This quarterly progress discusses the ongoing work at the Oak Ridge National Laboratory for the quarter ending in March 10, 1952. Topics discussed include reactor theory and design, shielding research, materials research, and includes appendixes with supplemental information.

The development of ionic methods for the determination of corrosion products in the highly radioactive Homogeneous Reactor (HR) fuels has been of major interest in the work of the Ionic Analyses Laboratory. Methods for the spectrophotometric determination of aluminum and for the polarographic determination of iron in HR fuels have been developed. The polarographic determination of molybdenum in uranyl sulfate solutions was studied. A polarographic method for the determination of zinc was developed. A fluorometric method for the determination of microgram amounts of fluoride was studied. Three organic reagents were investigated as precipitants for microgram quantities of zirconium in HR fuel. The automatic photometric titration technique was applied to the determination of thorium and of sulfate. A method was developed for the ionexchange separation and potentiometric titration of cobalt. The ultraviolet absorption spectra of technetium and rhenium were studied.

A new gas-liquid countercurrent system (the ANCO system from Anisole-Complex) for the enrichment of boron isotopes has been developed. It is believed that use of this systems will result in a considerably lower unit cost for enriched boron-10 than was previously possible. The system utilizes the exchange reaction between BF3 (gas) and BF3·anisole (liquid) to concentrate boron-10 in the liquid phase. The single stage isotopic separation factor for this system has been found to vary from 1.039 at 0°C to 1.029 at 30°C. The isotopic exchange reaction has been shown to be rapid. Vapor pressures of the complex as a function of temperature have been measured and the heat of formation of the complex determined. Laboratory experiments show that quantitative removal of the BF3 from the complex can be accomplished by heating. A complete miniature ANCO plant was constructed and operated in the laboratory to test the feasibility of the system. The system was found to operate efficiently with a minimum of attention, and to enrich the isotopes of boron as expected. Based upon the experience obtained with the laboratory ANCO unit, a pilot plant large enough to utilize a 6-inch diameter exchange column was designed. The design calculations of …

Report issued by the Oak Ridge National Laboratory discussing aqueous homogeneous reactors used in central-station power. As stated in the introduction, "it contains an evaluation of the potentiality of producing power only, as exhibited by aqueous homogeneous systems" (p. 6). This report includes tables, and illustrations.

Technical report on the activities of the Oak Ridge National Laboratory Biology Division for the report period including a list of 346 publication and lectures and 205 short articles by members of the division on their research and activities.

The design of internally cooled electrical coils for the production of high frequency intensity magnetic fields presents many new aspects and combinations of the familiar modes of heat transfer. However, the customary methodology appears to be sufficient for preliminary analysis and understanding of those problems. This methodology comprises the derivation of a qualitative, approximate equation expressing the relative performance of the various parts of a system, followed by an examination of this equation in order to locate the limiting features of the system. These features are then investigated by more powerful methods, which in turn provide guidance for development research in the laboratory.

Thorium, a fertile material, is of interest to the Reactor Program in the production of U233. Thorium can be extracted and processed to a very pure bulk metal for fabrication into solid fertile elements. There are advantages, technical and economic, for using fabricated bulk thorium dioxide rather than the metal in some applications. It is the purpose of this paper to point out these advantages and to present briefly the technology related to fabrication, radiation damage and chemical processing of ThO2.

New systems involving the exchange of boron between boron trifluoride and boron trifluoride addition compounds have been explored. These systems have large separation factors and potentially simple reflux mechanisms. A precise determination of this separation factor for the anisole-boron trifluoride system gave the value (see report). Boron exchange was found to occur between BF and BCl3. Several homogenous catalysts have been found which activate the hydrogen-water exchange, but none are adoptable to the production of deuterium because of the slow exchange rate. Platinum or platinum oxide may be usable as a heterogeneous catalyst with proper support or dispersion techniques. The high-pressure solubility of hydrogen in several amalgams was investigated in connection with a unique countercurrent exchange system. A proposed system involving isotopic exchange between lithium dipivaloylmethane in diethyl ether and lithium hydroxide in aqueous solution was shown to give little or no isotopic separation. Column studies of the carbonate system exchange reaction were concluded with a 40°C run. Slightly higher enrichment of N15 was obtained than at 30°C . The temperature dependence of all in this system was measured between 15 and 45°C. The factor increases with temperature, showing a tendency toward a maximum near 45°C. Isotopic exchange appears to …

Quarterly technical report including reports on chemistry of source, fissionable, and structural elements, nuclear chemistry, radio-organic chemistry, chemistry of separations processes, chemical physics, radiation chemistry, and instrumentation. [From Abstract]

Electrodialysis in an ion-exchange membrane cell was shown to be technically feasible for the concentration of an azeotropic mixture of HF and water. A flowsheet is presented for recovery of anhydrous HF by distillation and electrodialysis of the azeotropic residue. In the electrodialysis step, 2.6 kwhr of energy per pound of anhydrous product was consumed, with electricity at 1¢ per kilowatt-hour, the total operating cost of the electrodialysis equipment alone, including amortization, would be 6¢ per pound of HF.

