Report details the development of design equations for double-panel, air-heated windshields with ice prevention properties. The application of the equations and suggestions for experimental flight testing are described.

Report summarizes the available hinge-moment data for unshielded horn-balanced control surfaces. The purpose is to correlate the available data to assist with estimating the balance characteristics for use in the design and alteration of control surfaces with horn balances. Plan forms and variation of incremental hinge-moment-coefficient slopes with balance coefficients are presented.

"Formulas for the calculation of hinge-moment characteristics of an elevator with a spring tab have been developed in terms of basic aerodynamic parameters, spring stiffness, and airspeed. The formulas have been used in a study of the stick-force gradients on a pursuit airplane equipped with an elevator with a spring tab. Charts are presented showing the variation of stick-force gradient in accelerated flight over a large range of speed and the complete range of spring stiffness for various center-of-gravity locations, altitudes, and airplane sizes" (p. 1).

Analysis was made to determine characteristics required of a balancing-tab system for ailerons in order to reduce aileron stick forces to any desired magnitude. Series of calculations based on section data were made to determine balancing-tab systems of various chord tabs and ailerons that will give, for a particular airplane, zero rate of aileron hinge moment with aileron deflection and yet will produce same maximum rate of roll as a plain unbalanced 15-percent chord aileron of same span. Effects of rolling velocity and of forces in tab link on aileron hinge moments have been included.

Bulletin presenting the results of an investigation to determine possible improvements in the tightness and the flushness of machine-countersunk rivets. Specimens used in the study were simple lap joints made by different riveting methods. The results indicate that a comparison of the quality of machine-countersunk riveted joints on the basis of maximum load alone is not justified.

"Tests were run on a single-cylinder, air-cooled engine with a Wright C9GC cylinder to determine the improvement in cylinder-head cooling that can be obtained by building into the exhaust passage an insulating shield designed to protect the valve-guide boss and the exhaust-passage walls from the exhaust gas. The test results showed an appreciable improvement in cooling of the exhaust-valve-guide boss, of the guide bushing, and of the valve seat" (p. 1).

Report discusses data obtained from testing shear of joints riveted with round-head and brazier-head rivets. The tightness of the rivets is also compared for one value of rivet diameter. The load-displacement curves and comparison of load at various values of permanent displacement are presented for both types of rivets.

Report discusses the results of an investigation to compare the discharge characteristics of an alcohol feed ring and a standard alcohol discharge nozzle when utilized to supply anti-icing alcohol to the propeller-blade feed shoes on a Curtiss-Wright C-46 cargo airplane. The equipment used, testing practices, and results of the alcohol flow distribution are described.

Bulletin presenting a discussion of information as to the influence on spins and spin recovery of the wing loading and load distribution of present-day pursuit airplanes. The high wing loadings results in high rates of descent and large control forces for recovery.

"Typical thrust and torque coefficients and increments, due to the propeller, in the ratio of the dynamic pressure at the tail to the free-stream dynamic pressure are presented for 10 full-scale airplanes. Calculations indicate that an error of about 2 percent mean aerodynamic chord appears possible in determining the neutral point from wind-tunnel tests or a model in the gliding condition if the propeller is operated at zero thrust rather than at the values of thrust coefficient indicated by the flight tests" (p. 1).

Report presenting an exploration of fatigue stresses of some wrought aluminum alloys, including charts that cover different ranges of stress and number of cycles.

Report discusses the results of testing on "10-inch shear panels of 24S-T aluminum alloy with 1.5 inch holes to determine the stress concentration at static rupture and the deformation characteristics" (from Summary). The strength of the perforated specimens is compared to the solid specimens and the critical stresses are computed. The stress at which permanent set occurs was also measured.