A discussion of the Flettner rotor is presented from a nautical and economic viewpoint, and although it was a failure, the experimental and theoretical inventions cannot be disregarded. The following critical and experimental investigation will show the relations and applicability of the theories and practical applications. The Magnus effect is described in detail and a discussion and critical review of the Magnus effect is included.

The tapered wing shape increases the lift in the middle of the wing and thus reduces the bending moment of the lifting forces in the plane of symmetry. Since this portion of the wing is the thickest, the stresses of the wing material are reduced and desirable space is provided for stowing the loads in the wing. This statically excellent form of construction, however, has aerodynamic disadvantages which must be carefully weighed, if failures are to be avoided. This treatise is devoted to the consideration of these problems.

This report will present ideas closely related to the vortex conception and illustrate them in the simplest possible terms. In addition to these general considerations, this report will attempt to show the application of the vortex theory in connection with the wing theory.

The accuracy of the instruments used for flight test measurements has been inadequate so a new series of tests were commissioned with the development of an accurate elevator setting recorder.

The suggestion for the measurements collected in this report was prompted by the results of spinning experiments. For the theoretical spinning investigations there was a lack of data on lateral force, yawing, and rolling moment of airplanes.

This report provides a summary of the important steps to be taken in combating airplane fires. Some considerations and ways of preventing fires from developing are provided.

In the present study it is proposed to provide an equipment permitting the study of the propagation of the region of reaction in mixtures of air and carbureted gases enclosed within a cylinder. Ignition is produced at the end of compression by an electric spark. With this apparatus it is proposed to determine: 1) the influence of the richness of the explosive mixture on the rate of flame propagation; 2) the influence of the degree of volumetric compression on one of the hydrocarbons; 3) the influence of the variation of initial temperature of the mixture before compression; 4) the influence of tetraethyl-lead on the propagation - notably on the formation of the explosive wave.

Memorandum presenting the experimental results of tests to confirm the contribution to the study of normal burning in gaseous carbureted mixtures.

"Two screw propellers, a normal airplane propeller with a pitch/diameter ratio H/D = 0.5 and a helicopter propeller H/D = 0.2 were tested in the large wind tunnel of the Gottigen Aerodynamic Institute. With both propellers the angle between the propeller axis and the direction of the wind was varied from 0 to 90 degrees. In addition to the three force and the three moment components in a wind-fast coordinate system, the corresponding components in a propeller-fast coordinate system, a total of six force and six moment components, together with the propulsive efficiency, were measured or calculated from measurements" (p. 1).

In this mathematical investigation, made in collaboration with Dr. Wilhelm Schmidt, we interpret the temporary change (due to some disturbance) in the quantities which define the position of the airplane while in a flat spin. We further examine the effect of this change, of the means resorted to to produce the disturbance, and thus reveal the expedients available for recovering from a flat spin.

From Summary: "The present report is, in the first place, a compilation of the test results now available from wing tests up to angles of attack 90^o. Reports are also given of tests with monoplane and auxiliary wings in the Gottingen wind tunnel for the purpose of plotting a steadily rising curve of the normal force as a foundation of the angle of attack."

The working process of the Junkers engine has resulted from a series of attempts to attain high performance and to control the necessarily rapid and complete combustion at extremely high speeds. The two main problems of Diesel engines in aircraft are addressed; namely, incomplete combustion and the greater weight of Diesel engine parts compared to gasoline engines.

Memorandum presenting a description of the Dornier seaplane Do X. Details of the general description, materials, details of the main wing and upper wing, details of the hull and of the wing stubs, tail surfaces and control lines, power plant, and launching car and floating dock are provided.

This report deals with the measurement of the velocity distribution of the air in the velocity of a plate placed parallel to the air flow. The measurements took place in a small wind tunnel where the diameter of the entrance cone is 30 cm and the length of the free jet between the entrance and exit cones is about 2.5 m. The measurements were made in the free jet where the static pressure was constant, which was essential for the method of measurement used.

"This report is intended to furnish bases for load assumptions in the designing of airplane controls. The maximum control forces and quickness of operation are determined. The maximum forces for a strong pilot with normal arrangement of the controls is taken as 1.25 times the mean value obtained from tests with twelve persons. Tests with a number of persons were expected to show the maximum forces that a man of average strength can exert on the control stick in operating the elevator and ailerons and also on the rudder bar" (p. 1).

The method of riveting by forming the closing head under increasing pressure or by a series of hammer blows is investigated. The question as to the best edge distance, i.e. that distance from the rivet center to the plate edge below which it is unadvisable to go and, at the same time useless to go beyond, was examined. The slippage of plates which occurs under the effect of a certain stress, does not completely disappear on unloading.

The present report gives the results of tests which were made for the purpose of solving the problem of whether diagrams obtained from pressure tests could be conclusive for the determination of the safe impact coefficients. It is first established that the rubber rings adhere firmly to the compression surfaces during deformation. Suggestions are thus obtained for a constructive simplification of the rubber rings. The hysteresis phenomenon is ascribed to external and internal friction forces. A device for falling tests is then described with which the process of shock absorption with rubber rings was tested.

This survey is intended to give a general approximate idea of the stability and controllability of German airplanes. Both flight characteristics, including the behavior of the airplane under the action of deflected controls and external disturbances, and flight performance, which refers to climbing, speed, take-off, and landing qualities.

In horology the friction between solids is of the greatest importance; one limited, however, to the application of the laws of Coulomb which, do not at all correspond with reality. This report presents a review of the subject and some general conclusions. The choice of lubricant is discussed as well as the pressure between frictional surfaces. The gears in a watch are used extensively as examples.

"The effect of a slotted wing depends essentially on the fact that a secondary flow branches off from the main flow and passes to the suction side of the profile. It is thus possible to delay the separation greatly and increase the lift. The practical aspect of the slotted wing is less known in Germany, especially the results obtained during the last three years since the introduction of the 'auto control slot'" (p. 1).

"For some time the D.V.L. has been investigating the question of applicability of Handley Page slotted wings to German airplanes. Comparitive gliding tests were made with open and closed slots on an Albatros L 75 airplane equipped with the Handley Page "auto control slots." This investigation served to determine the effect of the auto control slot on the properties and performances of airplanes at large angles of attack. The most important problems were whether the angle of glide at small angles of attack can be increased by the adoption of the auto control slot and, in particular, as to whether the flight characteristics at large angles of attack are improved thereby and equilibrium in gliding flight is guaranteed even at larger than ordinary angles of attack" (p. 1).

This report presents a calculation of the torsional frequencies of revolving bars with allowance for the air forces. Calculation of the flexural or bonding frequencies of revolving straight or tapered bars in terms of the angular velocity of revolution. Calculation on the basis of Rayleigh's principle of variation. There is also a discussion of error estimation and the accuracy of results. The author then provides an application of the theory to screw propellers for airplanes and the discusses the liability of propellers to damage through vibrations due to lack of uniform loading.

The limitation of the 1929 contest to performance gliders necessitated the establishment of a formula which would make it possible to distinguish between performance gliders and school and training gliders. The sinking speed was therefore adopted as the basis for such a distinction, and the requirement was made that the sinking speed of a performance glider should not exceed 0.8 m/s. The rest of the report details the different entries with regard to design and performance.

This report details the advantages and construction of tailless airplanes. Both a glider and a powered model were built and the specifications of both airplanes are listed.