"An investigation has been made at large scale of the characteristics of highly swept wings. Data were obtained at several angles of sideslip on wings having angles of sweep of plus or minus 45 degrees, plus or minus 30 degrees, and 0 degrees. The airfoil sections of the wings varied from approximately NACA 0015 at the root to NACA 23009 at the tip. Each wing was investigated with flaps under flection, partial-span split flaps deflected 60 degrees, full-span split flaps defected 60 degrees and split-flap-type ailerons deflected plus or minus 15 degrees" (p. 1).

Report presenting an investigation of the distribution of pressure at zero lift over the surface of a swept airfoil of biconvex section. The measured pressures are compare with theoretical values calculated from thin-airfoil theory. Results regarding pressure distributions, drag, and boundary-layer studies are provided.

Report presenting an investigation of a family of turbine-rotor-blade designs based on one-dimensional-flow theory and incorporating systematic changes in design variables. They were designed for 40-percent reaction and a total-to-static pressure ratio of 4.00 based on the assumption of constant static pressure along the radius and one-dimensional-flow theory for the design of the rotor-blade passages.

Wind-tunnel investigations were made in pitch and yaw with and without split flaps. Presence of the fuselage had negligible effect on values of maximum lift coefficient and slope of lift curve, but caused a destabilizing shift in the rate of change of pitching moment with lift. Effects of fuselage position on drag characteristics were small for wings without flaps, but were appreciable when split flaps were on.

"An investigation of the spin and recovery characteristics of a 1/24-scale model of the Grumman XF9F-2 airplane with wing-tip tanks installed has been conducted-in the Langley 20-foot free-spinning tunnel. The effects of control settings and movements on the erect spin and recovery characteristics of the model for a range of possible loadings of the tip tanks were determined. Spin and recovery characteristics without tanks were determined in a previous investigation" (p. 1).

"Wind-tunnel tests of a full-scale model of the Republic XP-91 airplane were conducted to determine the longitudinal and lateral characteristics of the wing alone and the wing-fuselage combination, the characteristics of the aileron, and the damping in roll of the wing alone. Various high-lift devices were investigated including trailing-edge split flaps and partial- and full-span leading-edge slats and Krueger-type nose flaps. Results of this investigation showed that a very significant gain in maximum lift could be achieved through use of the proper leading-edge device" (p. 1).