None

In 2006, the U.S. Department of Energy initiated the Seismic Boreholes Project (SBP) to emplace boreholes at the Waste Treatment Plant (WTP) site in order to obtain direct shear wave velocity (Vs) measurements and other physical property measurements in Columbia River basalt and interbedded sediments of the Ellensburg Formation. The goal was to reduce the uncertainty in the response spectra and seismic design basis, and potentially recover design margin for the WTP. The characterization effort within the deep boreholes included 1) downhole measurements of the velocity properties of the suprabasalt, basalt, and sedimentary interbed sequences, 2) downhole measurements of the density of the subsurface basalt and sediments, and 3) geologic studies to confirm the geometry of the contact between the various basalt and interbedded sediments through examination of retrieved core from the core hole and data collected through geophysical logging of each borehole. This report describes the results of the geologic studies from three mud-rotary boreholes and one cored borehole at the WTP. All four boreholes penetrated the entire Saddle Mountains Basalt and the upper part of the Wanapum Basalt where thick sedimentary interbeds occur between the lava flows. The basalt flows penetrated in Saddle Mountains Basalt included the Umatilla …

A theory for the electroreduction/oxidation was formulated A new density formalism is discused with possible applications to pores in membranes

A relatively simple, quantitative approach is proposed to address a specific, important gap in the appr approach recommended by the USEPA Guidelines for Cancer Risk Assessment to oach address uncertainty in carcinogenic mode of action of certain chemicals when risk is extrapolated from bioassay data. These Guidelines recognize that some chemical carcinogens may have a site-specific mode of action (MOA) that is dual, involving mutation in addition to cell-killing induced hyperplasia. Although genotoxicity may contribute to increased risk at all doses, the Guidelines imply that for dual MOA (DMOA) carcinogens, judgment be used to compare and assess results obtained using separate 'linear' (genotoxic) vs. 'nonlinear' (nongenotoxic) approaches to low low-level risk extrapolation. However, the Guidelines allow the latter approach to be used only when evidence is sufficient t to parameterize a biologically based model that reliably o extrapolates risk to low levels of concern. The Guidelines thus effectively prevent MOA uncertainty from being characterized and addressed when data are insufficient to parameterize such a model, but otherwise clearly support a DMOA. A bounding factor approach - similar to that used in reference dose procedures for classic toxicity endpoints - can address MOA uncertainty in a way that avoids explicit modeling …

A year of data from sonic anemometer and mechanical wind sensors was analyzed and compared at a low-wind site. Results indicate that 15-minute average and peak 1-second wind speeds (u) from the sonic agree well with data derived from a co-located cup anemometer over a wide range of speeds. Wind direction data derived from the sonic also agree closely with those from a wind vane except for very low wind speeds. Values of standard deviation of longitudinal wind speed ({sigma}{sub u}) and wind direction fluctuations ({delta}{sub {theta}}) from the sonic and mechanical sensors agree well for times with u > 2 ms{sup -1} but show significant differences with lower u values. The most significant differences are associated with the standard deviation of vertical wind fluctuations ({sigma}{sub w}): the co-located vertical propeller anemometer yields values increasingly less than those measured by the sonic anemometer as u decreases from 2.5 approaching 0 ms{sup -1}. The combination of u over-estimation and under-estimation of {sigma}{sub w} from the mechanical sensors at low wind speeds causes considerable under-estimation of the standard deviation of vertical wind angle fluctuations ({sigma}{sub {phi}}), an indicator of vertical dispersion. Calculations of {sigma}{sub {phi}} from sonic anemometer measurements are typically 5{sup …

None

None

Proton radiography offers significant advantages over conventional X-ray radiography, including the capability of looking into thick, dense materials, better contrast for a wide range of materials, sensitivity to different materials of similar density, and better resolution because of the ability to focus beams. In order to achieve this capability it is crucial to understand the background due to neutrons and photons and to develop techniques to reduce it to tolerable levels. The physics goal of this project is to measure forward production of neutrons and photons produced by high-energy proton beams striking a variety of targets. This work is being carried out in conjunction with the Fermilab Experiment 907 (MIPP) collaboration including physicists from Lawrence Livermore Laboratory. Our group is responsible for the E907 forward neu-tron/photon calorimeters. These are the only detectors in the experiment that provide informa-tion on neutrons and photons. We are taking a leading role in obtaining and analyzing the for-ward production data and in developing an optimal detector for proton radiography. With the support of our Stewardship Science Academic Alliances grant, we were able to design, build, and commission the calorimeters on budget and ahead of schedule. E-907 officially started physics running at Fermilab in January …