This engineering note documents the calculations done to determine the relief capacity of the solenoid vacuum pumping line. The calculations were done by David Bell, a co-op student from the University of Wisconsin. The calculations are attached. The conclusion is that the vacuum pumping line has a venting capacity of 129 g/s warm helium or 298 g/s warm nitrogen. Both of these capacities are much larger than the expected operating mass flow rates of the liquid helium (5 to 15 g/s) or liquid nitrogen (2 or 3 g/s) circuits. The calculations assume the solenoid vacuum vessel is at 3 psig and the relief plate is set at 1.5 psig. Additional calculations were done to prove that the venting capacity of the vacuum pumping line exceeded flowrates due to a failure mode. These calculations are attached. Since the system is not finalized, (pipe sizes not determined, components sized...) the calculations were done by first picking reasonable line sizes based on known allowed pressure drops in the system and then doing a maximum delivery rate calculation if a line was completely severed in the vacuum space of the solenoid/control dewar. The numbers from these calculations say that failure mode flow rates are …

A plasma coating system has been developed for induction melting zirconium at 1900 C using a graphite crucible. This laminated coating system consists of plasma spraying the following materials onto the graphite: (1) molybdenum or tungsten, (2) a 50% blend by weight of the metal powder and calcia-stabilized zirconium oxide, and (3) calcia-stabilized zirconia followed by painting a final coating of nonstabilized zirconia on top of the plasma-sprayed coating system. Zirconium was melted in argon using both laminating systems without any degradation of the graphite crucible and with only a minimal amount of carbon absorption. This novel approach that is being proposed as an alternative method of melting zirconium alloys offers substantial cost savings over the standard practice of electric arc melting using a consumable electrode.

The majority of this research has been in developing a model to describe the magnetostrictive properties of Terfenol-D, Tb{sub 1{minus}x}Dy{sub x}Fe{sub y} (x = 0.7-0.75 and y = 1.8--2.0), a rare earth-iron alloy which displays much promise for use in device applications. In the first chapter an introduction is given to the phenomena of magnetization and magnetostriction. The magnetic processes responsible for the observed magnetic properties of materials are explained. An overview is presented of the magnetic properties of rare earths, and more specifically the magnetic properties of Terfenol-D. In the second chapter, experimental results are presented on three composition of Tb{sub 1{minus}x}Dy{sub x}Fe{sub y} with x = 0.7, y= 1.9, 1.95, and x= 0.73, y= 1.95. The data were taken for various levels of prestress to show the effects of composition and microstructure on the magnetic and magnetostrictive properties of Terfenol-D. In the third chapter, a theoretical model is developed based on the rotation of magnetic domains. The model is used to explain the magnetic and magnetostrictive properties of Terfenol-D, including the observed negative strictions and large change in strain. The fourth chapter goes on to examine the magnetic properties of Terfenol-D along different crystallographic orientations. In the fifth …

The March seminar, ``Military and Diplomatic Roles and Options`` for managing and responding to proliferation, featured three presentations: the military and diplomatic implications of preemptive force as a counterproliferation option; an in-depth assessment of the threat posed by biological weapons; and, a new proposed US counterproliferation policy.

Letter opinion issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, Dan Morales, regarding a legal question submitted for clarification: Whether a home-rule city may reimburse its officials in a fixed amount for expenses incurred (ID# 20029)

Newsletter of the Texas Department of Health discussing the news, activities, and events of the organization and other information related to health in Texas.

Work funded by the grant consisted of a series of experiments designed to elucidate scales and forcing mechanisms of the circulation and water properties within Santa Monica/San Pedro basin. Each experiment consisted of a moored array of roughly 30 current meters, CTD surveys (usually upon deployment and retrieval of the moored array), and satellite imagery. The CROSS moored array was designed primarily to obtain information on cross-shelf and cross-basin coherence scales, vertical coherence scales and the principal forcing mechanisms for the circulation. Several papers are referenced.

