A guide to evaluating the health and maturity of a hen for the purpose of egg production.

"The aerodynamic forces on an oscillating airfoil or airfoil-aileron combination of three independent degrees of freedom were determined. The problem resolves itself into the solution of certain definite integrals, which were identified as Bessel functions of the first and second kind, and of zero and first order. The theory, based on potential flow and the Kutta condition, is fundamentally equivalent to the conventional wing section theory relating to the steady case" (p. 291).

"Drag tests were conducted in the N.A.C.A. full-scale wind tunnel on full-scale models of two Army Air Corps type A-6 landing lamps mounted on an 8 by 48 foot airfoil. Drag measurements were made with the lamps in the leading edge and attached to the lower surface at the 5 and 10 percent chord positions. The drag of the lamps when faired into the airfoil was also measured. The results show that at 100 miles per hour and at the angle of minimum drag of the airfoil the unaired lamps in the leading edge produced an increase in drag of 5.5 pounds and that the unaired lamps on the lower surface at either position increased the airfoil drag 22.5 pounds" (p. 1).

Note presenting tests in a wind tunnel to determine the control forces and air loads acting on split flaps. Clark Y wing models were used with two different sizes of full-span split flaps, one with a medium chord and one with a narrow chord. The results indicated that at angles of attack and flap deflections for maximum lift, the lift loads on the split flaps were only 5 percent and 9 percent of the total lift for the narrow and medium-chord flaps respectively.

This report details the designs of high-speed aircraft from various countries from 1931 on, with special emphasis on the United States and Germany.

"The present report gives a method for computing the torsion of boxes with thin shear-resistant or simply tension-resistant walls under any torsional load, support and dimension. The final stress condition is developed from that of a principal system with unconstrained sectional warping corresponding to Bredt's formula and an additional stress condition due to constrained cross-sectional warping. This is computed by means of the deflection condition of the principal system from a statically indeterminate calculation" (p. 1).

This report details the design and construction of the Heinkel 70 mailplane and its comparison with the Lockheed "Orion".

This report presents test results of experiments on the vibration-response characteristics of airplane structures on the ground and in flight. It also gives details regarding the construction and operation of vibration instruments developed by the National Advisory Committee for Aeronautics.

This report presents the results of flight tests made to determine the lateral control characteristics of short wide ailerons and spoilers, as a consequence of the promise shown in wind-tunnel tests by these devices as means of obtaining lateral control, particularly at angles of attack above the stall. Several forms of spoilers, front-hinge, rear-hinge, plain retractable, and saw-tooth retractable were tested alone and in combination with the ailerons. The tests were made with several different amounts of wing dihedral so that the effect of the yawing moments of the different lateral control combinations, which varied from large negative to large positive values, could be evaluated. In conjunction with the tests, observations were made to throw some light on the feasibility of operating the airplane with two controls instead of the present three.

This report presents performance results of air cooled and water-cooled engines. The results obtained were sufficiently promising to warrant further investigation with fuel injection and spark ignition, with the same arrangement of inlet ports and exhaust valves at the bottom of the cylinder and the exhaust gases discharged through two poppet valves in the cylinder head. The displacement of the engine was 118 cubic inches. Optimum performance was obtained with the inlet air directed into the cylinder at an angle of 20 degrees to the radial.

A comparison is made of the boundary-layer flow computed by the approximate method developed by K. Pohlhausen with the exact solutions which have been published for several special cases. A modification of Pohlhausen's method has been developed which extends the range of application at the expense of some decrease in the accuracy of the approximations.

This report presents the results of wind tunnel tests to determine possible improvements in the design of airplane windshields, particularly with respect to the pilot's vision from the cabin in stormy weather.

It is shown that the lift distribution for a biplane with unequal chords may be calculated by the method developed in NACA Technical report no. 458 if corrections are made for the inequality in chord lengths. The method is applied to four cases in which the upper chord was greater than the lower and good agreement is obtained between observed and calculated lift coefficients.

"This paper presents a mathematical discussion of the laminar boundary layer, which was developed with a view of facilitating the investigation of those boundary layers in particular for which the phenomenon of separation occurs. The treatment starts with a slight modification of the form of the boundary layer equation first published by Von Mises. Two approximate solutions of this equation are found, one of which is exact at the outer edge of the boundary layer while the other is exact at the wall" (p. 541).

Report issued by the U.S. Bureau of Mines discussing the "occurrence, milling, and metallurgy of manganese in the United States" (p. 1). Different properties and compounds of manganese are also discussed. This report includes a map, tables, illustrations, and photographs.

Circular presenting a description of the Short Scylla, which is a 39-passenger landplane with four Bristol Jupiter XF BM engines. A description of the characteristics, blueprints, and photographs of the aircraft are provided.

Circular describing the Avro 642, which is a mixed construction high-wing cantilever monoplane. Details of the engines, controls, interior, wings, cockpit, ailerons, landing gear, characteristics, performance, drawings, and photographs are provided.