The goal of this research is to develop and study an inorganic catalytic membrane reactor which will allow the oxidative coupling of methane to C{sub 2} hydrocarbons at near 100% selectivity and relatively higher conversion, by control of the oxygen supply through the membrane. The reactor setup has been completed. Repairs and purchase of new mass flow control equipment have been undertaken to enable accurate quantitative analysis of gas mixtures using the GC-MS. A four point sub miniature thermocouple assembly has been installed which allows temperature gaskets and seals have been tried to achieve good sealing at reaction temperatures. Gas permeability data have been obtained to monitor the change in porosity of a 20 nm pore size {alpha}-alumina membrane with increasing number of perovskite depositions.

The Monthly Energy Review provides an overview of the production, distribution, and consumption of energy derived from petroleum, natural gas, coal, electricity, and nuclear energy. It also discusses oil and gas resource development, energy prices, and issues relevant to international energy markets.

The GEM EM calorimeter is optimized for the best energy, position, angular resolution and jet rejection. The detailed simulation results are presented. In the barrel with LKr, an energy resolution of about 6%/{radical}{direct_sum}0.4%, pointing resolution of 40mrad/{radical}E + 0.5mrad, and jet rejection of a factor of 5 are expected.

The purpose of this plan is to determine hydraulic conditions at Well 399-1-16C (16C) and to present a remediation plan. The objectives are to restore hydraulic isolation of the confined aquifer (water level returning to approximately 370 ft) and to prevent chemical contamination between the unconfined and confined aquifers. This work scope is an extension of Task 4d of the Remedial Investigation/Feasibility Study Work Plan for the 300-FF-5 Operable Unit, Hanford Site, Richland, Washington, DOE/RL 89-14 (1990), and is a result of discussions held with the regulators and documented this plan was presented to the regulators at the January 1993 unit managers meeting and is documented in the minutes from that meeting.

Concurrent progress is being made in all key areas, namely, separation, characterization and market assessment. The market area, not one of our traditionally strong areas, has been going better than expected. We believe this is due mainly to the emerging interest in new and unconventional materials. The characterization work has been progressing solidly with the fundamental Z-BASIC correlations providing information not heretofore available in the chemical literature. Our agreement with Hewlett-Packard regarding the purchase of equipment at a reduced price is complete and the gc-ms will be ordered shortly. The separation work has progressed satisfactorily although an unexpected amount of time has been required for ``facilities`` and ``equipment`` related issues. Some of these issues have dealt with safety and regulatory compliance when storing larger quantities of samples. These now seem to be solved. We have a lot of direct experience in shale oil separations dating back to the OXY project and before. Also, we will streamline our work by going to prepacked micro-separation tools for some of our separation characterization work. This will allow us to stay on schedule. Overall, we are on schedule with the project. All administration requirements are in place and the accounting and financial records are …

This is the ``seventh`` and final Quarterly Report under the scope of work for cooperative agreement between the Western Interstate Energy Board and the US Department of Energy. The report covers the period January--March 1993. The cooperative agreement was to expire in June 1992, but DOE granted an extension through March 24, 1993. Since this is the last Quarterly Report under the expired cooperative agreement, most tasks are noted as being completed. Two final items, however, will soon be sent to DOE -- final minutes from the March 9--11 High- Level Radioactive Waste Committee meeting, and the Year-End Technical Report. Some highlights from the quarter: The Committee decided on a preferred format for the revised Spent Fuel and High-Level Radioactive Waste Transportation Primer. The document would be 100- 200 pages, accompanied by a series of white papers on key transportation elements. A 25--30 page handbook for educating western state elected officials would also be prepared. On March 24, the Committee sent a letter to DOE commenting on the Near-Site Transportation Infrastructure report findings. The Committee is concerned that infrastructure limitations may limit the rail shipping option in many instances, even after upgrades have been implemented. The NSTI findings may also …

The research project includes four tasks: GCM diagnosis, climate data preparation, climate data analysis, and the relationship between large- and regional-scale climates to address the following two scientific issues: the need for quality-assured climate data to study long term regional climate changes and to validate model simulated regional climate; and the need to understand the differences among GCMs in the simulations of present climate and climate changes due to increasing CO{sub 2} and other trace gases. This document consists of four sections: the project statement of work, the project progress for the period September 1, 1992--June 25, 1993, the plan for the remaining period, and the plan for the next project year.

In the new injection scenario antiprotons are injected onto a helical orbit in the Tevatron in order to avoid the detrimental effects of the beam-beam interaction at 150 GeV. The new scenario required changes in the tuning procedure. Antiprotons are too precious to be used for tuning, therefore the antiproton injection line has to be tuned with protons by reverse injecting them from the Tevatron into the Main Pang (MR). Previously, the reverse injection was performed in one supercycle. One batch of uncoalesced bunches was injected into the Tevatron and ejected after 40 seconds. Then the orbit closure was performed in the MR. In the new scheme the lambertson magnets have to be moved and separator polarities have to be switched, activities that cannot be completed in one supercycle. Therefore, the reverse injection sequence was changed. This involved the redefinition of TVBS dock event $D8 as MRBS $D8 thus marking it possible to inject 6 proton batches and eject them one at a time on command, performing orbit closure each time in the MR.

