen to plutonium atomic ratio (H/Pu).

This document will be concerned with the design, operation and maintenance of an automatic fuel element stamping machine. In order to take advantage of automatic unloading and length checking at the Acme-Gridley lathes in the 313 Building, automatic stamping of fuel elements is desirable. This, along with the need for a permanent canning line identification, resulted in a request for a machine to automatically stamp HAPO fuel elements on a production basis.

Operating plant experiences in restoring to useful service failed equipment contaminated through exposures to radioactive processes is of international interest to the nuclear industry. In accordance with a request from the Hanford Operations Office of the United States Atomic Energy Commission this report of the various measures taken in rehabilitating for re-use expensive engineered equipment has been compiled by the General Electric Company. This report is a review and summary of the disposition of contaminated major processing equipment at Hanford Atomic Products Operation during 1958-1959 and a listing of 1) equipment buried, 2) equipment stored, to be buried or decontaminated, and 3) equipment decontaminated and returned to service.

A reinforced Butler building was exposed to fallout from Shots Diablo and Shasta, and the resulting dose rates and fallout deposition inside and outside the structure were measured with various instruments and techniques. Protection factors and roof and ground contributions to the total dose rates at points within the structure were determined from the measurements. Comparisons were made with the results of theoretical and other experimental studies. Information obtained from this experiment should be of value as basic experimental data for fallout protection work, although it is recommended that additional substantive data obtained under more controlled conditions.

The decontamination of the present Hanford reactors involves a once-through cleaning operation. Considerable interest has also been shown in determining the feasibility of this once-through technique for cleanup of certain portions of the NPR system. This report contains information on a series of tests performed in the 242-B single pass flow facility. Information concerning the following are presented: (1) Efficiency of decontaminating KER Loop 1 and 2 contaminated specimens. (2) Efficiency of decontaminating present reactor pigtails by different methods. (3) Areas that need further study.

Organic compounds with high boiling points and low corrosion qualities have been considered for use as reactor coolants and moderators. Those being considered, however, have a greater tendency to leak than does water. A program to evaluate mechanical closures to be used for a leak-tight system for organic fluids has been established. Report HW-59446 covered descriptions of the facility used in this study and the primary results of tests covering two liquids, fittings, and instrumentation. This report will cover final results and other pertinent information.

Technical report. From Abstract : "Details are provided on the construction and operation of a two-stage diaphragm pump successfully used for the first time in liquid metal service. From the results of 5,376 hr. test of the pump it was concluded that it is well suited to the pumping of liquid metals at low flow rates where pulsating flow can be tolerated and also where remote operation is required. Operating temperatures and pressures are limited only by the availability of suitable materials of construction."

From Introduction: "The recent acceptance by physicists and chemists of new values for the fundamental constants and the continued demand for expanded and convenient tables prompted the recomputation and preparation of this volume. The authors have tried to incorporate this work a number of the more desirable features of the above-cited works, particularly with respect to their use in calculations involving: Thermodynamic properties of gases; specific heats, electrical and thermal conductivity of solids; and molecular structure and spectroscopy of diatomic and polyatomic molecules. It is the hope of the authors that formal character of this publication will insure a more adequate notice and dissemination than was accorded the earlier works, thereaby reducing the probability of still further duplication of effort."

From Abstract: "The results of an investigation of lightweight, precast cellular concrete planks are given. Fire tests were made of two floor and five roof specimens made up of these planks. Variables, included density of the cellular concrete, thickness and span of the planks, reinforcement, and cover for the latter."

From Introduction Statement of Objectives: "The purpose of this publication is to provide assistance to the practicing engineer who is faced with the problem of making dynamic measurements of rapidly changing pressures."

Abstract: This technical report summarizes the results of research and development tasks performed during Phase I of this contract and presents recommendations for future development work. Work is reported in the areas of plant assembly and relocation, housings and footings, waste heat dissipation, instrumentation, refueling systems, waste disposal, shielding, core nuclear thermal and hydraulic studies, gaseous waste processing (BWR), and critical experiments on a 5 x 5 array of Type 3 fuel elements.

