"This report presents results of a research and engineering program performed during the first half of 1950 that resulted in an acoustical treatment for the 8- by 6-foot supersonic wind tunnel at the Lewis Flight Propulsion Laboratory" (p. 1).

This report provides the results to an airborne radiometric reconnaissance made in central Montana, the Sweetgrass Hills and Arch area, and Clancy area of the Boulder batholith that was completed in October 1953. This report is divided into three parts, each area is discussed separately according to its geology, the airborne procedures employed, and the conclusions reached.

From Summary: "An investigation was conducted in an altitude test chamber at the NACA Lewis laboratory to determine the effect of a revision of the rated engine operating conditions and modifications to the afterburner fuel system, flameholder, and shell cooling on the augmented performance of the J71-A-2 (x-29) turbo jet engine operating at altitude . The afterburner modifications were made by the manufacturer to improve the endurance at sea-level, high-pressure conditions and to reduce the afterburner shell temperatures. The engine operating conditions of rated rotational speed and turbine-outlet gas temperature were increased. Data were obtained at conditions simulating flight at a Mach number of 0.9 and at altitudes from 40,000 to 60,000 feet."

From introduction: This is Progress report BMI-282, the first of a series covering the operation of the pressure-leaching towers for the extraction of uranium by an ammonium carbonate leach...This report discusses the data obtained from tests run to show the effects of such variables as the amount of air and carbon dioxide passed through the pulp, temperature, pressure, and concentration of ammonium carbonate and ammonium bicarbonate in the leach solution on the extraction of uranium.

From Summary: "The effects of variation in inlet-air temperature, combustion pressure, and boron or pentaborane concentration on combustion performance were discussed. It was shown how the theoretical data herein could be employed in obtaining the combustion efficiency of experimental combustors. Data were presented by which combustion efficiencies obtained with a water-quench heat balance could be adjusted for the heat of dissociation of the combustion products."

Report issued by the Brookhaven National Laboratory discussing the area survey manual covering the 15 service stations. Design and operations of the service stations are presented. This report includes tables, illustrations, photographs, and a map.

From abstract: "Optical spectra of six beta-diketones and their cupric chelates are presented and discussed in relation to the structures of the molecules."

Report presenting the use of the shock-expansion method for the calculation of the pressure distribution on cylindrical wings in supersonic flow as extended to tapered wings made up of single-curved surfaces. The method applies in regions of the wing where the component of velocity normal to the surface rulings is supersonic and the flow is not influenced by the presence of the root or tip.

This report covers the progress made on an intensive program to develop and evaluate UO2 as a possible fuel element for the PWR.

Continued work on the adsorbability of metal complexes from concentrated LiCl solutions and LiCl-HCl mixtures on a strong-base anion-exchange resin further demonstrated the much higher adsorbability of these complexes from LiCl solutions than from HCl solutions. The effect is believed to be due to the formation of less strongly adsorbed undissociated chloro-complex acids in the case of the HCl solutions.

Memorandum presenting an assessment of the importance of the addition lag of the monowing versus a cruciform shape on a missile.

Report presenting a study to compare the maneuvering performance of a cruciform and a monowing missile. Results regarding beam riding and minimum launch range at 5000 and 50,000 feet are provided.

Abstract: "This report describes a flame photometric system which continuously monitors a process water stream for ppm quantities of alkali metals, and automatically diverts the stream when the contamination exceeds a pre-determined level."

Note presenting a description of equipment and test technique used in the creep testing of lap joints. Riveted aluminum-alloy joints fabricated from 75S-T6 and 24S-T3 sheet with 24S and 24S-T31 rivets were tested at 300, 400, and 500 degrees Fahrenheit. The test results showed that the creep of the riveted joints is considerably greater than the creep of the unriveted sheet although not so large that the creep of the sheet is negligible compared with that of the joints.

From introduction: "A study of the decay schemes of a considerable number of nuclei in the heavy-element region has been undertaken in the hope that a more detailed knowledge of the energy levels involved will lead to a better understanding of their nature and therefore of the nucleus itself."

During this period a prototype gamma ray detection system was assembled and data was obtained on samples of beryllium salts on filter paper under a variety of conditions. Ordinarily either a scaler-register combination or the CRM-recorder combination would be sufficient for obtaining data. Both units have been used here in order to utilize the particular advantages of each system. The scaler-register unit was employed for obtaining precise data over short intervals while the CRM-recorder was used to maintain a check on stability over longer intervals of time.

Thorium is determined in uranium alloys by means of a fluoride separation followed by a complexometric titration. A nitric of hydrochloric acid solution of the alloy is neutralized to a pH of 2.0 to 3.0 and the thorium precipitated as thorium fluoride by the addition of hydrofluoric acid and ammonium fluoride using lanthanum as a carrier.

Technical report describing a brief survey of the problems concerned with radioactive waste disposal.

This report is based on work done by the US Geological Survey on behalf of the Division of Raw Materials of the US Atomic Energy Commission.

Fused uranium dioxide was separated into fractions of varying particle size by air separation. Specimens of the nominal size of 1/8 by 1/4 by 1½ in. were formed by hydrostatic pressing, firing, and lapping. Specimens prepared from the 0 to 5 μ fraction were the strongest and most dense. The room-temperature density was about 92% of theoretical and the room-temperature flexural strength was about 12,000 1b. per sq. in. When tested at 1000°C., the strength was about 18,000 1b. per sq. in. The flexural strength of specimens decreased and their density decreased as the starting particle size was increased. The crystallization of the urania fragments which had occurred during the firing treatment was observed.

Report presenting measurements of lift made on various rectangular-plan-form wings differing in trailing-edge thickness, profile shape, maximum thickness ratio, and aspect ratio. Experiments were conducted at a range of Mach numbers, Reynolds numbers, and wings with and without boundary-layer trips. Results regarding a comparison of experimental results with theory at moderate supersonic Mach numbers and calculations for hypersonic Mach numbers are provided.

This technical report represents a brief survey of work by this project on the effects of ultraviolet radiation (UV) on certain of the photochemical and metabolic properties of rhubarb chard and sugar beet (Beta vulgaris). These plants were selected for this work because for some years they have been used as sources of chloroplasts for Hill reaction studies in this laboratory. Some of this work has appeared as a brief paper.

"The flow-field characteristics around a swept-wing airplane model at low subsonic speed are described, and the loads induced on a typical missile model while operating within these flow fields are presented. In addition, theoretical flow fields are compared with experiment and are used in first-order estimations of the resulting induced missile loads" (p. 1).

The ORNL 86-in. cyclotron is being modified to provide for deflection of the proton beam. It is expected that operation will be resumed late in the spring. Nuclear physics work was limited, for the most part, to interpretation of previously collected data and to making preparations for utilizing the deflected beam. It was found that for certain isotopes the production rates could be almost doubled by operating at a slightly reduced energy and a much larger current. With the use of the ORNL 63-in. cyclotron, the absolute values of the electron capture and loss cross sections for 26-Mev nitrogen ions were obtained. The angular distribution of the cross sections for elastic scattering of nitrogen by nitrogen was measured at energies from 13 to 22 Mev. A double-focusing 90-deg magnet is being planned for use in identifying stable reaction products from nitrogen-induced reactions. The major components of the revised 44-in. test cyclotron were assembled and are being tested. Consideration is being given to the use of these components, along with a new 20,000-oersted magnet and a shielded cyclotron room, and if the tests are satisfactory the Laboratory will have available a machine which will accelerate N5+ ions to 81 Mev.