Continental Shelf Associates, Inc. (CSA) was contracted to conduct a three-year study of the environmental and health related impacts of produced water and sand discharges from oil and gas operations. Data on naturally occurring radioactive materials (NORM), heavy metals, and hydrocarbons in water, sediment, and biota will be collected and evaluated. Health related impacts will be studied through field collections and analyses of commercially- and recreationally-important fish and shellfish tissues. Additionally, information on seafood catch, consumption, and use patterns for the Gulf of Mexico will be gathered and analyzed. The facilities to be studied will include both offshore and coastal facilities in the Gulf of Mexico. Coastal sites will be additionally studied to determine ecological recovery of impacted wetland and open bay areas. The economic impact of existing and proposed effluent federal and state regulations will also be evaluated. The primary objectives of the project are to increase the base of scientific knowledge concerning (1) the fate and environmental effects of organics, trace metals, and NORM in water, sediment, and biota near several offshore oil and gas facilities; (2) the characteristics of produced water and produced sand discharges as they pertain to organics, trace metals, and NORM variably found in …

During this past quarter we further addressed the question of which species catalyzes removal of sulfur from coal by Bu{sub 3}P.

This was the seventh quarter of the contract. During this quarter we (1) continued the large task of processing the seismic data, (2) collected additional geological information to aid in the interpretation, (3) tied the well log data to the seismic via generation of synthetic seismograms, (4) began integrating regional structural information and fracture trends with our observations of structure in the study area, (5) began constructing a velocity model for time-to-depth conversion and subsequent AVO and raytrace modeling experiments, and (6) completed formulation of some theoretical tools for relating fracture density to observed elastic anisotropy. The study area is located at the southern end of the Powder River Basin in Converse County in east-central Wyoming. It is a low permeability fractured site, with both gas and oil present. Reservoirs are highly compartmentalized due to the low permeabilities, and fractures provide the only practical drainage paths for production. The two formations of interest are: The Niobrara: a fractured shale and limey shale to chalk, which is a reservoir rock, but also its own source rock. The Frontier: a tight sandstone lying directly below the Niobrara, brought into contact with it by an unconformity. A basemap is presented with the seismic …

Work over the past 3 years was directed toward the dynamics of elementary gas phase proton transfer reactions, particularly those of the O{sup {minus}} ion. Such reactions are important in flames. Published work over the past 30 months was concerned with dynamics of reactions of O{sup {minus}} with H{sub 2}O, NH{sub 3}, and HF. Results are enumerated here.

None

AQUATECH Systems a business unit of Allied-Signal Inc., proposes to demonstrate the technical viability and cost effectiveness of the SOXAL process a combined SO{sub x}/NO{sub x} control process on a 3 MW equivalent flue gas slip stream from Niagara Mohawk Power Corporation, Dunkirk Steam Station Boiler No. 4, a coal fired boiler. The SOXAL process combines 90+% sulfur dioxide removal from the flue gas using a sodium based scrubbing solution and regeneration of the spent scrubbing liquor using AQUATECH Systems` proprietary bipolar membrane technology. This regeneration step recovers a stream of sulfur dioxide suitable for subsequent processing to salable sulfur or sulfuric acid. Additionally 90+% control of NO{sub x} gases can be achieved in combination with conventional urea/methanol injection of NO{sub 2} gas into the duct. The SOXAL process is applicable to both utility and industrial scale boilers using either high or low sulfur coal. The SOXAL demonstration Program began September 10, 1991 and is approximately 22 months in duration. During the 6 months of scheduled operations period, expected to begin January 1992, data will be collected from the SOXAL system to define: SO{sub 2} and NO{sub x} control efficiencies; Current efficiency for the regeneration unit; Sulfate oxidation in the …

A number of sorbents with alumina-silicate base and sulfur capturing active sites have been developed for simultaneous removal of alkali metal compounds and sulfur dioxide. Current report will focus on bauxite sorbents, which includes experiments on sulfur dioxide absorption, alkali capturing and alkali/sulfur absorption simultaneously by bauxite-based sorbents. The alkali compound used here is sodium chloride. Experiments show an effective adsorption of sulfur or alkali separately, and the combined adsorption of alkali/sulfur. Atomic absorption analysis of reaction products shows that there is a much higher sodium content in the combined reaction products than that of the single reaction of alkali absorption by bauxite. Further X-ray diffraction analysis shows that there is sodium sulfate in the final products of simultaneous reaction, which indicates the formation and then condensation of sodium sulfate in the reaction system.

