Operation and maintenance procedures for 30 megawatt heat exchanger and steam generator for sodium cooled reactor system.

Given multigroup fluxes and adjoint fluxes of any cylindrical R-Z configuration, 2D PERT may compute: the prompt-neutron lifetime; the relative worth of various delayed neutrons; the integrals of capture, fission, etc., of given materials over any given region; local perturbations, i.e., danger coefflcients; and integrated perturbations, i.e., reactivity effect of uniform variation in the cross sections affecting a whole region. 2D PERT is programmed for a 32K IBM-704 using 3 tape units. The code is written in FORTRAN with the exception of two SAP subroutines. Input fluxes and adjoint fluxes are on tapes which may be obtained either directly from CUREM output or manufactured by a special tape-writing routine. Homogeneous cross sections and variations of these cross sections are either read in as input information or are computed by the code from a microscopic-cross-section library and atomic densities given as input. A combination of these methods may be used. (auth)

The three alterations discussed in this report have an effect on the parameters used in Total Control Calculations for C Reactor: Conversion to smaller diameter and shorter vertical safety rods in six outer control channels; installation of forty-four overbored tubes with short fuel charges in the flat zone and an associated increase in spike enrichment; and centralization of the enrichment ring into a three-lattice unit width in place of three and one-half lattice units previously in use. New parameters are derived in this document for future total control calculations.

A number of metals, carbides, nitrides, oxides, borides, and uranium gulfides are briefly evaluated concerning their possible applications as advanced nuclear rocket materials. (R.J.S.)

We present the results of measurements of the angular distribution of fission fragments produced by irradiation of Au{sup 197} and Bi{sup 209} with various heavy ions. The projectiles, B{sup 11}, C{sup 12}, N{sup 14}, and O{sup 16}, had energies from a few MeV above the Coulomb barrier to 10.4 MeV per nucleon. The gross features of these results can be explained by use of a model and parameters that have been used by others to account for angular distributions of fission fragments from helium-ion bombardments. In detail, however, these results appear to indicate that the models used to predict the average value of the angular momentum of the compound nucleus give values too low near the Coulomb barrier. Furthermore, at high bombarding energies it is necessary to consider the fact that appreciable direct interaction is taking place.

Information of interest to analytical chemists is presented in a report containing both positive and negative results obtained in a total of 58,467 determinations. The data and information are presented in sections concernlng the work of the shift laboratory, special analysis laboratory, spectral analytical group, analytical development group, quality control and standards laboratory, and analytical service for EOCR. Details of methods added to the ICPP analytical manual, and to the ICPP analytical radiochemlcal manual are included. (J.R.D.)

From summary: This report describes an experimental study performed on critical arrays of water-moderated, flat plate, laminated fuel bundles. The experiments were performed in support of analytical studies undertaken in the ANPP Code Development Program. The fuel bundles were built up using fully enriched uranium metal foils, stainless steel plates and boron stainless steel plates.

Previously reported results on the testing of small samples of boron carbide dispersed in nickel by electrolytic codeposition were adequately encouraging to lead to the development of a prototype control rod for operation in the Vallecitos Boiling Water Reactor. The operation of the control rod has been entirely satisfactory.

Abstract: Progress is reported on research and development tasks under the Program Plan for Engineering Support and Development of Army Pressurized Water Reactor Power Plants, Contract AT(30-1)-2639, during the six months' period October 1, 1061 to March 31, 1962.

Preparation of enriched fuel elements and target (N) elements for a full H-Reactor E-N demonstration loading was authorized in April, 1960. The objective of this loading was to demonstrate the feasibility of operating a Hanford reactor economically as a plutonium-tritium producer to increase over-all conversion ratio and diversify product output. Irradiation of the E-N load began in May, 1961 and was completed in January, 1962.

The effect of the redesign of the NERVA reactors as described herein on the transient startup and decay heat operating characteristics was not determined.

Technique used in deriving values of the linac ball tuner settings to produce various fields is discussed briefly, and tables showing ball tuner change numbers and values used in making up the ball tuner change numbers are given. (D.C.W.)

Technique used in deriving values of the linac ball tuner settings to produce various fields is discussed briefly, and tables showing ball tuner change numbers and values used in making up the ball tuner change numbers are given.

