Report discussing tests to determine the aerodynamic characteristics of a model of a 45 degree swept-wing fighter airplane and to determine the loads on attached stores and detached missiles. An investigation into aileron-spoiler effectiveness, aileron hinge moments, and the effects of wing modifications of aerodynamic characteristics was also carried out at various Mach numbers. Results are presented, but caution is provided in regards to extrapolating results from the model onto a full-scale aircraft.

Memorandum presenting an evaluation of the performance increase resulting from the addition of 20 percent fluorine to the oxygen-RP-1 propellant combination in a 5000-pound-thrust rocket engine at a chamber pressure of 650 pounds per square inch absolute. Runs were made with the engine water cooled and regeneratively cooled.

Translating spike inlet air flow regulation characteristics from transonic to supersonic speeds at zero angle of attack.

Memorandum presenting a transonic flutter investigation of models of the all-movable horizontal tail of a fighter airplane in the transonic blowdown tunnel. The models were dynamically and elastically scaled by criteria which provide a flutter safety margin. Results regarding some general comments, simulated airplane tests, effects of pitch stiffness with rearward pitch axis, and effect of pitch-axis location are provided.

"An investigation has been made in the NACA Lewis icing research tunnel to determine the aerodynamic and icing characteristics of a full-scale induction-system air-scoop assembly incorporating a flush alternate inlet. The flush inlet was located immediately downstream of the offset ram inlet and included a 180 deg reversal and a 90 deg elbow in the ducting between inlet and carburetor top deck. The model also had a preheat-air inlet" (p. 1).

From Summary: "In an effort to increase the operational range of existing small icing tunnels, the use of truncated airfoil sections has been suggested. With truncated airfoils, large-scale or even full-scale wing-icing-protection systems could be evaluated. Therefore, experimental studies were conducted in the NACA Lewis laboratory icing tunnel with an NACA 651-212 airfoil section to determine the effect of truncating the airfoil chord on velocity distribution and impingement characteristics. A 6-foot-chord airfoil was cut successively at the 50- and 30-percent-chord stations to produce the truncated airfoil sections, which were equipped with trailing-edge flaps that were used to alter the flow field about the truncated sections. The study was conducted at geometric angles of attack of 00 and 40, an airspeed of about 156 knots, and volume-median droplet sizes of 11.5 and 18.6 microns. A dye-tracer technique was used in the impingement studies."

"An NACA 65(sub 1)-212 airfoil of 8-foot chord was provided with a gas-heated leading edge for investigations of cyclical de-icing. De-icing was accomplished with intermittent heating of airfoil segments that supplied hot gas to chordwise passages in a double-skin construction. Ice removal was facilitated by a spanwise leading-edge parting strip which was continuously heated from the gas-supply duct. Preliminary results demonstrate that satisfactory cyclical ice removal occurs with ratios of cycle time to heat-on period (cycle ratio) from 10 to 26" (p. 1).

From Summary: "A procedure is presented for determining boundary-layer quantities from pressure-rake data, which include the combined effects of viscous and shock losses. The problem is analyzed using schileren photographs of the shock configuration, the continuity of mass relationship, and the characteristics of the turbulent boundary layer that its outer edge is defined by a rapid change in slope in the Mach-number profiles in the vicinity of the edge."

From Summary: "Sound pressure levels, frequency spectrum, and jet velocity profiles are presented for an engine-afterburner combination at various values of afterburner fuel - air ratio. At the high fuel-air ratios, severe low-frequency resonance was encountered which represented more than half the total energy in the sound spectrum. At similar thrust conditions, lower sound pressure levels were obtained from a current fighter air craft with a different afterburner configuration. The lower sound pressure levels are attributed to resonance-free afterburner operation and thereby indicate the importance of acoustic considerations in afterburner design."

Memorandum presenting the effect of missile armament on the performance of an interceptor-type aircraft model at Mach numbers 1.5, 1.7, and 1.9 and at angles of attack up to 19 degrees. The aircraft model was characterized by triangular-shaped normal-shock inlets located at wing roots. Results regarding force measurements, effect of armament on inlet-duct performance, fuselage boundary-layer survey, and total-pressure contours at inlet throat and diffuser exit are provided.

