Report discussing an analysis has been made by the NACA of the effects of heat and compressibility in the flow through the internal systems of aircraft along with equations and charts are developed whereby the flow characteristics at key stations in a typical internal system may be readily obtained.

"The Von Karman equations for a thin flat plate with large deflections are solved for the special case of a plate with clamped edges having a ratio of length to width of 1.5 and loaded by uniform normal pressure. Center deflections, membrane stresses, and extreme-fiber bending stresses are given as a function of pressure for center deflections up to twice the thickness of the plate. For small deflections the results coincide with those obtained by Hencky from the linear theory" (p. 1).

Report presenting an analytical study of the influence of full-span slotted and Fowler flaps on the requirements for horizontal tail surfaces. The elevator deflection required to land at three-point attitude, elevator deflection required to stall the airplane at altitude, and permissible center-of-gravity range have been calculated for a fighter-type airplane.

Report presenting the calibrations of three types of service pitot-static tubes over an approximate range of speeds of 150 to 600 miles per hour. The calibrations indicated a need for a pitot-static tube with greater accuracy, especially at higher speeds. Results regarding the service tubes, Prandtl tube, Eigh-speed tube, and a comparison of the tubes are provided.

Report presenting the results of comparative cooling tests run on two Wright C9GC (G-200) cylinders, one with the original steel fins and one with 1-inch spiral copper fins brazed on the barrel. Calculations were also performed using copper and aluminum fins with the same weight as the original steel fins, which showed positive results. Results regarding cylinder-temperature correlation, piston-temperature correlation, and comparative performance are also provided.

Report presenting a technique of testing wind tunnel powered models developed as a result of experience gained in the investigation of the static longitudinal and lateral staiblity and control characteristics of several powered models in the 7- by 10-foot wind tunnel. A discussion of the conditions to be investigated, methods of presenting and interpreting the data, and a suggested operating technique are given.

"The field for curved blades is represented by a vortex series with a vortex removed at the blade point. Further, an example of calculation of a curved blade from this series is given, whereby the necessary accuracy required of the different methods in practice is shown according to the case considered" (p. 1).

Report discusses the results of an experimental investigation of two low-drag wing-nacelle units suitable for use with pusher propellers. The benefits of adding a nacelle to the wing are detailed.

Report presenting an investigation to determine whether some characteristic of the boundary layer could be used to provide warning of the increase in stalling speed of a wing caused by ice formations on the leading edge. Results were analyzed by referring the total pressures at the rake to the free-stream total pressure, static pressure at the rake, free-stream static pressure, and static pressure from wind-tip swiveling head.

Report presenting a study of the performance of bombers powered by one, two, four, and six 2000-horsepower engines supercharged to 25,000 feet. The performances are computed and are based on drag coefficients equal to the best obtained on modern airplanes and on weight estimates obtained from modern Army Air Forces airplanes. A chart is provided with the coordinates of power loading and wing loading noted so that all performances can be compared.

"In connection with recent tests of a 1/4-scale model pursuit airplane in the NACA 8-foot high-speed tunnel, gun openings having low drag were developed for installation in the nose of the fuselage. The increase in the fuselage-drag coefficient for the final form of openings was 0.0132 at a Mach number of 0.69 and at an angle of attack of 0 degrees. The corresponding drag coefficient based on the wing area was about 0.0005. The critical speed of the airplane was not affected by the gun openings" (p. 1).

Report presenting an investigation of means to increase the range of several airplanes to 6000 miles, including the B-17E, B-24D, B-26C, and B-25A. Tank-wing trailers and tank gliders were found to be the most practical ways of increasing range and calculations are provided for determining the proper loading and dimensions.

Report presenting the results of recent spin-tunnel tests on models of seven multiengine airplanes and compared with corresponding results for representative single-engine airplanes loaded along the fuselage. Multiengine airplanes were found to give steep spins with high rates of descent and high load factors.

Report presenting a new method for obtaining the velocity potential of the flow about a solid of revolution moving uniformly in the direction of its axis of symmetry in a fluid otherwise at rest. The method is based essentially on the fact that the form of the differential equation for the velocity potential is invariant with regard to conformal transformations in a meridian plane. The general results are applied to a body of revolution obtained by revolving a symmetrical Joukowski profile about its axis of symmetry.

Report presenting an investigation of the performance of a mixed-flow impeller and vaned diffuser unit with several modifications in a variable-component supercharger test rig. The investigation covered impeller tip speeds from 800 to 1200 feet per second over the range of air flows from wide-open throttle to incipient surge. The results showed the supercharger to have a peak efficiency of 0.77 and a peak pressure coefficient of 0.61 with the impeller frontal clearance at 0.035 inch.

"The present measurements form a continuation of earlier flight tests published in a previous report for predicting the downwash at the tail of an airplane. The method makes use of the tail itself as integrating contact surface to the extent that, beginning from the measurement of the self-alignment of the elevator, the mean downwash angle and dynamic pressure at the tail are determined. The instrumental accuracy is considerably improved if the elevator is completely separate from the controls during the tests, because the effect of friction on the self-alignment of the elevator is then reduced to a minimum and a finer elevator weight balance is rendered possible" (p. 1).

Report presenting information about airfoils in cascade, including the angle through which the air is turned and where the cascade losses are located.

From Summary: "An investigation was carried out in the NACA low-turbulence tunnel to develop low-drag airfoil sections suitable for admitting air at the leading edge. A thickness distribution having the desired type of pressure distribution was found from tests of a flexible model. Other airfoil shapes were derived from this original shape by varying the thickness, the camper, the leading-edge radius, and the size of the leading-edge opening. Data are presented giving the characteristics of the airfoil shapes in the range of lift coefficients for high-speed and cruising flight."

Report presenting a preliminary investigation to determine the suitability of ejectors actuated by the exhaust of a radial air-cooled aircraft engine for providing engine cooling air at the ground condition. Various length and diameter ejectors were tested for varying engine power for nine ejectors actuated by the exhaust of individual cylinders and three ejectors actuated by the exhaust of groups of three cylinders.

Note presenting a study of the electrical charge structure of thunderstorms by the use of continuously synchronized records of the electrical-potential gradient at the surface of the earth under the influence of active storms.

"Tests were made in the NACA 19-foot pressure tunnel of a simplified twin-engine bomber model with an NACA low-drag wing primarily to obtain an indication of the effects of engine nacelles on the characteristics of the model both with and without simple split trailing-edge flaps. Nacelles with conventional-type cowlings representative of those used on an existing high-performance airplane and with NACA high-speed type E cowlings were tested. The tests were made without propeller slipstream" (p. 1).

Report presenting a theoretical analysis of the performance of propellers extending to high values. Charts are presented that facilitate the selection of the most efficient propellers over a wide range of operating conditions.

Report presenting an analysis of records of more than 134,000 flying hours, which have been received and evaluated in order to bring the V-G recorder data up to date. The analysis of the records is contained in the report. Results indicate that the maximum effective gust velocities for both the land transport airplanes and the flying boats have approached values of 40 feet per second.

Report presenting testing of cooling blowers for air-cooled engine installations and an exploration of the methods used in the blower design and operating characteristics of the blowers over a range of flight speeds and altitudes. The results indicate that the blowers operate as a more efficient type of propeller cuff and in many cases provide considerably more pressure boost than using a cuff.