From Introduction: "This report presents the results of these tests which cover a total of about 70 flying hours on this airplane."

From Introduction: "The tests described in this report are the first in an investigation by N.A.C.A. of the aerodynamic characteristics of possible tailless arrangements. The investigations will be extended to include whatever range is through most desirable and may include, among other things, variations in aspect ratio, taper, sweepback, washout, air-foil section, dihedral, and also control flaps or other control devices of different forms and proportions."

This report is a revision of NACA-TR-357. It was prepared by the Committee on Aircraft Accidents. The purpose of this report is to provide a basis for the classification and comparison of aircraft accidents, both civil and military.

From Summary: "A theory is developed for the airfoil of finite span at supersonic speed analogous to the Prandtl airfoil theory of 1918-1919 for incompressible flow. In addition to the profile and induced drags, account must be taken at supersonic flow of still another drag, namely, the wave drag, which is independent of the wing aspect ratio. Both wave and induced drags are proportional to the square of the lift and depend on the Mach number, that is, the ratio of flight to sound speed. In general, in the case of supersonic flow, the drag-lift ratio is considerably less favorable than is the case for incompressible flow."

Brief summary of the physical characteristics, general habits, breeding habits, food habits, migratory habits, and habitat of the Alaska-Yukon caribou.

The problem of autorotation has been attacked by various authors, in particular Fuchs and Schmidt who applied the so-called strip method which is based upon the assumption that the forces and moments per unit length acting in each section of the wing are equal to those on an infinite cylindrical wing of equal section in an air flow of intensity and direction resulting from the apparent relative motion of this section with respect to the surrounding air. In other words they disregarded the induced velocities, which, however, are of such importance that their omission is bound to result in appreciable errors, as we attempt to prove in this report.

"A quantitative criterion of merit has been needed to assist airplane designers to incorporate satisfactory spinning characteristics into new designs. An approximate empirical criterion, based on the projected side area and the mass distribution of the airplane, has been formulated in a recent British report. In the present paper, the British results have been analyzed and applied to American designs. A simpler design criterion based solely on the type and the dimensions of the tail, has been developed: it is useful in a rapid estimation of whether a new design is likely to comply with the minimum requirements for safety in spinning" (p. 1).

"An approximate empirical criterion, based on the projected side area and the mass distribution of the airplane, was formulated. The British results were analyzed and applied to American designs. A simpler design criterion, based solely on the type and the dimensions of the tail, was developed; it is useful in a rapid estimation of whether a new design is likely to comply with the minimum requirements for safety in spinning" (p. 1).

Circular presenting a description of the Avro Trainer airplane, which is primarily intended for pilots in training and is designed to be easy to use, including large, comfortable cockpits, good view, effective windshields, and wide track. Details of the design, flight characteristics, drawings, and photographs are provided.

This report presents test results obtained during an investigation of the performance of a single-cylinder, high-speed, compression-ignition test engine when using multiple-orifice fuel-injection valve nozzles in which the number and the direction of the orifices were varied independently.

Circular presenting a description of the Baynes Bee, which is a light two-seat high-wing monoplane. Details of its unique qualities, design, components, flying qualities, drawings, and photographs are provided.

"Memorandum presenting the development of a static pressure head for high speeds. These tests proved the practicability of static pressure heads at speeds up to 400 km/h (248.5 mph). It weighs 6.5 kg or 2.5 times as much as the old head. The position of the pressure head below the airplane was determined by bearing method at different speeds and for different lengths of suspension" (p. 1).

Progressive application of the Kutta-Joukowsky theorem to the relationship between airfoil lift and circulation affords a number of formulas concerning the conduct of vortex systems. The application of this line of reasoning to several problems of airfoil theory yields an insight into many hitherto little observed relations. This report is confined to plane flow, hence all vortex filaments are straight and mutually parallel (perpendicular to the plane of flow).

"The paper beings with a brief discussion on the origin of the bending stresses in cantilever box beams under torsion. A critical survey of existing theory is followed by a summary of design formulas; this summary is based on the most complete solution published but omits all refinements considered unnecessary at the present state of development. Strain-gage tests made by NACA to obtained some experimental verification of the formulas are described next. Finally, the formulas are applied to a series of box beams previously static-tested by the U.S. Army Air Corps; the results show that the bending stresses due to torsion are responsible to a large extent for the free-edge type of failure frequently experienced in these tests" (p. 1).

Circular presenting a description of the Bernard 82, which is a scaled-up version of the 80 G.R.; they have similar designs but the 82 has greater span and wing area, deeper chord, higher fuselage, and a thicker wing for the bombs. A description of some flight tests and characteristics is also provided.

Describes the process of deboning lamb meat.

Bulletin discussing

Present designs for large flying boats are characterized by high wing loading, high aspect ratio, and low parasite drag. The high wing loading results in the universal use of flaps for reducing the takeoff and landing speeds. These factors have an effect on takeoff performance and influence to a certain extent the design of the hull. An investigation was made of the influence of various factors and design parameters on the takeoff performance of a hypothetical large flying boat by means of takeoff calculations.

"Thin-walled shells with strong longitudinal and transverse stiffening (for example, stressed-skin fuselages and wings) may, under certain simplifying assumptions, be treated as static systems with finite redundancies. In this report the underlying basis for this method of treatment of the problem is presented and a computation procedure for stiffened cylindrical shells with curved sheet panels indicated. A detailed discussion of the force distribution due to applied concentrated forces is given, and the discussion illustrated by numerical examples which refer to an experimentally determined circular cylindrical shell" (p. 1).

"Tests on a Friez type cup anemometer have been made in the variable density wind tunnel of the Langley Memorial Aeronautical Laboratory to calibrate the instrument and to determine its suitability for velocity measurements of wind gusts. The instrument was calibrated against a Pitot-static tube placed directly above the anemometer at air densities corresponding to sea level, and to an altitude of approximately 6000 feet. Air-speed acceleration tests were made to determine the lag in the instrument reading. The calibration results indicate that there should be an altitude correction. It is concluded that the cup anemometer is too sluggish for velocity measurements of wind gusts" (p. 1).

This investigation is part of an extensive experimental study that has been carried out at full scale in the NACA 20-foot tunnel, the purpose of which has been to furnish information in regard to the functioning of the propeller-cowling-nacelle unit under all conditions of take-off, climbing, and normal flight. This report presents the results of tests of six propellers in the normal and high-speed flight range and also includes a study of the take-off characteristics.

Circular describing the Cierva Autogiro Mark III. Details of the constructional features, characteristics, drawings, and photographs are provided.

Report issued by the U.S. Bureau of Mines on the coal mine related deaths that occurred during the month of May, 1931. The number of fatalities and their causes are presented. This report includes tables and graphs.

This report covers an investigation of the application of the theory of dynamic longitudinal stability, based on the assumption of small oscillations, to oscillations an airplane is likely to undergo in flight. The investigation was conducted with a small parasol monoplane for the fixed-stick condition. The period and damping of longitudinal oscillations were determined by direct measurements of oscillations in flight and also by calculation in which the factors that enter the theoretical stability equation were determined in flight. A comparison of the above-mentioned characteristics obtained by these two methods indicates that the theory is applicable to the conditions encountered in flight.