From Introduction: "The work of the Magnetic Measurements Section of the National Bureau of Standards includes (1) testing of specifically prepared test specimens intended for use as standards for checking magnetic testing apparatus (2) investigation and development of magnetic testing apparatus (3) calibration of mutual inductors, test coils, and instruments for measuring magnetic fields, and (4) investigations in the field of magnetics such as studies of phenomena associated with nuclear magnetic resonance or the selection and testing of materials suitable to be used as standards of magnetic susceptibility."

This report is about Binary counters.

The design and construction of the Boiling Nuclear Superheater (BONUS) Power Station at Punta Higuera on the seacoast at the westernmost tip of Puerto Rico are described. The reactor has an output of 17.5 Mw(e). This report will serve as a source of information for personnel engaged in management, evaluation, and training. (N.W.R.)

None

This report contains a listing of the bound-proton kernels for neutron scattering which were calculated in conjunction with the USAEC Control Rod Materials Program.

The results of Spert I in-pile transient tests of a rodtype, low- enrichment UO/sub 2/ fuel element are presented. The tests were performed to investigate the possibility of damage to such long thermal-time-constant fuel rods when subjected to short-period power excursions, and to test the effectiveness of an instrumentation technique for measurement of UO/sub 2/ fuel temperatures within the rods. In an initial series of power excursion tests, in which the range of reactor periods was from approximately 1 sec to 7.5 msec, simultaneous measurements were made of the transient temperature at the center of the fuel rod and at the outer cladding surface. Fuel rod rupture occurred during the exponential rise of the 7.5-msec excursion. Similar short-period tests performed on a second fuel rod contain ing no internal thermocouples did not result in cladding failure, supporting the postulation that rupture of the first rod was caused by waterlogging of the UO/sub 2/ as a result of the cladding penetrations made for installation of the internal thermocouples. Calculations of the transient temperature distribution in the fuel rod were made, and the results are found to be in good agreement with the experimental data obtained on the central-UO/sub 2/ and cladding-surface …

None

Abstract: An easy to use method for evaluating Bessel functions is given. This method is applicable to the one-dimensional, 2-group, 2-region diffusion problem, and is designed primarily for use on a small or medium sized digital computer. ...FORTRAN programs based on this method are presented together with the output obtained from an IBM-1620 digital computer.

In this report, approximations which have been shown to simplify the calculation of the normal modes of paraffin hydrocarbons are tested for olefinic hydrocarbons by application to C2H4, CH2CD, C2D4. The results indicate that the method should suffice for the low-frequency models below about 0.1 ev energy, and may be adequate for all vibrations as far as he needs of neutron scattering are concerned,

Reproducibly high density UC-PuC pellets containing minor amounts of (U,Pu)/sub 2/C/sub 3/ were made with nickel sintering aid. Average densities of 95% and maximum densities of 96.6% of theoretical were obtained. High density, singlephase UC-PuC pellets were made by sintering at high temperatures. Densities of 94% of theoretical appear to be attainable. Improved identification of microstructural constituents was made by means of metallography, x-ray diffraction, and microprobe analysis. Development of specialized chemical analysis techniques continued. The post-irradiation examination of the UC specimens was completed. Mass spectrometer analysis showed that 0.4% of the fission gases was released. Metallographic examination of the UC did not reveal any channges in structure. Metallographic examination of the metal specimen parts that were in contact with UC was completed. No evidence for interaction with niobium and slight evidence for interaction with stainless steel was found. The latter was not deleterious. Perturbation factors were calculated for the UC- PuC experiments. Negotiations continued, in order to select the most suitable test reactor. (auth)

Abstract: Distribution coefficients have been measured for the partition of metal ions between cation exchange resin and acetone-water-hydrochloric acid solutions. the differences in distribution coefficients of metal ions are greater in acetone-water media than in aqueous media of the same hydrochloric acid concentration. Using distribution coefficient data, conditions for column separations of mixtures can be selected. Column separations of metal ion mixtures can be effected by eluting with acetone-water-hydrochloric acid solutions of different compositions. Successful separations of a number of mixtures are reported.