"Column and plate compressive strengths of extruded 14S-T aluminum alloy were determined both within and beyond the elastic range from tests of flat-end H-section columns and from local-instability tests of H-, Z-, and channel-section columns. These tests are part of an extensive research investigation to provide data on the structural strength of various aircraft materials. The results are presented in the form of curves and charts that are suitable for use in the design and analysis of aircraft structures" (p. 1).

Report discussing a mock-up injection impeller created to investigate the hydraulic characteristics and limitations of the NACA injection impeller currently in use. Information about the form and magnitude of critical factors of fuel-transfer leakage and peripheral fuel distribution is provided as well as the effects of design variations of components on hydraulic characteristics. Several revisions in portions of the impeller are suggested to improve its fuel-transfer, fuel-pumping, and fuel-equalizing characteristics.

Report presenting an investigation of the transition of the boundary layer from the laminar to the turbulent region on a flat plate, on the concave and convex side of a plate with a 20-foot radius of curvature, and on the convex side of a plate with a 30-inch radius of curvature.

Tests show that at inlet-air temperatures of 250 deg F and 100 deg F the knock-limited performance of the base fuel of blends, leaded with 4 ml TEL per gallon and containing 20 percent spiropentane, was reduced at fuel/air ratios below 0.085. The 20 percent methylenecyclobutane reduced the knock-limited power of the base fuel at fuel/air ratios below 0.112. Di-tert-butyl ether, methyl-tert-butyl ether, and triptane increased the knock-limited power of the base fuel at all fuel/air ratios and at both temperatures.

Report discussing several types of jet-exit designs, including normal, beveled, and unsymmetrical shapes, and their effect on the stability characteristics of the aircraft. No deviation of the jet center line from its exposed path is likely to be obtained if a jet exist is used that is normal to the flow. Having a tilted or asymmetrical exit was found to adversely affect the stability of the aircraft.

Report presenting an investigation to obtain force-test data on a wing design suitable for high-speed guided missiles, especially data on rolling moments produced in yawed and pitched attitudes. Force tests were conducted on two models of a wing design of low aspect ratio and 20 degree triangular plan form. Results regarding the application of results, four-unit wing design, and six-unit wing design are provided.

An investigation was conducted to compare the performance of two 25-ft-diam rotors which had identical dimensions and were similar in construction but different in blade airfoil-sections. Tests were conducted at indicated blade pitch angles from 3 degrees to 11.5 degrees and rotor speeds of 200, 290, and 371 rpm. The 23012.6 rotor required 2 percent less power to hover than the 0012.6. At thrust coefficients above design, the performance of the 23012.6 became better than the 0012.6 rotor.

Report discussing the characteristics of the jet-motor air-intake duct system for a pursuit-type airplane with modifications to the duct system. Details of its effects on the Mach number, high pressure recovery, drag, and simplicity of the system are provided. Problems regarding the flow condition through the ducts and some potential modifications to prevent further issues are also described.