From Introduction: "This paper contains data on the mechanical properties of sand-cast test bars having a considerable range in zinc, magnesium, and copper content and more detailed data on the properties and foundry characteristics of an aluminum-zinc-magnesium-copper alloy having a preferred composition for high strength and ductility."

Report presenting an analytical study of the influence of full-span slotted and Fowler flaps on the requirements for horizontal tail surfaces. The elevator deflection required to land at three-point attitude, elevator deflection required to stall the airplane at altitude, and permissible center-of-gravity range have been calculated for a fighter-type airplane.

Report presenting a technique of testing wind tunnel powered models developed as a result of experience gained in the investigation of the static longitudinal and lateral staiblity and control characteristics of several powered models in the 7- by 10-foot wind tunnel. A discussion of the conditions to be investigated, methods of presenting and interpreting the data, and a suggested operating technique are given.

Report presenting the results of recent spin-tunnel tests on models of seven multiengine airplanes and compared with corresponding results for representative single-engine airplanes loaded along the fuselage. Multiengine airplanes were found to give steep spins with high rates of descent and high load factors.

Report presenting testing of cooling blowers for air-cooled engine installations and an exploration of the methods used in the blower design and operating characteristics of the blowers over a range of flight speeds and altitudes. The results indicate that the blowers operate as a more efficient type of propeller cuff and in many cases provide considerably more pressure boost than using a cuff.

Report presenting an investigation of a plain aileron and a balanced aileron on a tapered wing with full-span duplex flaps, which consisted of an inboard NACA slotted flap and an outboard balanced split flap. Increments of maximum lift coefficient of 0.82 and 1.04 were obtained from the inboard flap alone and from the duplex-flap combination.

Report presenting an investigation in the 7- by 10-foot wind tunnel of several arrangements of a plug-type spoiler-slot aileron on a tapered wing model of a typical fighter airplane with a full-span slotted flap. When the aileron is deflected, the plug projects from the upper surface of the wing as a spoiler and makes a slot appear behind the spoiler.

Report presenting an investigation in the 7- by 10-foot wind tunnel to determine the aerodynamic section characteristics of several arrangements of an NACA full-span high-lift lateral-control combination. The combination consists of a full-span flap of airfoil profile that retracts ahead of a narrow-chord full-span aileron. Results regarding coefficients, precision, plain airfoil, determination of optimum aileron-flap arrangement, section aerodynamic characteristics, and lateral-control characteristics are provided.

Report presenting force tests in two-dimensional flow in the 4- by 6-foot vertical tunnel of the characteristics of an NACA 0015 airfoil with a balanced flap having a chord of 30 percent of the airfoil chord, a flap-nose overhang 50 percent of the flap chord, and a tab having a chord 20 percent of the flap chord. Results regarding the precision and presentation of data, lift, hinge moment of flap, pitching moments, drag, tab characteristics, and balancing effectiveness of various overhangs are provided.

Report presenting an analysis of the probable aerodynamic section characteristics of a plain flap with various arrangements of internal balance. The results of the calculations previously obtained were found to be in agreement with the experiment. Some possible applications of the data to balancing tabs are also provided.

Report presenting force-test measurements in two-dimensional flow made in the 4- by 6-foot vertical tunnel of the characteristics of an NACA 0015 airfoil with a balanced flap with a chord 30 percent of the airfoil chord and a flap-nose overhang 35 percent of the flap chord. Results regarding lift, hinge moment of flap, pitching moment, drag, and tab characteristics are provided.

Report presenting testing of a mock-up of a pursuit airplane in the full-scale wind tunnel and the effects of propeller operation and flap deflection on the aerodynamic characteristics of the wing-fuselage combination and of the horizontal tail. The results indicate that with the flap deflected, the propeller-operating conditions cannot be directly determined from the propeller-removed lift coefficient.

Report presenting a survey of aircraft heat exchangers in three parts: design, selection, and installation. Appendices give the physical properties of air, properties of standard atmosphere as defined by the Navy, Army, and NACA, and an impact-pressure chart.

Report presenting determination of air-flow quantity in front of and behind three orifice plates to determine the errors introduced in the quantity measurements by the turbulence behind the orifice plates. For the orifice plates tested, the results showed that the measurements must be taken 40 to 60 hole diameters downstream from the plates to ensure accuracy.

Report presenting tests conducted with an air-cooled aircraft-engine cylinder to determine the effect on the knocking tendency of cutting out one spark plug when the engine is operating at or near the knock point with two spark plugs firing. The results indicate that cutting out one spark plug will not lead to knock but will actually stop or decrease knock that is occurring with both spark plugs firing.

Report presenting tests of the flow of air through brass tubes with the friction coefficient and incompressible flow relation as the main focus. The analytical relation between friction coefficient, tube length, and Mach number is shown for flow without shock and the conditions for flow with and without shock are delimited.

Report presenting a method for obtaining exact potential-flow patterns in a compressible fluid. The method is based on a complex-function theory developed for the solutions of the simultaneous first-order partial differential equations in the hodograph variables.

Report presenting a direct comparison between the observed and the calculated longitudinal dynamic stability of a particular dynamic model of a flying boat moving on the water. Good agreement was obtained between experiment and theory for trim angles in the vicinity of lower limit, at one speed a little above the hump.

"The results are given of an investigation of some of the limitations that now prevent increases in the temperature level of engine cylinder heads, and a review of previous work in the field is included to supplement these results. Attention was given, in particular, to the effects of fuel knock and surface ignition on cylinder temperatures and the effects of cylinder temperatures on performance. Data were obtained from a Wright C9GC air-cooled cylinder and from a Lycoming O-1230 liquid-cooled cylinder" (p. 1).

Report discusses the results of yawing tests on a model of the complete hull of the XPB2M-1. The tests indicated that there was a tendency toward directional instability in the vicinity of the hump. The researchers concluded that at a certain range, the curves of yawing moment are discontinuous, and this has led to difficulty in preliminary test flights.

"Vibrations of rotary-wing aircraft may derive their energy from the rotation of the rotor rather than from the air forces. A theoretical analysis of these vibrations is described and methods for its application are explained herein" (p. 1). Information about self-excited speed range and shaft-critical speed are provided for any rotor with more than two blades.

Report presenting wind tunnel testing of four full-scale seaplane floats to determine the aerodynamic characteristics of the floats and to evaluate several drag-reducing refinements. Four floats were investigated; two differed only in external details like flush rivets, while one was the type used on twin-float installations. The variation of lift, drag, and pitching moment with pitch angle are presented for each float.

Report presenting data from tests conducted on full-scale propellers with 3155 blade design, which have been used to construct a set of propeller thrust charts for use in the calculation of take-off performance. By using the charts, the thrust of modern single- and dual-rotating propellers may be easily and rapidly calculated through the entire take-off range.

From Introduction: "Certain alternations of a qualitative nature may be performed in spite of the fact that a pressure change cannot be prescribed. It is the purpose of this paper to indicate a method by which qualitative alternation may be performed. It will be noted that the present method of contour modification will serve the intended purpose of the inverse method."