It is usual to determine the density of neutrons by using foils of metals which become radioactive as a result of bombardment in the region under investigation. From the rate of disintegration of the newly formed radioactive element the number of neutrons absorbed can be calculated. By use of the capture cross section of the element of which the foil is composed the density of the neutrons can then be computed. By counting the alpha particles from a bismuth foil of known weight after exposure to neutrons the density of the neutrons which produced this activity can be calculated. The least accurately known value which enters into this evaluation is the capture cross-section of bismuth for pile neutrons. This value may be improved by future measurements. It is of importance only for absolute measurements of neutron density so that relative values can be measured with considerable accuracy on the basis of known data.

Warping of a rod by a variation in heat transfer coefficient around the periphery is considered. Estimates for some simple cases are given, and a more precise numerical calculation is carried out in ne instance.

Measurements made in a uranium cylinder result in a mean value of 1.55 cm. for the diffusion length L for distances of 1 to 4 cm. from the base of the cylinder. Calculations give a value which agrees with the experimental result and show further that L increases from 1.40 to 1.63 cm. as the neutrons diffuse a distance of 5 cm. into the uranium.

Stresses set up by an insulating strip in the bond are estimated and found to be small compared to those normally present without the defect.

Technical report with short reports on (1) Heavy water analysis and standardization, and Specific gravity of pure D2O; (2) Homogenous exponential experiment; (3) Recombination of pile gases; (4) Slurry pumping studies; and (5) Electron microscope laboratory.

Technical report. The object of the research is to determine the procedure and equipment for the preparation of U233 on a semi-works scale. The general proposed procedure is that thorium carbonate in aluminum cans will be irradiated with pile neutrons. The Pa233 resulting from neutron absorption the Th232 and the decay of Th233 will be extraction from 99% of the thorium and the natural U in thorium by MnO2 precipitations. The Pa233 will then be allowed to decay to U233 which in turn will be isolated from the remaining Th and partially decayed Pa233 by ether extraction.