"The results of the first flight test of a swept-back four-wing version of Tiamat (MX-570 model C) which was launched at the NACA Pilotless Aircraft Research Station at W4110PB Island, Va. are presented. In general, the flight behavior was close to that predicted by calculations based an stability theory and oscillating table tests of the autopilot. The flight test thus indicates that the techniques employed to predict automatic stability are valid and practical from an operational viewpoint" (p. 1).

From Summary: "Estimates of the static stick-fixed stability and control characteristics of the Consolidated Vultee model 240 airplane are presented in this report. The estimates are based on tests of a 0.092-scale powered model in the 10-foot wind tunnel of the Guggenheim Aeronautical Laboratory of the California Institute of Technology. Results of the analysis are evaluated in terms of the Army specifications for stability and control characteristics which are more specific and, in general, equal to or more rigid than the Civil Aeronautics Administration requirements."

The present report contains three-component forces and mass-flow measurements on a jet nacelle at small inlet-velocity ratios v(sub A)/v(sub o) < 1. The mass-flow measurement on two cross sections of the nacelle demonstrate the local-velocity distribution with varying flow and angle of attack.

The crystal structures of alloys 61, X-40,X-50, 422-19, 6059, and Vitallium, derived from x-ray diffraction, are discussed. The alloys have been, or are being considered for use in gas turbine applications. The predominant phase was a solid solution of the face centered cubic type of the principal constituent elements.The lattice parameters were found to be between 3.5525 and 3.5662.

The Russian AM 35 and AM 38 aircraft engines have superchargers with a swirl throttle, which appears to be a purely Russian development. This paper gives the results of test runs of the two engines, including the effects of the swirl throttle on engine performance.

"The NACA 23012-4 airfoil was investigated for the purpose of increasing lift by means of blowing out air from the wing, in conjunction with the effect of plain flap of variable contour and slotted flap of 25 percent chord length. The wing also was provided with a hinged nose, to be deflected at will. Air was blown out from the wing immediately in front of the flap; also at the opening between wing and hinged nose,tangentially to the surface of the wing" (p. 1).

This paper gives an overview of equations for vibration and flutter affecting airplane wings in nonstationary flow.

"The probable spin and recovery characteristics of the XSN2J-1 air-plane have been estimated on the basis of the results of brief test a performed on a model of an airplane of somewhat similar design. The spin-recovery tail-parachute requirements for the airplane were also determined end, in addition, an analysis was made to determine the best method of emergency pilot escape during a spin. The results of the investigation indicate that the recovery characteristics of the airplane will be satisfactory for all probable loading conditions of the airplane" (p. 1).

"The report UM No. 1023/1 which presented the results of measurements for a series of trapezoidal wings was the beginning of a series on wings with aspect ratio 1 to 3 and various contours. In report No. 1023/1 the aspect ratio (Lambda = 4/3) remained the same; the tapering was modified. The present report gives the results of the series of elliptic wings. Here the aspect ratio varies from 1 to 2 with the sweepback. The contour is formed by elliptic arcs. The influence of sweepback and contour upon the neutral point is shown" (p. 1).

The characteristics of the position and form of the transition surface through the critical velocity are computed for flow through flat and round nozzles from subsonic to supersonic velocity. Corresponding considerations were carried out for the flow about profiles in the vicinity of sonic velocity.

"It is known that compression shocks which lead from supersonic to subsonic velocity cause the flow to separate on impact on a rigid wall. Such shocks appear at bodies with circular symmetry or wing profiles on locally exceeding sonic velocity, and in Laval nozzles with too high a back pressure. The form of the compression shocks observed therein is investigated" (p. 1).

Report presenting an investigation in the 18- by 18-inch supersonic tunnel to determine design conditions for optimum performance of shock diffusers at Mach number 1.85 with a series of projecting single-shock cones with varying angles. Each cone was tested with a curved and a straight diffuser-inlet section. The effect of angle of attack was investigated for several configurations.

Wind-tunnel investigations were made in pitch and yaw with and without split flaps. Presence of the fuselage had negligible effect on values of maximum lift coefficient and slope of lift curve, but caused a destabilizing shift in the rate of change of pitching moment with lift. Effects of fuselage position on drag characteristics were small for wings without flaps, but were appreciable when split flaps were on.