General considerations involving the transportation of irradiated fuel and radioactive wastes are reviewed. It is assumed that many reactors will supply feed to a few large multipurpose chemical plants which ultimately send radioactive waste to a few disposal sites. General economic considerations of irradiated fuel reprocessing, economic aspects of the nuclear economy complex, growth predictions of the nuclear power economy in the U.S., general requirements for the shipment of fuel and waste, regulations applicable to fuel shipment, and permissible radiation levels are discussed.

This report presents "Results of a critical literature review on pressure drop due to isothermal turbulent flow in noncircular geometries" (introduction).

From abstract: "This report describes the decontamination of Oak Ridge National Laboratory Purex Pilot Plant facilities and presents an appraisal of the decontaminating techniques and reagents which were employed."

In the use of a reactor as a device to measure neutron cross sections, the pile oscillator is often employed because of its much higher sensitivity compared to that available in static reactivity measurements. The factor limiting the available in static reactivity measurements. The factor limiting the available sensitivity is the generation of random noise, which originates in the statistical nature of the chain reaction. In other words, the nuclear reactions which maintain the chain reaction do not proceed uniformly, but rather at rates which fluctuate in time around some average values. These fluctuations limit the accuracy of measurements in the reactor.

Sanderson & Porter have carried out a series of studies over the last four years which indicate that the pebble-bed reactor way be an attractive way to obtain low-cost power. At the request of the Atomic Energy Commission, two design studies have been carried out on this concept at the Oak Ridge National Laboratory. The first of these a preliminary design of a 10-Mw(t) reactor experiment, the PRRE, was initiated September 10, and a report on the study was issued November 1960. The second phase of the work, a conceptual design study of a 330-Mw (e) central station, was initiated November 1, and is the subject of this report.

Study of the effects on Zircaloy-2 radiation corrosion of a high concentration of excess H2SO4 in a uranyl sulfate test solution using an in-pile loop experiment.

The thickness of an oxide film on phosphor bronze helices was determined by first establishing the oxygen content of the helix "as received" and after cleansing with nitric acid. Based on the assumption that the difference between these two values was the oxygen in the film, and that the film consisted entirely of cupric oxide, the thickness of the film was calculated from the density of cupric oxide, weight of the film, and surface area of film. A value of 1080 A was calculated as the thickness by this method.

Results of four experiemental runs in the Fluorox fluidized bed reactor system are reported. The engineering feasibility of UF6 production from UF4 by use of dry air of O2, 2UF4 + O2 = UF6 + UO2F2, in an Inconel fluidized bed reactor at 800-850°C was demonstrated in two experimental tests in which greater than 90% of the theoretical amount of UF6 was collected or measured. Two runs made with crude UF4 (produced from unpurified mill concentrate) as the feed material, showed that UF6 could be produced at 700-725°C but corrosion on Inconel was prohibitive.

To better understand the solvent extraction process much effort has been and is being expended at ORNL and elsewhere to measure reaction kinetics of the extraction reactions. To date these efforts have been largely unsuccessful, due to the attempt to apply homogeneous reaction kinetics to two-phase systems. An optical method has been devised for analyzing the concentration profile in the vicinity of a quiescent interface during steady-state diffusion at rather large molecular fluxes. The system under study is the extraction of uranyl ion from water by a TBP solution. Considerable effort has been directed to eliminating leaks in the diffusion cell and testing the optical system/

In order to make rational predictions of the operating characteristics of uranium anion exchange contactors, an understanding of the mechanism and kinetics of the exchange is necessary. Toward this objective an effort is being made to determine the equilibrium sorption isotherms and rates of sorption of uranium on the anion exchange resin Dovex 21K.

In order to make rational predictions of the operating characteristics of uranium anion exchange contactors, an understanding of the mechanism and kinetics of the exchange is necessary. Toward this objective an effort is being made to determine the equilibrium sorption isotherms and rates of sorption of uranium on the anion exchange resin Dovex 21K.

Considerable delay has occurred in getting ratification of the Eurochemic charter by 80% of the participating nations. The French, who were not expected to ratify the charter until an elected government was again established , actually ratified under de Gaulle late in 1958.

Bench scale studies have been made of the recovery of uranium from acid leach liquors (and slurries) by solvent extracting with di (2-ethylhexyl) phosphoric acid in an organic diluent. Uranium may be stripped from the organic solvent by either alkaline or acidic reagents, the former having been studied in greater detail. On the basis of these tests, a recovery process may be considered which shows promise both from the standpoint of operation and chemical costs. Under proper conditions, vanadium can also be extracted by the di (2-ethylhexyl) phosphoric acid and stripping again may be accomplished with either acidic or alkaline reagents. Preliminary studies have been made of these possibilities. In addition to di (2-ethylhexyl) phosphoric acid, some other organophosphorus acids, have been cursorily examined in respect to their extraction and/or stripping performance.

A study was made of a method for the flame photometric determination of iron. In Part I of this report, the flame emission spectrum of iron, measured by means of a Beckman Model DU spectrophotometer with a flame attachment, is compated to that measured with an ORNL high-sensitivity, recording, single-beam instrument, in order to determine which instrument is best suited for this application. Although it was found that the Beckman product has the higher resolving power over the wavelength region of 360 to 400mu, it does no posses the sensitivity or ease of operation of the ORNL instrument. On this basis, the ORNL flame spectrophotometer is used in subsequent tests. After selecting the best-suited instrument for the flame photometric determination of iron, it was necessary to establish the optimum operating conditions for this particular method. These conditions are described in Part II.