None

The Purpose of this manual is to describe preparation of bismuth powder for use in process operations. Bismuth powder is to be prepared in Room 232 of ``T`` Building where all necessary apparatus is installed.

None

None

Activities covered in this report for the month of January are as follows: (1) power coefficient test of the F Pile; (2) control rod calibration; (3) investigations into reactivity gains possible by zoning the pile for metal charging; (4) polonium production under emergency conditions: (5) analysis of process tube ion chamber failures; (6) measurements of the thermal neutron flux in various pockets of the E Test Hole of the F Pile; (7) reactivity balance of each of the operating piles at beginning and end of this report period; (8) graphite studies; (9) pile shielding; (10) radiation measurements on a simulated D-R rod guide and rod; and (11) calculation of radioactive isotopes expected in cooling water.

Despite the fact the adequate data from long-term, chronic experiments on the effects of Po{sup 210} are not available, some sort of a working figure for the maximum permissible body content of polonium is desirable. As described herein, calculations involved in determining the permissible body content of polonium generally fall into three classes. 1. Comparison of X-ray and polonium toxicity and application of an acceptable X-ray tolerance figure. 2. Assumption of a most sensitive organ and computation of the critical concentration of radioactive material present in this organ under conditions such that the organ received an assumed maximum permissible exposure over an indefinitely long period of time. 3. Comparison of radium and polonium toxicity with application of an acceptable maximal content of radium.

None

This document details activities at the Hanford Engineer Works during the month of January 1949.

This report details events of importance reported by the Hanford Operations Office for the week ending February 23, 1949.

This report details events of importance reported by the Hanford Operation Office for the week ending February 2, 1949.

None

The attenuation of electro-statically and electro-magnetically shielded rooms in the ``E,`` ``R,`` ``I,`` and ``T`` Buildings was measured so that corrective measure could be taken if the attenuation was found to be low. If remedial measures could not be taken, the shortcomings of the rooms would be known. Also, the men making the measurements should oversee construction and correct errors at the time. The work was performed by measuring the attenuation at spot frequencies over the range of from 150 kilocycles to 1280 megacycles with suitable equipment mounted in small rubber-tried trucks. The attenuation was determined by ``before and after`` shielding and/or ``door open and door closed`` measurements after installation of copper shielding. In general, attenuation in the frequency range of approximately 10 to 150 mc. was good and was of the order expected. At frequencies in the range of 150 mc. to 1280 mc., the attenuation curve was more erratic; that is, at certain frequencies a severe loss of attenuation was noted, while at others, the attenuation was very good. This was mainly due to poor or faulty seals around doors and pass windows. These poor seals existed in the ``T,`` ``E,`` and ``I`` Buildings because the doors were …

This report details events of importance reported by the Hanford Operations Office for the week ending February 16, 1949.

This report details events of importance reported by the Hanford Operations Office for the week ending February 9, 1949.

None

None