In accord with me test program (published in reference 7) the wing in question is briefly designated as No. 5. It differs from the rectangular wing discussed in reference 7 by its taper and from the 35 degree swept-back trapezoidal wing treated in reference 8 by the absence of sweepback.

Report presenting a method of predicting the dynamic response of airplane wings to gusts by considering only the fundamental mode of bending along with the results of model tests to evaluate the method. Results regarding experimental results and associated calculations, limitations of calculations, and results calculated for effect of change of certain parameters are provided.

"Requirements of an automatic engine control, as affected by engine characteristics, have been analyzed for a direct-coupled turbojet engine. Control parameters for various conditions of engine operation are discussed. A hypothetical engine control is presented to illustrate the use of these parameters. An adjustable speed governor was found to offer a desirable method of over-all engine control. The selection of a minimum value of fuel flow was found to offer a means of preventing unstable burner operation during steady-state operation" (p. 1).

Tests were made in the Langley 7- by 10-foot tunnel on a 0.182-scale model of an F4U-1 airplane with external stores. This paper is concerned mainly with presenting the data obtained in this investigation and with a comparison of some of these data with flight-test results determining the feasibility of estimating flight buffet Mach number from tunnel data. The results of this investigation indicate that the incremental drag coefficient due to external stores may be used to estimate the maximum Mach number that the F4U-1 airplane may reach in flight when it is equipped with external stores. This estimation is conservative for the five configurations investigated by mounts varying from 0 to 10 percent of the flight limit Mach number. The free-stream tunnel Mach number corresponding to sonic flow over the lower surface of the wing in the region of the store is a good indication of the lower limit of buffet in flight of the F4U-1 airplane when equipped with external stores. The fluctuations of total pressure over the horizontal tail are not sufficiently large (maximum of 1 percent q(sub o) to cause buffeting of the airplane.

"There are investigated the problems of the flow of a supersonic jet out of a vessel with plane side walls and the problem of the supersonic flow about a wedge when there is a zone of local subsonic velocities ahead of the wedge" (p. 1).

An analysis has been made of airfoil data taken on several NACA 16-series propeller airfoils from tests of 5-inch-chord models in the Langley 24 inch high-speed tunnel and l2-inch-chord models in the Langley 8 foot high-speed tunnel, This analysis has shown that the combined effects of Reynolds number changes and variations in airfoil characteristics resulting from differences in models and tunnels are such that when 5 inch-chord and l2-inch-chord data are applied to full-scale propeller design at or near the design condition, differences of less than 1 percent in efficiency will be involved.

"Some aerodynamic relations are derived which exist between two infinitely long airfoils if one is in a straight flow and the other in oblique flow, and both present the same profile in the direction of flow" (p. 1).

"An investigation was made in the Langley two-dimensional low-turbulence tunnel on a wing section for the XB-36 airplane equipped with a double slotted flap to determine the effect on lift and drag of various slot-entry skirt extension. A skirt extension of 0.787 deg. was found to provide the best combination of high maximum lift with flap deflected and law drag with flap retracted. The data showed that the maximum lift at intermediate (20 deg. to 45 deg.) flap deflections was lowered considerably by the slot-entry extension; but at high flap deflections the effect was small" (p. 1).

"The problem of turbulence in aerodynamics is at present being attacked both theoretically and experimentally. In view of the fact however that purely theoretical considerations have not thus far led to satisfactory results the experimental treatment of the problem is of great importance. Among the different measuring procedures the hot wire methods are so far recognized as the most suitable for investigating the turbulence structure" (p. 1).

"Wind-tunnel tests on a 1/5-scale model of the Ryan XF2R airplane were conducted to determine the aerodynamic characteristics of the air intake for the front power plant, a General Electric TG-100 gas turbine, and to determine the stability and control characteristics of the airplane. The results indicated low-dynamic-pressure recovery for the air intake to the TG-100 gas turbine with the standard propeller in operation. Propeller cuffs were designed and tested for the purpose of improving the dynamic-pressure recovery" (p. 1).

From Summary: "A theoretical study, based on the linearized equations of motion for small disturbance, is made of the air forces on wings of general plan forms moving forward at a constant supersonic speed. The boundary problem is set up for both the harmonically oscillating and the steady conditions. Two types of boundary conditions are distinguished, which are designated "purely supersonic" and "mixed supersonic." the method is illustrated by applications to a number of examples for both the steady and the oscillating conditions."