This procedure requires the binder and uncoated RDX be prepared in separate steps, see Figure 1: (1) The binder and dye are mixed by agitation with a water-insoluble organic solvent (e.g., toluene), I; (2) The RDX/PETN is agitated thoroughly with water, II; (3) The binder solution I is added to the RDX/water mixture at II with thorough mixing to form a slurry III; (4) In the next step the solvent is distilled off at IV leaving resulting granules; (5) The next step is followed by filtration at V, which may be done by vacuum; (6) The composition is then dried at VI to a dough-like consistency.

Evaluating the chemical background in the GC/MS system (system background) and solvent purity. This procedure will allow the analyst to verify that the GC/MS is free of chemical interferences or contamination and verify the solvent being utilized is free of interferences - Conduct a GC/MS analysis without injecting a solvent (system background) and Conduct a GC/MS analysis inject 1uL of CH2Cl2 solvent (Solvent background). GC conditions: (1) Injector Temperature (C): Injector Temperature is typically set at 250; (2) Transferline Temperature (C) - The Transferline Temperature is typically set at 280 C; (3) Constant flow (Sec./cm2) - This value, in seconds per cubic cm. Typically, set at 32; (4) Splitless mode (Sec.) - This value, in seconds, is the time before the purge valve opens. Typically, set at 45 seconds; (5) Starting Temperature (C): The Starting Temperature value can be set at 40 C; (6) Hold Time 1 (Min.) - Hold Time 1 is the amount of time, in minutes at the Starting Temperature that Ramp 1 Temperature is held. Typically set at 3 minutes; (7) Ramp 1 Rate (C/Min.) - Ramp 1 Rate is the temperature rise per unit time and has a typically value of 8 C per minute …