A weekly publication, the Texas Register serves as the journal of state agency rulemaking for Texas. Information published in the Texas Register includes proposed, adopted, withdrawn and emergency rule actions, notices of state agency review of agency rules, governor's appointments, attorney general opinions, and miscellaneous documents such as requests for proposals. After adoption, these rulemaking actions are codified into the Texas Administrative Code.

An important upgrade to the STAR detector at the Brookhaven National Laboratory RHIC accelerator will be an electromagnetic calorimeter. One design being considered for this calorimeter involves cast lead modules covering {Delta}{phi} = 6{degree} and 0 {le} {vert_bar}{eta}{vert_bar} {le} 1. These modules would consist of alternating layers of lead and sheets of plastic scintillator. The gaps for scintillator between the layers of lead would be created by parallel aluminum plates of thickness {approx_equal}6.6 mm = 0.260in. in the mold for the modules. These plates would need to be machined or ground to be reasonably flat, perhaps to {plus_minus}0.003in., and of uniform thickness from plate to plate. These requirements are imposed by the need to remove the plates from the casting after cooling, and to have good uniformity of the lead layer thickness, which gives good performance for the modules as a calorimeter. Aluminum was chosen for the plates because of its high coefficient of thermal expansion. An important cost in this calorimeter design is associated with the machining or grinding of the plates to proper thickness and flatness. In most cost estimates, it has been assumed that the mold parts could be used many times. This note describes a simple …

Net income for 259 energy companies-- including, 20 major US petroleum companies-- rose 38 percent between the first quarter of 1992 and the first quarter of 1993. An increased level of economic activity, along with colder weather, helped lift the demand for natural gas. crude oil, coal, and electricity. The sharp rise in the domestic price of natural gas at the wellhead relative to the year-ago quarter was the most significant development in US energy during the first quarter. As a consequence of higher natural gas prices, the upstream segment of the petroleum industry reported large gains in income, while downstream income rose due to higher refined product demand. Increased economic activity and higher weather-related natural gas demand also led to improvements in income for the rate-regulated energy segment. However, declining domestic oil production continued to restrain upstream petroleum industry earnings growth, despite a moderate rise in crude oil prices.

The goal of this project is to obtain the time history of impacts on the moon, with emphasis on recent impacts. In particular, the project could prove (or disprove) the existence of comet sores and provide the dates when they occurred.

Pressure rating calculations were done for some of the chimney and control dewar components. This engineering note documents these calculations. The table below summarizes the components looked at, and what pressure rating are. The raw engineering calculations for each of the components is given.

The Electric Power Monthly (EPM) is prepared by the Survey Management Division; Office of Coal, Nuclear, Electric and Alternate Fuels, Energy Information Administration (EIA), Department of Energy. This publication provides monthly statistics at the US, Census division, and State levels for net generation, fossil fuel consumption and stocks, quantity and quality of fossil fuels, cost of fossil fuels, electricity sales, revenue, and average revenue per kilowatthour of electricity sold. Data on net generation, fuel consumption, fuel stocks, quantity and cost of fossil fuels are also displayed for the North American Electric Reliability Council (NERC) regions.

Corrosion kinetics of SiC were investigated from 950 to 1100C at 0.63 vol% alkali vapor concentration. Corrosion rate in alkali is 10{sup 4} to 10{sup 5} times faster than oxidation rate of SiC in air. Activation energy of the alkali corrosion is 406 kj/mol, indicating a high sensitivity to temperature changes. Overall reaction appears to be controlled by the oxidation of SiC. The alkali corrosion kinetics of Si{sub 3}N{sub 4} from 950 to 1050{degrees}C were also examined in the same atmosphere (0.63 vol% alkali vapors). Reaction thickness of Si{sub 3}N{sub 4} appears to vary linearly with reaction time from 950 to 1050C, suggesting that the alkali corrosion process is controlled by the oxidation of Si{sub 3}N{sub 4}. At 1050{degrees}C, the alkali-enhanced oxidation of Si{sub 3}N{sub 4} is approximately 10{sup 7} times faster than the oxidation of Si{sub 3}N{sub 4} in dry oxygen. Compared to SiC corroded in the same alkali atmosphere, Si{sub 3}N{sub 4} seems to be less alkali-resistant than SiC. Phase relations of the Na{sub 2}O-Al{sub 2}TiO{sub 5} vertical section from 5--40 wt% Na{sub 2}O and 840-1100C were studied. Phase analysis indicates that this section is not a true binary system. A tentative phase diagram for the Na{sub 2}O-Al{sub …

