"Increments in structural loads due to atmospheric turbulence can be accurately expressed in terms of flight speed and effective gust velocities (reference 4). Data from which the effective gust velocities could be computed were also obtained during the flights of the XC-35 airplane. These data have been used to determine the significance of the fluctuations in the pilot's indicated-airspeed readings in relation to structural loads to due to atmospheric turbulence" (p. 3).

From Summary: "The independent variables considered in the analysis included stress-concentration factor, stress-load relation, wing loading, design and cruising speeds, design gust velocity, and airplane size. Several methods for estimating fatigue life from gust frequencies are discussed."

Report presenting column and plate compressive strengths of extruded 24S-T aluminum alloy determined both within and beyond the elastic range from tests of thin-strip columns and local-instability tests of H-, Z-, and channel-section columns. The tests are part of a research investigation to provide data on the structural strength of various aircraft materials. Results regarding compressive stress-strain curves and column and plate compressive strengths are provided.

Column and plate compressive strengths of extruded 24S-T aluminum alloy were determined both within and beyond the elastic range from tests of thin-strip columns and local-instability tests of H-, Z-,and channel-section columns. These tests are part of an extensive research investigation to provide data on the' structural strength of various aircraft materials. The results are presented in the form of curves and charts that are suitable for use in the design and analysis of aircraft structures.

Report presenting column and plate compressive strengths of extruded 75S-T aluminum alloy both within and beyond the elastic range from tests of thin-strip columns and local-instability tests of H-, Z-, and channel-section columns. The tests are part of an extensive research investigation to provide data on the structural strength of various aircraft materials. Results regarding compressive stress-strain curves and column and plate compressive strengths are provided.

Report presenting a comparison of two flight-test procedures for the determination of the aileron control capabilities of an airplane. The procedures consist of performing rudder-fixed aileron rolls from straight unbanked flight and from steady turning flight. Results regarding rate of roll comparison and sideslip-angle comparison are provided.

"Tests were made of a model representative of a single-engine tractor-type airplane for the purpose of determining the stability and control effects of a propeller used as an aerodynamic brake. The tests were made with single-and dual-rotation propellers to show the effect of type of propeller rotation, and with positive thrust to provide basic data with which to compare the effects of negative thrust. Four configurations of the model were used to give the effects of tilting the propeller thrust axis down 5 deg., raising the horizontal tail, and combining both tilt and raised tail" (p. 1).

An investigation to determine the feasibility of measuring surface contours with an aerial-mapping contour finder on stereoscopic electronic micrographs of replicas of metal surfaces. Results regarding the measurement of stereoscopic electron micrographs, measurement of surface contours, possible sources of low stereographic values, and limitations on stereoscopic-contour measurements are provided.

Report discusses the results of bending tests on an open box beam designed to fail on the highly cambered tension side. Results in the elastic range and ultimate-strength test are provided. The stringer stresses near the root were in fair agreement with stresses calculated by shear-lag theory and the ultimate tensile strength developed by the beam was only a little higher than the tensile yield stress of the material.