"This reports presents the results of pressure distribution tests on a thick, tapered and twisted monoplane wing model. The investigation was conducted for the purpose of obtaining data on the aerodynamic characteristics of the new wing and to provide additional information suitable for use in the design of tapered cantilever wings. The tests included angles of attack up to 90 degrees. The span loading over the wing was approximately of elliptical shape, which gave rise to relatively small bending moments about the root" (p. 97).

"An investigation conducted to determine the factors which control the combustion in a high-speed compression-ignition engine is presented. Indicator cards were taken with the Farnboro indicator and analyzed according to the tangent method devised by Schweitzer. The analysis show that in a quiescent combustion chamber increasing the time lag of auto-ignition increases the maximum rate of combustion. Increasing the maximum rate of combustion increases the tendency for detonation to occur" (p. 63).

Report discussing an investigation to determine whether the crank angle for maximum rate of pressure rise can be used to indicate maximum-economy spark advance. Information about spark-advance tests at constant inlet-air pressure and fuel-air-ratio test results are provided.

Report presenting part of the results obtained to determine the effects of compressibility at high Mach numbers on a model of the Bell XS-1 transonic research airplane. General trends that can be qualitatively analyzed for level-flight Mach numbers up to 0.93 are given. Results regarding force characteristics and a comparison of results with wing-flow investigation are also provided.

Memorandum presenting a review of information relating to aircraft fires to determine what new or further research might lead to a substantial reduction of the aircraft fire hazard in flight and following crashes. An examination of fuels, lubricants, and hydraulic fluids as inflammable liquids is presented, together with possible sources of ignition under the general categories of hot surfaces, electric sparks and arcs, flames, and hot gases.

The effects of mass-flow ratio on the additive drag and normal-shock position of a single oblique-shock diffuser are presented. Also evaluated is the variation with operating condition of the velocity distribution at the combustion-chamber inlet. A comparison with connected-pipe data is included.

"The significance of additive drag is discussed and equations for determining its approximate value are derived. Charts are presented giving values of additive drag for open-nose inlets and for annular-nose inlets with conical flow at the inlet. The effects of variable inlet total-pressure recovery and static pressures on the center body are investigated, and an analytical method of predicting the variation of pressure on the center body with mass-flow ratio is given" (p. 1).

"A pneumatic probe based on continuity of mass flow through two restrictions separated by a cooling chamber was constructed to measure gas temperature at and beyond the limit of thermocouples. This probe consisted of a subsonic flat-plate orifice for the first restriction and a sonic-flow converging-diverging nozzle for the second restriction. The effect of variation in gas constants on the calibration is examined for common engine-exhaust gases" (p. 1).