"A preliminary analysis has been made of the conditions of stability of free oscillations of a hinged rotor in hovering flight. The case analyzed is a rotor with hinges allowing freedom in flapping and lagging and having a completely reversible cyclic pitch-control system, so that a twisting moment on a blade moves the control stick without hindrance from spring or friction constraint. The principal results of this study are presented in the form of a stability chart" (p. 1).

Report discussing the effects of various inlet pressures, inlet temperatures, wheel speeds, pressure ratios, and cooling-air flows on the performance of a radial-flow exhaust-gas turbosupercharger turbine with a 12.75-inch tip diameter. Information about efficiency is provided for a given blade-to-jet speed ratio.

Results of flight tests of a control-feel aid presented. This device consisted of a spring and dashpot connected in series between the control stick and airplane structure. The device was tested in combination with an experimental elevator and bobweight which had given unsatisfactory dynamic stability and control-feel characteristics in previous tests. The control-feel aid effected marked improvement in both the control-feel characteristics and the control-feel dynamic longitudinal stability of the airplane.

Report discussing the icing characteristics of a rectangular-throat pressure-type carburetor. Serious ice was not found to form under the conditions of this particular test, although visible ice and frost formed in certain areas.

"In the course of an investigation to find a satisfactory vertical tail for the XP-62 airplane, a 0.45-scale vertical tail model on a stub fuselage was tested in the Langley 7- by 10-foot tunnel. This model was fitted with a flat plate to represent the horizontal tail surface. The data are presented herein for their general interest value rather than their application to this particular airplane" (p. 1).

"Flight tests of an A-26B airplane have been conducted to determine the changes in maximum speed, as affected by changes in carburetor ram and aerodynamic refinement of the nacelles, resulting from the addition of sealed spinners and modification of the charge air system, cowling, and nacelle afterbodies. The changes in nacelle drag resulting from these modifications were measured independently by means of a revolving wake survey rake behind the nacelle and boundary layer rakes on the cowling, and provide a quantitative check of the speed measurements as well as a means of analyzing the components of nacelle drag" (p. 1).

Availability data obtained on SNB-1 trainer-class airplanes were analyzed and results presented as flight envelopes which predict occurrences of large values of air speed and acceleration. Comparison is made with SNJ-4 trainer-class airplane data analyzed by the same method. It is concluded that flight envelopes are satisfactory; that the two types show large differences in flight loads and speeds experience; and that SNB-1 will seldom, if ever, exceed design limit load factor and restricted speed, which SNJ-4 can be expected to exceed design-limit load factor and restricted speed in a very small number of flight hours.

Report discussing testing on 22 inch-diameter pulse-jet engines to determine the effect on performance of a change in combustion-air temperature from approximately 80 degrees to 130 degrees. The effects on jet thrust, combustion-air flow, and engine thrust are described.