"A comparison is made of the structural efficiencies of truss webs of 24S-T aluminum alloy with previously published values of the structural efficiencies of diagonal-tension webs of 24S-T aluminum alloy on the basis of identical allowable stresses. It is concluded that the diagonal-tension beam (web and flanges) can usually be built to be a more efficient beam than the truss beam, even though over a small range the web of a Warren truss beam is slightly more efficient than the web of a diagonal-tension beam" (p. 1).

Report presenting an investigation to determine whether some characteristic of the boundary layer could be used to provide warning of the increase in stalling speed of a wing caused by ice formations on the leading edge. Results were analyzed by referring the total pressures at the rake to the free-stream total pressure, static pressure at the rake, free-stream static pressure, and static pressure from wind-tip swiveling head.

Report describes the installation of six-cylinder blocks from two in-line aircraft engines on CUE crankcases, which permits the separate operation of any cylinder as part of a single-cylinder test engine. Using multicylinder-engine blocks for single-cylinder tests is advantageous because there is greater availability of standard engine parts and there is less temperature gradient. Modifications of the crankcase, camshaft-drive mechanism, and operation of the cylinder are described.

Report describes the standard procedure that NACA used for evaluating the aileron characteristics of airplanes. The variables measured in the testing are rolling velocity, aileron positions, aileron stick forces or tangential wheel force, indicated airspeed, altitude, free-air temperature, and rudder position. The step-by-step flight procedure is described and information regarding evaluation of the control data and general suggestions is included.

"Tests described in this report were undertaken to obtain a quantitative measure of the pressure lag in typical pressure-tubing systems used by the Ames Aeronautical Laboratory in flight research investigations. Lag measurements were made with both single-direction and oscillating pressure changes. Single-direction pressure changes were investigated to determine if the lag in orifice-pressure lines and in the research airspeed and altitude measuring systems of pursuit-type airplane undergoing flight tests was sufficient to cause an appreciable error in the record of a sudden pressure change" (p. 1).

Report presenting an analysis of records of more than 134,000 flying hours, which have been received and evaluated in order to bring the V-G recorder data up to date. The analysis of the records is contained in the report. Results indicate that the maximum effective gust velocities for both the land transport airplanes and the flying boats have approached values of 40 feet per second.

Report presents tables and charts for the evaluation of profile drag from wake surveys at high supersonic speeds. Two methods of evaluation are presented: an exact method that can be used on a wake of any shape and a simple approximate method that can be used when the variation of total-pressure loss across the wave has a typical form.

Report discusses the maximum load, time to reach maximum load, and variation of load with time for prismatic floats in order to improve understanding of hydrodynamic theory for the landing impact of seaplane floats. Comparison of theoretical and experimental results and their applicability to flight impact are provided.