None

Symbols and definition of various airspeed terms that have been adopted as standard by the NACA subcommittee on aircraft structural design are presented. The equations, charts, and tables required in the evaluation of true airspeed, calibrated airspeed, equivalent airspeed, impact and dynamic pressures, and Mach and Reynolds numbers have been compiled. Tables of the standard atmosphere to an altitude of 65,000 feet and a tentative extension to an altitude of 100,000 feet are given along with the basic equations and constants on which both the standard atmosphere and the tentative extension are based.

None

Report presenting the results of tests to determine the effect of taper on the zero-lift drag of wings of constant exposed aspect ratio at low supersonic speeds. Findings indicated that maximum thickness, leading-edge, and trailing-edge sweep are all important in determining the drag coefficient of a tapered wing.

Technical report. Long-time tests have been made on the effect of various types of radiation on the corrosion of 2S aluminum in simulated W water. In no case was any acceleration of corrosion by the radiation observed; the effect of radiation, if any, appeared to be a protective one. Deuteron irradiation did accelerate the corrosion of mild steel at low flow rates in hot water of pH 6 to 7, but no appreciable effect was observed with copper, stainless steel, or tuballoy. The general theory of the effect of radiation on corrosion is discussed, with the conclusion that no acceleration of corrosion by radiation is to be expected in most cases of practical interest.

Long-time tests have been made on the effect of various types of radiation on the corrosion of 2S aluminum in simulated W water. In no case was any acceleration of corrosion by the radiation observed; the effect of radiation, if any, appeared to be a protective one. Deuteron irradiation did accelerate the corrosion of mild steel at low flow rates in hot water of pH 6 to 7, but no appreciable effect was observed with copper, stainless steel, or tuballoy. The general theory of the effect of radiation on corrosion is discussed, with the conclusion that no acceleration of corrosion by radiation is to be expected in most cases of practical interest. (auth)

Report discusses the results of an experimental investigation of two low-drag wing-nacelle units suitable for use with pusher propellers. The benefits of adding a nacelle to the wing are detailed.

Report presenting a consideration of the development of the laminar boundary layer in a compressible fluid. Formulas are given for determining the boundary-layer thickness and the boundary-layer Reynolds number, which is a measure of the boundary-layer stability, for airfoils and bodies of revolution.

Report issued by the U.S. Bureau of Mines regarding laboratory tests conducted on acid leaching of manganese ore. Descriptions of the methods used in testing and results are presented. This report contains tables, and graphs.

The following report records the study of albino rats subjected to beta rays and analyzes the skin reactions and metabolic patterns.

Aluminum oxide occupies a larger volume than the aluminum it contains would fill as metal, consequently, the assumption has been made that holes in metallic aluminum would close by a sufficient amount of oxidation. Therefore, we were asked to investigate the rate of plug formation under conditions to be expected in the pile. For the latter we were requested to approach the pile conditions as nearly as we could by employing the Chicago cyclotron. It seems to us that the problem divides itself into two separate questions: (1) under what conditions may holes be expected to close? (2) if holes do close how much corrosion of uranium may be expected before the closure becomes impervious to water vapor? In this report only the first question is considered. The experiments and theory coupled with the data collected by other workers on the project definitely define the limits within which pores in the aluminum cans may be expected to close by an oxidation process. Under the most favorable conditions only small holes may be sealed in this manner. In the large majority of the cases the holes not only fail to close but become larger.

This report contains the flight-test results of the longitudinal-stability and -control phase of a general flying qualities investigation of the Lockheed P-80A airplane (Army No. 44-85099). The tests were conducted at indicated airspeeds up to 530 miles per hour (0.76 Mach number) at low altitude and up to 350 miles per hour (0.82) Mach number) at high altitude. These tests showed that the flying qualities of the airplane were in accordance with the requirements of the Army Air Forces Stability and Control Specification except for excessive elevator control forces in maneuvering flight and the inadequacy of the longitudinal trimming control at low airspeeds.

Report presenting testing of a low-acceleration transonic flutter test vehicle to obtain flutter data on two similar sweptback wings which indicated that wing flutter was symmetrical in mode. Results regarding flight and flutter characteristics for the FR-1-B are provided.

Note presenting an investigation of the effects of tip dihedral on lateral stability and control characteristics by flight tests of models in the free-flight tunnel. The results indicate that at high lift coefficients, tip dihedral may cause a lightly damped lateral oscillation, which does not occur with full-span dihedral at similar values of effective dihedral and directional stability.

Report describing results of experiments that involved injecting radioactive yttrium into animals: "The excretion, retention, and distribution of the yttrium was measured, and its effect on survival and growth was observed. The average total excretion of Y91 to the time of death (from 76 hours to 24 days) was a little less than 30 per cent of the injected dose" (p. 2).

This is the University of California, Radiation Laboratory progress report for June 15-July 15, 1948. It discusses the following: (1) 184-inch Cyclotron Program; (2) 60-inch Cyclotron Program; (3) Synchrotron Program; (4) Linear Accelerator Program; (5) Experimental Physics; (6) Theoretical Physics, (7) Isotope Separation Program; (8) Chemistry Departments; (9) Medical Physics; and (10) Health Physics and Chemistry.

From Summary: "An analysis of the nose-inlet shapes developed in previous investigations to represent the optimum from the standpoint of critical speed has shown that marked similarity exists between the nondimensional profiles of inlets which have widely different proportions and critical speeds. With the nondimensional similarity of such profiles established, the large differences in the critical speeds of these nose inlets must be a function of their proportions. An investigation was undertaken in the Langley 8-foot high-speed tunnel to establish the effects of nose-inlet proportions on critical Mach number and to develop a rational method for the design of high-critical-speed nose inlets to meet desired requirements."

Report presenting a note in two parts regarding simplified truss stability criteria. The first part covers the development of simplified criteria for the stability of planar pin-jointed trusses against buckling in the plane of the truss. The second part constitutes a report on tests carried out to verify the validity of the criteria developed in part one.

Report presenting an experimental investigation of thrust augmentation of an axial-flow-type turbojet engine with a 4000-pound-thrust rating using a water-alcohol injection at the compressor inlet at sea-level conditions and zero ram. Three injection systems were investigated in order to obtain satisfactory atomization and distribution of the injected liquids. Results regarding engine performance and engine operation are provided.

This document is a de-classified July 1948 General Chemistry Progress Report from Monsanto Chemical`s Mound facility. Detailed discussions of numerous studies of Postum compounds are included in this report, and experimental data on various chemical and physical properties of these compounds are given.

"The theoretical critical stress is derived for a simply supported curved rectangular panel in axial compression having a central chordwise stiffener offering no torsional restraint. The results are presented in the form of computed curves and a table. Because a panel of moderate or large curvature buckles in compression at a stress considerably below the theoretical value, a method is suggested to aid in determining the critical stress for use in design" (p. 1).

Describes the characteristics of peppers, lists the different varieties, and the steps necessary to successfully produce quality peppers.

Report discussing an analysis has been made by the NACA of the effects of heat and compressibility in the flow through the internal systems of aircraft along with equations and charts are developed whereby the flow characteristics at key stations in a typical internal system may be readily obtained.

"The production-model 333-A-23 turbojet-engine compressor with a 17-blade impeller was operated at ambient and 0 F inlet temperatures and at inlet pressures of 14 and 5 inches mercury absolute for equivalent impeller speeds from 6000 to 12,750 rpm. The results of this investigation are compared with those of the 533-A-21 compressor. At the design equivalent speed of 11,750 rpm the maximum pressure ratio was 4.39" (p. 1).