The objective of this study was to examine the processes in coal/petroleum coprocessing systems which led to coke formation. Specifically, the interactions between the petroleum residue and coal, leading to retrogressive products, were investigated. Five coals were reacted with five model compounds in order to investigate the coal conversions in a variety of solvents and to determine the role of the solvent in promoting or inhibiting coal conversion. The selected model compounds range from paraffinic to fully aromatic and were chosen as representative of types of compounds that are found in petroleum residua. Coprocessing experiments were conducted using the five coals and three petroleum residua. The effect of temperature on coal conversions was crucial. The coal conversions at 350 and 400{degree}C seem to be governed by the nature of the coal and to a lesser extent by the petroleum residua. Negative coal conversions were observed above 400{degree}C indicating that retrogressive processes had occurred. At temperatures higher than 400{degree}C, the petroleum residua undergo physical and chemical transformations and the influence of the petroleum residua on coal conversions is significant. The structural features of the residues indicated that the residues were predominately coal-derived. An overall increase in aromaticity was observed with increasing …

Results that shed new light on the study of protein dynamics were obtained by quasi-elastic neutron scattering. The triple axis instrument H-9 supplied by the cold source was used to perform a detailed study of the quasi-elastic spectrum and the Debye-Waller factor for trypsin in powder form, in solution, and in crystals. A preliminary study of myoglobin crystals was also done. A new way to view the results of quasi-elastic scattering experiments is sketched, and the data on trypsin are presented and analyze according to this new picture.

Results that shed new light on the study of protein dynamics were obtained by quasi-elastic neutron scattering. The triple axis instrument H-9 supplied by the cold source was used to perform a detailed study of the quasi-elastic spectrum and the Debye-Waller factor for trypsin in powder form, in solution, and in crystals. A preliminary study of myoglobin crystals was also done. A new way to view the results of quasi-elastic scattering experiments is sketched, and the data on trypsin are presented and analyze according to this new picture.

Spectral broadening of single-frequency laser pulses by optical cross-phase modulation (XPM) with chaotic laser pulses in birefringent single-mode optical fibers is investigated numerically and results are compared with experiments. By this process we have generated laser pulses of variable bandwidth (1--25 {Angstrom}) at the fundamental wavelength (1053 nm) for amplification in high power solid-state Nd:glass lasers used for inertial confinement fusion research. Simulations indicate that a temporally smooth XPM pulse can be generated with intensity fluctuations of less than 10% and spectral width greater than 50 {Angstrom} using a short length ({approximately}5 m) of special low dispersion and low birefringence fiber, e.g. D = 10 ps/nm-km (normal dispersion) and {Delta}n = 2 {times} 10{sup {minus}5}. Readily available fibers of similar length, with parameters of D = 40 ps/nm-km and {Delta}n = 6 {times} 10{sup {minus}5}, can give spectral widths exceeding 25 {Angstrom}, but the noise will range from 25 to 60%. Broadband laser pulses generated by XPM are now routinely used at Lawrence Livermore National Laboratory for active smoothing of the laser irradiance on targets by the technique of smoothing-by-spectral dispersion.

Weekly newsletter discussing natural resources, parks, hunting and fishing, and other information related to the outdoors in Texas.

A weekly publication, the Texas Register serves as the journal of state agency rulemaking for Texas. Information published in the Texas Register includes proposed, adopted, withdrawn and emergency rule actions, notices of state agency review of agency rules, governor's appointments, attorney general opinions, and miscellaneous documents such as requests for proposals. After adoption, these rulemaking actions are codified into the Texas Administrative Code.

The technical work during this reporting term has principally involved the continued development, optimization and improvement of freezing drying techniques for solid ceramic oxide electrolyte powder preparation, preliminary optimization of the calcining of the ceramic electrolyte freeze dried powders to allow for optimum processing to the IGR composite, and determining (initial) electrochemical properties of the stabilized ceramic solid electrolyte at a variety of temperatures in air.

The technical work during this reporting term has principally involved the continued development, optimization and improvement of freezing drying techniques for solid ceramic oxide electrolyte powder preparation, preliminary optimization of the calcining of the ceramic electrolyte freeze dried powders to allow for optimum processing to the IGR composite, and determining (initial) electrochemical properties of the stabilized ceramic solid electrolyte at a variety of temperatures in air.

Silica aerogel consists of bonded silicon and oxygen joined into log strands, which are randomly linked together with pockets of air between them. Discovered in the 1930s, the material was thought to have little use outside of theoretical science. However, with the advent of greatly improved processing techniques, such as those developed at Lawrence Livermore National Laboratory, aerogels are on the verge of commercialization. This document describes the need for aerogels in the high-speed microelectronics industry, and state of the art processing techniques. Collaboration is welcomed in the endeavor.