Memorandum presenting a technique for predicting the influence of body vortices and the wing shock-expansion field on the pitch-up characteristics of supersonic airplanes to supplement the calculative methods for wing vortices which are well known. The method is applied to the prediction of the pitch-up characteristics of four airplanes with high tails, of which one serves as a calculative example.

Memorandum presenting static longitudinal stability and control characteristics of a flare-stabilized body of revolution employing a movable portion of the flare surface as a pitch control determined for a range of Mach numbers, angles of attack, and control deflections. The variation of lift coefficient with pitching-moment coefficient for the basic configuration with control undeflected was found to be essentially linear, and the stability to increase slightly with increasing Mach number.

Combustion efficiency of pentaborane fuel in 48- inch diameter ramjet engine.

Report presenting an investigation to determine separately the aerodynamic characteristics of a Douglas Aircraft Company store and a semispan delta-wing-fuselage configuration in the presence of one another. The store was located at the 50-percent-semispan station with the store nose both ahead of and behind the wing leading edge for two longitudinal and three vertical positions.

Memorandum presenting a performance investigation using hydrogen fuel in a full-scale afterburner conducted with particular study of fuel-injector configurations and afterburner length. A total of seven fuel-injector configurations, grouped by type as concentric ring or radial bar, were investigated at a specified burner-inlet velocity and range of burner-inlet total pressures.

Memorandum presenting an analysis of the effect of adding fluorine to the Vanguard first-stage oxidant. An increase in specific impulse of 5.74 percent may be obtained with 30 percent fluorine. Charts are provided regarding the vehicle performance increases for a zero-drag vertical trajectory.

Pressure tunnel investigation of supersonic store interference in vicinity of 22 degree swept wing fuselage configuration at Mach numbers 1.61 and 2.01.

"Flutter tests have been conducted on two low-aspect-ratio wing plan forms under consideration by the Boeing Airplane Company for the 110A weapons system. These configurations had three heavy nacelles near the trailing edge, and flutter tests were made both with and without the nacelles. Up to a Mach number of 3.0 the dynamic pressure required for flutter of a wing with nacelles was generally higher than that of a wing without nacelles" (p. 1).

Report presenting an investigation of the properties of hydrazine, stability and corrosiveness with a number of construction materials, sensitivity to detonation and temperature, and spontaneous reaction with the oxidants, concentrated hydrogen peroxide, sodium permanganate solution, fuming nitric acid, and tetranitromethane. Results regarding corrosion and stability, sensitivity to temperature and detonation, and theoretical calculations are provided.

"Results of tests of an airspeed head mounted on a freely falling body are presented in preliminary form. Measurements were made throughout the transonic speed range. Details and dimensions of the airspeed head and the body are given in figure 1" (p. 1).

Report presenting a lateral-control investigation of 3- and 6-percent chord spoilers projecting on the upper surface of a wing of high-aspect ratio. The spoilers were found to give large rolling moments at Mach numbers below the Mach number corresponding to the break in the rolling-moment-coefficient curves. Results regarding section pressure distributions, rolling-moment characteristics, normal-force characteristics, pitching-moment characteristics, wing-torsional considerations, and hinge-moment characteristics are provided.

Report presenting tests to determine the effects of sweepback angle and aspect ratio on the drag of an NACA 65-009 airfoil at supersonic speeds. The results indicated that for the range of Mach numbers investigated, increasing the sweepback angle and decreasing the aspect ratio reduced the value of the wing drag coefficient.

Report presenting the air-flow behavior over the wing of an XP-51 airplane including photographs of tufts attached to the wing surface and chordwise pressure distributions. A comparison of tuft studies from flight results are compared with results from wind-tunnel testing. Three types of flow were observed: steady flow, unsteady flow, and break-away flow are provided.

Memorandum presenting an investigation conducted using a single combustor from a 4600-pound-thrust turbojet engine to determine if ignition-plug fouling by carbon deposits could be prevented by retracting the plug from the combustion zone during operation after ignition had taken place. The fuels used were normally conducive to forming carbon. The results indicated that retracting the ignition plug from the combustion zone after ignition prevented plug fouling by carbon.