From Summary: "Tests of a 1/7 size model of the Grumman XJR2F-1 amphibian were made in Langley tank no.1 to examine the landing behavior in rough water and to measure the normal and angular accelerations experienced by the model during these landings. All landings were made normal to the direction of wave advance, a condition assumed to produce the greatest accelerations. Wave heights of 4.4 and 8.0 inches (2.5 and 4.7 ft, full size) were used in the tests and the wave lengths were varied between 10 and 50 feet (70 and 350 ft, full size)."

Report discussing testing on a 42 degree swept-back wing to determine its low-speed aerodynamic characteristics in pitch and yaw at high Reynolds numbers. The main effect of increasing the Reynolds number was delayed wing stalling to higher angles of attack. Roughness on the wing leading edge also had a large adverse effect on lift, drag, and pitching-moment characteristics at higher Reynolds numbers.

"A Douglas C-74 airplane, during a test dive at about 0.525 Mach number, experienced uncontrollable longitudinal oscillations sufficient to cause shedding of the outer wing panels and the subsequent crash of the airplane. Tests of a section of the horizontal tail plane from a C-74 airplane were conducted in the Ames 16-foot high-speed wind tunnel to investigate the possibility of the tail as a contributing factor to the accident. The results of the investigations of fabric-covered elevators in various conditions of surface deformation are presented in this report" (p. 1).

Report presenting an investigation of the two-dimensional aerodynamic characteristics of several NACA airfoil sections at four Reynolds numbers. Results regarding the minimum drag, maximum lift, lift-curve slope, and angle of zero lift and pitching moment are provided.

Report presenting an investigation to evaluate the effects of split flaps, elevons, sharp leading edges, drooped-nose flaps, and extended-nose flaps on the lift, drag, and pitching-moment characteristics at low speed of a wing-fuselage combination with a wing with the leading edge swept back 63 degrees and an aspect ratio of 3.5. Results regarding the plain wing and wing-fuselage combinations, Reynolds number, split flaps, elevons, leading-edge devices, and highest lift coefficient attained before longitudinal instability are provided.

Testing was performed at Mach number 1.53 with a wing-fuselage combination with a wing with 63 degrees leading-edge sweep, an aspect ratio of 3.46, and a taper ratio of 0.25. The wing had an NACA 64A005 thickness distribution parallel to the plane of symmetry and was cambered and twisted. Results regarding the comparison of lift, drag, and pitching-moment characteristics of WF-63c and WF-63, effects of sweep, and effects of Reynolds number are provided.

An altitude-wind-tunnel investigation of the performance of AN-F-58 and AN-F-32 fuels in an experimental turbojet engine was conducted over a range of simulated altitudes and flight Mach numbers. Combustion efficiencies obtained with AN-F-58 and AN-F-32 fuels were approximately equal. The minimum-speed altitude operational limit was essentially the same with either AN-F-58 or AN-F-32 fuel. Starting characteristics of the two fuels were approximately the same at low wind milling speeds. Visual observation showed no apparent differences in the carbon-deposition rates of AN-F-58 and AN-F-32 fuels.

Report presenting testing of a standard turbojet engine by water injection at the inlet of the axial-flow compressor in the altitude wind tunnel. Engine performance at 7600 rpm was obtained over a wide range of water-air-pressure ratios and ram-pressure ratios. Results regarding the engine-component performance are also provided.

Memorandum presenting an approximate method for the estimation of the properties of the incompressible laminar boundary layer on a flat plate in the slip-flow region using Karman's momentum method. At equivalent stations, the total thickness and the skin friction of a slipping boundary layer are less than that of the normal boundary layer at the same Reynolds number.

Report presenting calculations to determine the effect of several operating conditions on the performance of condensers for steam-turbine power plants. The analysis covered a range of turbine-inlet pressures and turbine-outlet pressures for various condenser cooling-air pressure drops, flight speeds, and altitudes. Results regarding steam-cycle performance, effect of turbine-outlet pressure on condenser performance, effect of cooling-air pressure drop on condenser performance, effect of turbine-inlet temperature on condenser performance, and power-plant-weight estimates are provided.

"A compilation of free-spinning-airplane model data on the spin and recovery characteristics of 111 airplanes is presented. These data were previously published in separate memorandum reports and were obtained from free-spinning tests in the Langley 15-foot and the Langley 20-foot free-spinning tunnels. The model test data presented include the steady-spin and recovery characteristics of each model for various combinations of aileron and elevator deflections and for various loadings and dimensional configurations" (p. 1).

From Summary: "An investigation was conducted to determine the coolant-flow distribution, the cylinder temperatures, and the heat rejections of the V-1650-7 engine . The tests were run a t several power levels varying from minimum fuel consumption to war emergency power and at each power level the coolant flows corresponded to the extremes of those likely to be encountered in typical airplane installations, A mixture of 30-percent ethylene glycol and 70-percent water was used as the coolant. The temperature of each cylinder was measured between the exhaust valves, between the intake valves, in the center of the head, on the exhaust-valve guide, at the top of the barrel on the exhaust side, and on each exhaust spark-plug gasket."

