Report presenting an investigation using rocket-propelled model of the Convair B-58 supersonic bomber. Drag at trim lift was obtained for a range of Mach and Reynolds numbers and is compared to data from several other testing facilities.

Report presenting the results of tests to determine the effect of taper on the zero-lift drag of wings of constant exposed aspect ratio at low supersonic speeds. Findings indicated that maximum thickness, leading-edge, and trailing-edge sweep are all important in determining the drag coefficient of a tapered wing.

"An investigation is being conducted in the Langley 20-foot free-spinning tunnel on a 1/24-scale model of the Grumman F11F-1 airplane to determine spin and recovery characteristics and the minimum-size parachute required to satisfactorily terminate the spin in an emergency. Results obtained to date are presented herein. Test results indicate that it may be difficult to obtain an erect or inverted spin on the airplane, but, if a spin is obtained, the spin will be very oscillatory and recovery from the developed erect spin by rudder reversal may not be possible" (p. 1).

From Summary: "The performance of an annular combustion chamber from a 24C turbojet engine was investigated over a range of simulated altitudes from 20,000 to 55,000 feet and corrected engine rotor speeds from 6000 to 13,000 rpm at a simulated ram-pressure ratio of 1.04. The purpose of the investigation was to determine the effects on the altitude operational limits, combustor-outlet gas temperature distribution, combustion efficiencies, and combustor inlet-to-outlet total-pressure drops of two changes in the 24C-4B basket air-passage arrangements that were designed to improve combustor-outlet temperature distribution. These changes were: (a) replacement of the downstream secondary air holes with large rectangular slots further upstream (rectangular-slot basket), and (b) enlargement of anticoking holes in the rectangular-slot basket (modified rectangular-slot basket)."

"An investigation was made of a 1/25-scale dynamically similar model of a 255,000-pound transport airplane in order to study its behavior when ditched. The model was free-launched from the Langley tank no. 2 monorail carriage into calm water. Various landing attitudes, flap settings, speeds, and configurations were investigated" (p. 1).

Report presenting tables and charts of gas properties for use in thermodynamic calculations for engine cycles involving the combustion of air and any fuel or combustion of fuels containing carbon, boron, hydrogen, and oxygen. Dissociation and phase changes may be accounted for with the method presented, which does not require the presentation of separate data for each fuel-air ratio.

Report presenting an investigation to determine the aerodynamic characteristics of bodies with elliptical and triangular cross sections and to compare the data with a body with circular cross sections. Force tests to determine lift, drag, and pitching-moment characteristics as well as pressure-distribution measurements were made for an angle of attack range.

The thermal decomposition of ethylpentaborane at temperatures of 185 degrees to 244 degrees C is approximately a 1.5-order reaction. The products of the decomposition were hydrogen, methane, a nonvolatile boron hydride, and traces of decaborane. Measurements of the rate of decomposition of pentaborane showed that ethylpentaborane has a greater rate of decomposition than pentaborane.

Report presenting the average heat-transfer to the forward half of a circular cylinder measured in a blowdown jet at a stream Mach number of 4.15. Most of the tests was made at a wall-to-stagnation temperature ratio of about 0.8. Report presenting pressure distributions, heat transfer and recovery temperatures, and effect of yaw on transition are provided.

Memorandum presenting an investigation utilizing a 1/15-scale rocket-propelled model of the Convair B-58 supersonic bomber. The drag at model trim lift was obtained at a range of Mach and Reynolds numbers. A comparison of the drag at transonic speeds and approximately the same Reynolds number showed excellent agreement.

Memorandum presenting an investigation made to determine the effects of lip bluntness, camber, and leading-edge roundness on the drag and pressure recovery of a normal-shock nose inlet in a body of revolution. Surface pressure distributions over the inlet lip and forebody were also obtained. Results regarding surface-pressure distributions, external drag, and pressure recovery are provided.