The problem before us is to determine the total stresses in an axially loaded column of any degree of restraint which is also subject to transverse bending both from a uniformly distributed load and from concentrated loads. The solution of this problem is of special importance in the design of aircraft which consist of slender columns" (p. 1).

Ballistics is a science hundreds of years old and this report is an attempt to show how these older principles can be used in the newer science of aerodynamics.

In short, the "politics of aviation" lies in a few propositions: the need of having as large a number of fields as possible and of sufficient area; the utilization of the larger part of the existing military fields; the selection of uncultivated or unproductive fields, whenever technical conditions permit; ability to disregard (save in exceptional cases) objections of an agricultural nature.

The establishment of air service in the Belgian Congo is detailed in this report. The airplanes, landing fields, and air routes are all discussed.

This article discusses the different passenger air transport services offered in Europe. The author deals mainly with the service offered between different cities, in terms of time and cost.

For some time, the designers of airplanes have begun to occupy themselves with the question of longitudinal stability. In their quest to simplify calculation and data collection, the designers have attached the greatest importance to the coefficient of initial longitudinal stability. In this study a diagram was constructed from the data of the tunnel tests, which depends neither on the position of the center of gravity nor of the angle of deflection of the elevators. This diagram is constructed by means of straight lines drawn through the metacenters of the complete airplane, in a direction parallel to the tangents to the polar of the airplane relative to a system of axes fixed with reference to the airplane.

This report is a listing of the different studies conducted by the Institute in May thru August of 1921. The aerodynamical section studied: the aerodynamical characteristics of a very thick concave-convex wing; the disturbance caused in a tunnel by the presence of a disk, placed in relation with a transversely infinite barrier; vertical pressure in a wing of low head resistance; the drag caused by two small doors in the sides of the fuselage. Some other studies conducted by the Institute included: depressions in the interior of the model of a wing; the influence of a conical casing fitted with helicoidal flanges centered on the hub of the propeller; the influence of the velocity of translation on the aerodynamical effects of the propeller; and the influence of a honeycomb placed in the tunnel.

Report discussing the problem to be solved, as presented to the pilot or observer of an aircraft, is as follows: The aircraft starting from A must land at B, the only data being the speed of the airplane, the altitude and the orientation D of the course. The above data would be amply sufficient, were it not for the fact that the airplane is constantly subjected to a wind of variable direction and strength.

A series of equations relating to airplanes are given and examples listed. Some of the equations listed include: the speed, altitude and carrying capacity of various airplanes; weight of an airplane; weight of various parts of an airplane; the polars of the wings; speeds of airplanes; radius of action.

A beacon light manufactured by the Julius Pintsch Company is described and the arrangement of these lights on a landing field is discussed.

In order to determine the efficiency of a propeller as accurately as possible, its revolution speed, thrust and power absorbed must be measured during flight. Unfortunately, these measurements can only be made with very complicated equipment. To surmount this problem the testers contented themselves with approximate results obtainable in two or three hours of flight.

The author discusses the safety record of airships in light of the accidents with the Roma and the ZR2.

Unfortunately the problem of laying out an air route has been approached by all who give it consideration as one of the hardest tasks in the world. Whereas, as a matter of fact, a very serviceable air route can be laid out with an absolute minimum of ground work.

This report presents some studies of maritime aviation which cover the following principal points: employment of landplanes on maritime aerial warfare; their adaption to peculiar requirements of the Navy; and the establishment of a method of aerial pursuit and bombardment, likewise adapted to military aviation over land.

This article discusses the upcoming gliding meets in France and Germany in the summer of 1922. Restrictions of design, prize money, and new innovations are all discussed.

Given here is the most recent research on skin frictional resistance of plane surfaces in air that was conducted by Dr. Wieselsberger under the direction of Dr. Prandtl of Gottingen University. In all, 16 models were tested. These were divided into four groups, as follows: 1) cloth, in the original condition; 2) cloth, with the nap singed off; 3) cloth, with three coats of dope; and 4) cloth, with six coats of dope. Each group consisted of four models of uniform width, 1 meter, and of lengths of 0.5, 1.0, 1.5, and 2.0 meters.

"The study of the motion of perfect fluids is of paramount importance for the understanding of the chief phenomena occurring in the air surrounding an aircraft, and for the numerical determination of their effects. The author recently successfully employed some simple methods for the investigation of the flow of a perfect fluid that have never been mentioned in connection with aeronautical problems. These methods appeal particularly to the engineer who is untrained in performing laborious mathematical computations, as they do away with these and allow one to obtain many interesting results by the mere application of some general and well-known principles of mechanics" (p. 1-2).

"The laws of curvilinear motion are established and the transverse forces on elongated airship hulls along a curved path are investigated" (p. 1).

"The results of the two preceding notes are applied to airships and checked with wind tunnel tests" (p. 1).

Describes customary agreements and practices for renting dairy farms in various situations.

Report discussing 1) the pertinent information available on what electric furnaces can do to assist prospective users in selecting a furnace that fits their requirements and 2) the gradual evolution of the present commercial types of electric furnaces. Also discusses some of the fundamental principles in the design, construction, and operation of electric furnaces.

Report issued by the U.S. Bureau of Mines discussing studies conducted on the development of the oil-shale industry from a historical, technical, and economic perspective. Results of the studies are presented. This report includes tables, illustrations, and photographs.

Patent for the manufacture of Aluminum Chloride that can be carried out at lower temperatures with aluminum ore or compound, such as bauxite, sulfur and chlorine, and involves no cooking.

Patent for an automobile rim to make the mounting or demounting of a tire easier without any tools.