"A theoretical analysis of the cross-sectional temperature distribution of a water-cooled turbine blade was made using the relaxation method to solve the differential equation derived from the analysis. The analysis was applied to specific turbine blade and the studies icluded investigations of the accuracy of simple methods to determine the temperature distribution along the mean line of the rear part of the blade, of the possible effect of varying the perimetric distribution of the hot gas-to -metal heat transfer coefficient, and of the effect of changing the thermal conductivity of the blade metal for a constant cross sectional area blade with two quarter inch diameter coolant passages" (p. 1).

The problems of static and dynamic longitudinal stability both at high speeds and at low speeds are discussed and data are presented which indicate recent progress made in the solution of these problems.

Report presenting an investigation of the problems of static and dynamic longitudinal stability both at high speeds and low speeds as well as information about progress that has been made to solve these problems. The incorporation of large amounts of sweepback on both the wing and horizontal tail can improve the rate of trim changes and stability. Longitudinal stability has been attained for configurations with a sweep angle of 45 degrees with stall-control devices, but experimental proof is needed for these devices.

"The ditching characteristics of the Lockheed XR60-1 airplane were determined by tests of a 1/24-scale dynamic model in calm water at the Langley tank no. 2 monorail. Various landing attitudes, flap settings, speeds, and conditions of damager were investigated. The ditching behavior was evaluated from recordings of decelerations, length of runs, and motions of the model" (p. 1).

Report discussing an investigation on the effect of engine skew on the directional and lateral control characteristics of a single-engine airplane with a single-rotating propeller. The estimated and test results showed an advantage to skewing the propeller, as it assists with overcoming inadequate rudder control in power-on flight and aileron control, especially with flaps deflected.

Report presenting the results of an analytical investigation, which demonstrated that the inlet of a turbojet engine can be protected from ice accretions by bleeding hot gases from other locations within the engine to the inlet without undue loss in thrust. Results regarding the bleedback requirements, engine performance, effect of nozzle area, mixing efficiency, and seriousness of thrust losses are provided.

"An analysis has been made of the lift control effectiveness of a 20-percent-chord plain trailing-edge flap on the NACA 65-210 airfoil section from section lift-coefficient data obtained at Mach numbers from 0.3 to 0.875. In addition, the effectiveness of the plain flap as a lift-control device has been compared with the corresponding effectiveness of both a spoiler and a dive-recovery flap on the NACA 65-210 airfoil section. The analysis indicates that the plain trailing-edge flap employed on the 10-percent-thick airfoil at Mach numbers as high as 0.875 retains at least 50-percent of its low-speed lift-control effectiveness, and is sufficiently effective in lateral control application, assuming a rigid wing, to provide adequate airplane rolling characteristics" (p. 1).

"An analysis has been made of the lift-control effectiveness of a 20-percent-chord plain trailing-edge flap on the NACA 65-210 airfoil section from section lift-coefficient data obtained at Mach numbers from 0.3 to 0.875. In addition, the effectiveness of the plain flap as a lift-control device has been compared with the corresponding effectiveness of both a spoiler and a dive-recovery flag on the INCA 65-210 airfoil section" (p. 1).

Report presenting wind-tunnel testing to determine the low-speed lift, drag, and pitching-moment characteristics of a 40 degree sweptback wing with high-lift and stall-control flaps and a fuselage with a fineness ratio of 10.2 to 1. Low, medium, and high-wing-fuselage combinations were tested at high Reynolds numbers. Results regarding the high-lift and stall-control flaps and wing-fuselage combinations are provided.

A lightweight instrument that utilizes resistance-wire electric strain gases to measure propeller-shaft thrust has been developed. A wind-tunnel investigation on a propeller installed, on a single-engine pursuit airplane showed that the instrument gave a reliable indication of propeller-shaft thrust to an accuracy of +/-2 percent within its calibrated range. No attempt was made to determine the relation of indicated shaft thrust to net propeller thrust.

Report presenting aerodynamic and icing investigations conducted in the icing research tunnel on a model of a turbojet-engine nacelle with a long straight air inlet in order to provide basic design criteria for hot-gas blowback systems. The most uniform temperature distribution was obtained with a bleedback of 4.4 percent at a gas temperature of 1000 degrees Fahrenheit and resulted in an average dry-air-temperature rise of 46 degrees Fahrenheit.

Report presenting the specific impulse of liquid diborane and liquid oxygen over a range of mixture ratios in a 100-pound-thrust rocket engine operating at a combustion-chamber pressure of 300 pounds per square inch absolute. A faired curve through the experimental data had approximately the same shape as the theoretical curve.