Sulfur dioxide is one of the major pollutant from coal combustion application and gasification. The capture of sulfur from flue gas with lime has been investigated and proven to be effective. Previous work concluded that the overall conversion of lime is limited by the micro-structure of the particles and reaction temperature. Due to the larger specific volume of product of calcium sulfate than that of the raw sorbent of calcium carbonate, which may cause pore blockage at the pore mouth and increase the diffusion resistance of sulfur dioxide through the product layer, but this pore plugging will not apply to the particle less than 0.01 cm in diameter. The reaction temperature, which determined the chemical reaction kinetics, between 800{degrees}C to 850{degrees}C, is recommended to be the best chemical reaction temperature for sulfur removal by lime. The alkali vapor removal has been the subject of many studies due to the possible application of coal combustion and hot flue gas turbine combined cycle which requires alkali concentration in the flue gas phase of sub parts per billion (ppB) level. But this process will increase the coal utilization efficiency dramatically. Some clay materials such as kaolinite and alumina-silica mixture like bauxite are found …

Document issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, Dan Morales, regarding a legal question submitted for clarification: Construction of Senate Bill 1342, Acts 1993, 73d Leg, ch. 964, which prohibits a school district from contracting with a business entity in which a trustee or his spouse has a "significant interest" (RQ-571)

Letter opinion issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, Dan Morales, regarding a legal question submitted for clarification; Whether a salaried municipal police officer may serve simultaneously as a salaried municipal judge in a different city (ID# 20331)

The research efforts on the importance of a coal-sand attrition continued with work in four categories: Continuous grinding tests using steel media; fracture tests on coal samples compacted at different pressure; SEM-Image analysis of feed and ground product coal samples; zeta potential measurements of coal samples ground by different media, and flotation test of coal samples ground by different media. Results are described.

The structure functions of deep-inelastic scattering at small-x satisfy two different equations in the leading logarithmic approximation (LLA). The first one -- the GLAP equation, describes the Q{sup 2}-evolution of partonic distributions h{sub i}(x). The second one -- the BFKL, equation determines the x-dependence of parton densities H{sub i}(x, k{sub {perpendicular}}). Analogous equations for matrix elements of higher twist operators were constructed in Refs. 3 and 4. Here the author discusses the possibility of finding an exact solution for multi-gluon compound states in LLA for the color group SU(N), in the limit N {yields} {infinity}. The contributions of diagrams with many reggeized gluons are important for the unitarization of the perturbative Pomeron in QCD. It is shown that the Bethe-Salpeter equations for compound states of many reggeized gluons are conformally invariant in the two-dimensional impact parameter space. Their solutions can be written in holomorphically factorized form and there is a differential operator commuting with the holomorphic part of the corresponding Hamiltonian.

Despite explicit Federal legislation forbidding combining commercial banking with commerce, it remains possible through corporate ownership to combine two kinds of banks with nonbanking activities. Federal legislation does permit combinations that have the effect of allowing some commingling, as is shown below. Continuing efforts to encourage these mixtures may be patterned on industrial banks or nonbank banks, whose operations are favorable for owners such as insurance, securities, or industrial firms.

This publication presents information for the month of August, 1993 on the following: Energy overview; energy consumption; petroleum; natural gas; oil and gas resource development; coal; electricity; nuclear energy; energy prices, and international energy.

An outline is given of the physics relating the Pomeron phase transition to the anomaly in QCD with many massless quarks. Implications for the existence of a further quark sector and its relation to dynamical electroweak symmetry breaking are described.

ESME is a computer program to calculate the evolution of a distribution of particles in energy and azimuth as it is acted upon by the radio frequency system of a proton synchrotron. It provides for the modeling of multiple rf systems, feedback control, space charge, and many of the effects of longitudinal coupling impedance. The capabilities of the program are described, and the requirements for input data are specified in sufficient detail to permit significant calculations by an uninitiated user. The program is currently at version 8.1 and extensively modified since the previous user documentation. Changes since the 7.xx versions include a new command and associated parameters for mapping phase space flow lines, new names for a few parameters, and a few new parameters for old commands. Special attention has been given to features relating to calculation of the collective potential and the generation of phase space trajectories including its effects. The VAX-based code management convention has been modified slightly to permit pre-compile options to be used in the include files as well as the program source files. The biggest change from v. 8.0 to v. 8.1 is the addition of code for HIGZ-based graphics; the new code and that …

WRAP-2A will process mixed and low-level waste (MLLW) for disposal. The final treatment processes selected for use in WRAP-2A consist of stabilization using cementitious materials and immobilization using thermosetting polymers. Modifications or additions to these processes may be made as technology improvements become known. Knowledge of the diverse waste forms that must be processed will be important to the effective exploration of process technologies that may be available. This document is a compilation of the current knowledge of the waste and process methods specified for each type of waste. As the uncertainties associated with the waste and methods of processing are addressed and resolved, revisions to this document will be made. This document is broken down by feed stream, source of the waste, waste codes, radiological characterization and recommended final forms of the waste for each stream.