Analysis of pressure distributions for a series of tip and trailing-edge controls on a 60 deg wing at Mach numbers of 1.61 and 2.01 (open access)

Analysis of pressure distributions for a series of tip and trailing-edge controls on a 60 deg wing at Mach numbers of 1.61 and 2.01

Report presenting an investigation at Mach numbers of 1.61 and 2.01 to determine the pressure distributions for a series of 20 controls on a 60 degree delta wing. Tests occurred at a range of angles of attack and control deflections. Results regarding basic pressure distributions, comparison of experimental and theoretical results, and experimental comparisons are provided.
Date: May 16, 1958
Creator: Lord, Douglas R. & Czarnecki, K. R.
System: The UNT Digital Library
Analysis of pressure distributions for a series of tip and trailing-edge controls on a 60 degree delta wing at Mach numbers of 1.61 and 2.01 (open access)

Analysis of pressure distributions for a series of tip and trailing-edge controls on a 60 degree delta wing at Mach numbers of 1.61 and 2.01

Report presenting an investigation at two Mach numbers to determine the pressure distributions for a series of 20 controls on a 60 degree delta wing. Thirteen controls were of the balanced tip type and seven of the controls were of the more conventional trailing-edge type. Results regarding the basic pressure distributions, comparison of experimental and theoretical results, and some experimental comparisons are provided.
Date: May 16, 1958
Creator: Lord, Douglas R. & Czarnecki, K. R.
System: The UNT Digital Library
Effect of sliding velocity on friction properties and endurance life of bonded lead monoxide coatings at temperatures up to 1250 degrees F (open access)

Effect of sliding velocity on friction properties and endurance life of bonded lead monoxide coatings at temperatures up to 1250 degrees F

Report presenting studies to determine the effect of sliding velocity and ambient temperature on the friction properties and endurance lift of thin lead monoxide coatings bonded to type 440-C martensitic stainless steel. Results regarding the effect of run-in on endurance life are also provided.
Date: May 16, 1958
Creator: Sliney, Harold E.
System: The UNT Digital Library
PUMP-MOTOR MIXING AND HEAT BALANCE TESTS OF THE BYRON-JACKSON 4000-GPM PUMP (open access)

PUMP-MOTOR MIXING AND HEAT BALANCE TESTS OF THE BYRON-JACKSON 4000-GPM PUMP

The pump-to-motor mixing rate of the ByronJackson 4000-gpm pump was determined as a function of motor purge flow. A purge rate of 63 liters/hr, which corresponds to a mixing rate of 0.55 liters/hr, is recommended for operation of this pump. Further increases in purge flow did not decrease the mixing rate significantly below this level. Two runs were made with cooling water bypassing the external motor cooler. These runs indicated that the external cooler was necessary to prevent overheating of the 4000 gpm pump motor. However, the observed heat balance checked the predicted heat balance, indicating that the method of prediction can be applied to the design of motor
Date: May 16, 1958
Creator: Payne, H.R.
System: The UNT Digital Library
Strontium Program: Summary Report for May 1958 (open access)

Strontium Program: Summary Report for May 1958

Technical report was prepared by the Health and Safety Laboratory (HASL) with the objective of presenting a current picture of the Strontium Program. Abstract: Strontium 90 levels in fallout, milk, canned fish and tap water are summarized for data available up to May 1, 1958. Original data submitted during the month of April are included as an appendix. Data are presented to show the amount of Strontium 90 in fallout at sampling stations within and outside the United States.
Date: May 16, 1958
Creator: Hardy, Edward P., Jr.
System: The UNT Digital Library