From abstract: "The preparation of pure molybdenum(IV) bromide was accomplished conveniently by the reaction between molybdenum(III) bromide and liquid bromine at ca. 55°. Molybdenum(IV) bromide was found to be soluble in liquid bromine, and this property was utilized to separate and purify the molybdenum(IV) bromide. The solution of MoBr4 in bromine was a poor electrical conductor. No evidence was found for the formation of MoBr4 from MoBr3 and bromine vapor at 2-4 atm. and temperatures from 180 to 400°. However, MoBr4 was completely decomposed at 110-130°, in vacuo, with formation of MoBr3 and bromine."

Cell proliferation on the actively growing periosteal surface of the femur of rabbits aged two weeks, has been investigated using autoradiographic techniques. Injections of tritiated glycine and tritiated thymidine were given simultaneously and the animals sacrificed at intervals from one hour to 5 days after injection. The glycine labelled the position of the bone surface at the time of injection and the thymidine labelled the cells which were synthesizing DNA . The rate of increase in the cell population was determined by counting the number of cells beyond the glycine label at different times after injection. The cell kinetics of the fibroblast--pre-osteoblast--osteoblast--osteocyte system has been studied. The fibroblasts are relatively unimportant from the point of view of increase in the cell population. The main site of cell proliferation is the layer of preosteoblasts on the periosteal surface. The rate of movement of cells from the pre-osteoblast to the osteoblast and osteocyte compartments has been measured. The incorporation of osteoblasts into the bone is not a random process, but it appears that the osteoblast must spend a certain time on the periosteal surface before becoming either an osteocyte or a relatively inactive osteoblast lining a haversian canal. During its most active …

A study of the cell kinetics on the actively growing periosteal surface of the femur of rabbits ages two weeks has been continues. A single injection of tritiated thymidine was given and the rabbits killed from one hour to four days after injection. The grain count spectra of the different cell types, pre-osteoblast, osteoblast and osteocyte, have been compared at different times after injection. The results showed evidence for the uptake of thymidine in nuclei which is not associated with cell division. A small percentage of osteoblasts was initially labelled at one hour and there was evidence that the majority of these had not divided by 3 or 4 days after injection. Some thymidine labelled cells had also become osteocytes without division. Furthermore, it appeared that a considerable fraction of the initially labelled pre-osteoblasts did not divide. The S-period for the pre-osteoblasts and osteoblasts was measured using a double-labelled thymidine technique.

Antiproton-production and nucleon-interaction cross sections were investigated for antiprotons in the energy range 0.5 to 1.0 Bev. The antiprotons were distinguished from other particles produced at the Bevatron by a system of scintillation- and velocity-selecting Cerenkov counters. The excitation function and momentum distribution were recorded for antiproton production in carbon and compared with statistical model expectations.

The spectra of KHF2, KH2F3, NaH2F3, liquid and solid HF were measured between 1200 and 30 cm-1 by the inelastic scattering of "cold neutrons" (0.005e.v.). The spectrum of KHF2 is in agreement with previous infrared measurements and shows a peak at 147 mV corresponding to a deformation frequency v2 of the F-H-F group and a broad peak at 13 mV due to a libration of this group. The observed spectra for KH2F3, NaH2F3 solid and liquid HF were compared with that for KHF2 considering the known results that the F-F distance increases, the position of the H atom between the two fluorines becomes more asymmetrical, and the strength of the hydrogen bond decreases in going from the HF2- ion to H2F3- ion to HF. In this comparison the known structure of the H2F3- ion is considered as being intermediate between that of HF2- and the zig-zag hydrogen bonded chains in solid HF. As a result, the lines observed at 112 mV and 67 mV in the H2F3- spectra and in HF respectively are associated with the deformation frequency v2 of the H-F-H group in these compounds. In addition the spectra of H2F3- ions show a peak at a 15 mV …