Report regarding an airborne gamma-radioactivity survey that took place in the 2,800 square mile area around the Los Angeles region in California. Topics include the types of bedrock noted in the area as well as their levels of radioactivity.

Abstract: "The pressure drop and the time-temperature variation of the air test medium and heat storage material in a pebble-bed heater (designed for intermittent hypersonic wind-tunnel operation at test section Mach numbers of 4 to 11) are presented."

A carrier-free separation of hafnium from several hundred milligrams of rare earth oxides by anion exchange from saturated HC1 solution is given. The procedure is completed in 4-8 hours and is suitable for remote control work.

Abstract: The acid hydrolysis of [Pt(NH3)3Cl] has been shown to occur to a measurable extent. for this reaction: [APt(NH3)cCl]+ + H2O [chemical equilibrium symbol with rate constant k-1 above and k1 below] [Pt(NH3)c(H2O)]++ + Cl-, the equilibrium quotient was measured at 25 degree C and 35 degree C. At 25 degree C this quotient was 8.4 x 10-5 at [Mu] (ionic strength) = 0 and 25 x 10-5 at [mu] = .318 M. This variation is consistent with the expected changes in activity coefficients. [Delta]H for the reaction was found to be approximately 0. The rate constant, k1 was 2.3 x 10-5 sec.-1 at 25 degree C and it was nearly independent of ionic strength. The acid hydrolysis provides a mechanism for the exchange of the chloride ligand and Cl-. Exchange experiments with Cl36 showed that in addition to the acid hydrolysis, a process, first order in both, [Pt(NH3)3Cl] and Cl- with a rate constant of 6. 10-5 sec.-1M.-1 contributes to the exchange. The behavior of the entire series of chloro-ammines of platinum(II) toward acid hydrolysis and chloride exchange has been summarized, and a likely mechanism for the process has been discussed.

"Graft polymers were made by Co60 mutual irradiation of mixtures of styrene and methyl acrylate in contact Teflon. These graft copolymers were analyzed by infra-red absorption and their composition determined. The composition of the graft copolymer formed from styrene and methyl acrylate was different from that which is predicted by the copolymer composition equation."

Graphical presentation of K-factors for eight isotherms, published data on the solid-vapor region, and a bibliography of approximately 450 references.

The crystal structures of the normal fatty acids of low molecular weight have been rather neglected until recently. Formic acid and acetic acid occur in the solid as hydrogen-bonded linear polymers, while several acids with eleven or more carbon atoms per molecule exist in the solid as dimers. The melting points of these acids, when plotted against number of carbon atoms, fall on two rather similar curves for even and odd numbers of carbon atoms, respectively, each with a minimum near five carbon atoms. These facts and hope of explaining the melting-point behavior led us to examine the structures of propionic and butyric acid crystals. These crystals have different structures, but both contain dimers.

"This bibliography lists selected books, articles, and unclassified reports which have appeared in the following abstracts and indexes between August 1959 and December 1960."

"A method and equipment are described for determining the surface parameters of contact required for heat transfer calculations. In this method, the output of a surface analyzer for one surface is recorded on one channel of magnetic tape and the output for the other surface of the contact pair on a second channel. The tape is played back to an analog computer which then integrates the analog voltage to compute the void volume thickness, the number of contact points, and the ratio of metallic contact area to the total area."

Report describing the design and usage of the BORAX V nuclear reactor, its surrounding facility, systems, experimental programs, and possible hazards.

Introduction: Recently a new type of charged particle detector, the so-called spark chamber, has been developed. The detector has certain advantages in high energy physics over bubble chambers aside from its much lower cost.

Report containing "[a] description (...) of the design of a prototype "packaged" nuclear power plant. The purpose of the plant is to alleviate fuel oil logistics and storage problems posed by remote auxiliary DEW Line radar stations north of the Arctic Circle. The ALPR (redesignated SL-1) is a 3 Mwt, heterogeneous, highly enriched uranium- fueled, natural-circulation boiling water reactor, cooled and moderated with light water. Steam at 300 psig, dry and saturated (421 deg F) is passed directly from the reactor to a conventional turbine-generator to produce electric power (300 kw nominal) and space-heating (400 kw) requirements consistent with rigid mechanical and structural specifications prescribed by the military, and dictated by the extreme geophysics prevailing at the ultimate site. The over-all design criteria emphasize: simplicity and reliability of operation and maintenance, with minimum supervision; minimum on-site construction; maximum use of standard components; limited water supply; utilization of local gravel for biological shielding; transportability by air lift; and nominal 3-year fuel operating lifetime per core loading." (p. 15)

