None

Memorandum presenting the Bell X-5 research airplane tested at 58.7 degrees sweepback during the program to determine the characteristics of a variable-sweep fighter airplane at transonic speeds. This paper includes the stability and control characteristics in the stable lift range up to Mach numbers near 1.0 at an altitude of 40,000 feet and to slightly lower Mach numbers at altitudes of 25,000 feet and 15,000 feet. Results regarding general comments, static stability and control characteristics, and longitudinal dynamic stability are provided.

Report presenting an investigation in the 4- by 4-foot supersonic pressure tunnel at a Mach number of 1.41 to determine the static stability and control and drag characteristics of a model of a 35 degree swept-wing airplane. The effects of alternate fuselage shapes, wing camber, wing fences, and fuselage dive brakes on aerodynamic characteristics were also investigated.

Memorandum presenting rolling stability derivatives for a complete model with a low-aspect-ratio wing and tail surfaces for a Mach number range of 0.70 to 0.94 and for an angle-of-attack range from 0 to 13 degrees for the lower Mach numbers. The model test results indicated regions of neutral or unstable damping in roll at Mach numbers of 0.85 and 0.90 in the higher angle-of-attack range for the basic model. Results regarding damping in roll, yawing moment and lateral force due to rolling, and aileron characteristics are provided.

Report presenting the lateral stability and control characteristics were investigated on the Convair XF-92A delta-wing airplane during the flights of the NACA research program. The investigation included sideslips, aileron rolls, and rudder pulses at a range of altitudes and indicated speeds. The lateral handling characteristics appear satisfactory when viewed in terms of gradually increasing sideslips, lateral control effectiveness, and period, and damping.

None

This report consists of Chapter Six of the Nuclear Metallurgy Lectures. Chapter six discusses the reduction of uranium, chemical composition of uranium ores, extraction process for uranium ores, bomb reduction, green salt, and dingots.

An investigation has been conducted at the Langley 4- by 4-foot supersonic pressure tunnel at a Mach nmber of 2.01 to determine the aerodynamic characteristics of several configurations of a model of a 45 deg swept-wing airplane. The basic configuratin had a wing with 45 deg sweepback at the quarter-chord line, aspect ration 3.2, taper ration 0.468, NACA 65A005.5 sections just outboard of the inlet and NACA 65A003.7 sections at the tip. The wing was mounted slightly above the body center line and an all-movable horizantal tail was located slightly below the extended chord line of the wing. Tre design incorporated twin wing-root supersonic inlets ducted to a single exit at the base of the fuselage. The configurations investigated included an extended nose length, a bumped-fuselage afterbody, an inlet droop, an lncreased wing aspect ratio, and a revised canopy shape. Configurations employing the wing of increased aspect ratio of 3.7, which constituted the bulk of the tests, produced about a 10-percent increase in lift and in longitudinal stability as compared with the basic wing of aspect ratio 3.2. There was a slight but masurable increase in minimum drag and maximum lift-drag ratio.

The conversion of UNH to UF4 and UF6, utilizing moving-bed techniques, is being studied; sufficient progress has been made that an evaluation of the process is warranted. The procedures under study, the Fluorox Process, have three major advantages: (1) substitution of HF for high-cost fluorine, (2) considerable reduction in HF requirements, and (3) marked reduction in plant-size and mechanical complexity.