Sanderson & Porter have carried out a series of studies over the last four years which indicate that the pebble-bed reactor way be an attractive way to obtain low-cost power. At the request of the Atomic Energy Commission, two design studies have been carried out on this concept at the Oak Ridge National Laboratory. The first of these a preliminary design of a 10-Mw(t) reactor experiment, the PRRE, was initiated September 10, and a report on the study was issued November 1960. The second phase of the work, a conceptual design study of a 330-Mw (e) central station, was initiated November 1, and is the subject of this report.

"The laboratory experiments and field testing which were carried out in the development of a homogeneous gas labeling device are described. Detailed drawings of the injector and its most critical components are included. Recommendations are made for a production model of the device along with estimated costs of construction."

This paper reports an extension of previous experimental work with Alfven waves. We consider hydromagnetic waves propagating in a cylindrical plasma in a uniform axial magnetic field. The copper tube is filled with highly ionized plasma by an electrically driven switch-on ionizing wave. After the tube is filled with plasma, a hydromagnetic wave is induced by a radial current flow from the small molybdenum electrode to the copper tube. The force produced by this radial current together with the static axial magnetic field displaces the plasma in the azimuthal direction, and a transverse wave is propagated in the axial direction, along magnetic field lines. The transient magnetic field associated with the wave is also in the azimuthal direction.

From introduction: This report details the results of a 256-pound high explosive cratering experiment at the Chariot test site 110 miles north of the Arctic Circle.

From introduction: "Once-Through boiling of water to 100 per cent steam quality was successfully accomplished. Results of Departure from Nucleate Boiling, transition, and film boiling tests are presented."

Introduction: The primary objective of the work of this report was research and development leading to large-scale applications of low level isotope tracer technology.

From abstract: Crater dimensions have been determined for 23 explosions of 256-pound spherical TNT charges buried in desert alluvium. As opposed to previous work covering depths of burst as great as 6 feet, the work presented in this report extends knowledge of apparent crater radius and depth to depths of burst as great as 30 feet.

It is possible to generate a relatively uniform, highly ionized plasma by passing a powerful discharge between electrodes so arranged that the current is forced to flow across an initial strong magnetic field. The magnetic induction due to the discharge causes a bending of the original field. If the discharge is operated with a low-impedance current source, the electric breakdown starts in a limited region near the current-input connections (minimum-inductance path) and propagates as a well-defined front in the manner of a hydromagnetic shock wave. In this paper we analyze the phenomenon as a one-dimensional single-fluid hydromagnetic problem, neglecting dissipation behind the wave.

From Abstract: "This Monograph contains a consistent set of tables of thermodynamic properties of a large number of diatomic hydrides, deuterides, and tritides, for the ideal gas state at one atmosphere pressure. In addition to the thermodynamic properties of the molecular gases, the tables also include thermodynamic properties for chemical reactions involving the isotopic exchange of hydrogen."

Monthly report the progress and development of improved zirconium alloys for service in superheated water and steam. This report covers the period between April 1 to April 31, 1961 and was conducted by the United States and the European Atomic Energy Community (EURATOM).

"The understanding of interactions between the elementary particles, which no number thirty, and range from the massless neutrino to the Е with a mass of approximately 1320 Mev, in a prerequisite to the knowledge of the structure of matter. Although the complex aggregate of elementary particles which constitute matter displays properties different from those of the basic building blocks, nevertheless it is impossible to gain a firm knowledge of the behavior of matter without first ascertaining in the intrinsic properties of elementary particles, as well as the dynamics of their interactions. The present work is concerned with inelastic proton-proton scattering at 1.35 Bev, where single pion production predominates."

"The previously found maximum in the cosmic radiation energy spectrum is discussed, and the possibility that it arises in part from a misinterpretation of the data due to oversimplifying assumptions about the composition of the beam is examined. The importance that lack of recognition of isotopic composition may have is pointed out, and it is clear that this importance is strongly dependent on the measurements made and on the cut-off rigidity."