It is usual to determine the density of neutrons by using foils of metals which become radioactive as a result of bombardment in the region under investigation. From the rate of disintegration of the newly formed radioactive element the number of neutrons absorbed can be calculated. By use of the capture cross section of the element of which the foil is composed the density of the neutrons can then be computed. By counting the alpha particles from a bismuth foil of known weight after exposure to neutrons the density of the neutrons which produced this activity can be calculated. The least accurately known value which enters into this evaluation is the capture cross-section of bismuth for pile neutrons. This value may be improved by future measurements. It is of importance only for absolute measurements of neutron density so that relative values can be measured with considerable accuracy on the basis of known data.

Report presenting tests on a scale model of a four-engine transport airplane to determine the stability characteristics, empennage control-surface effectiveness, the effect of propeller rotation on longitudinal stability, and a method for carrying spare wing panels under the fuselage. The effect of two models of wing power operation on the characteristics of the model was studied. The results indicate that the model possess satisfactory stick-fixed longitudinal stability for all normal flight conditions except for high power with flaps extended.

Warping of a rod by a variation in heat transfer coefficient around the periphery is considered. Estimates for some simple cases are given, and a more precise numerical calculation is carried out in ne instance.

Measurements made in a uranium cylinder result in a mean value of 1.55 cm. for the diffusion length L for distances of 1 to 4 cm. from the base of the cylinder. Calculations give a value which agrees with the experimental result and show further that L increases from 1.40 to 1.63 cm. as the neutrons diffuse a distance of 5 cm. into the uranium.

"Values of the circulation function have been obtained for dual-rotating propellers. Numerical values are given for four, eight, and twelve-blade dual-rotating propellers and for advance ratios from 2 to about 6. In addition, the circulation function has been determine for single-rotating propellers for the higher values of the advance ratio. The mass coefficient, another quantity of significance in propeller theory, has been introduced" (p. 35).

This report is a copy of a letter sent on May 23, 1944, concerning the analytical evaluation of Columbia River water by Clinton Laboratories.

This report contains work summaries for the week of May 18th, 1944 at the Hanford Atomic Products Operation. Canning, stack gas disposal, and graphite testing are discussed. (JL)

"The results of measurements in the Langley full-scale tunnel of the maximum lift coefficients and stalling characteristics of airplanes have been collected. The data have been analyzed to show the nature of the effects on maximum lift and stall of wing geometry, fuselages and nacelles, propeller slipstream, surface roughness, and wing leading-edge appendages such as ducts, armaments, tip slats, and airspeed heads. Comparisons of full-scale-tunnel and flight measurements of maximum lift and stall are included in some cases, and the effects of the different testing techniques on the maximum-lift measurements are also given (p. 1)".

Stresses set up by an insulating strip in the bond are estimated and found to be small compared to those normally present without the defect.

Technical report with short reports on (1) Heavy water analysis and standardization, and Specific gravity of pure D2O; (2) Homogenous exponential experiment; (3) Recombination of pile gases; (4) Slurry pumping studies; and (5) Electron microscope laboratory.

Technical report. The object of the research is to determine the procedure and equipment for the preparation of U233 on a semi-works scale. The general proposed procedure is that thorium carbonate in aluminum cans will be irradiated with pile neutrons. The Pa233 resulting from neutron absorption the Th232 and the decay of Th233 will be extraction from 99% of the thorium and the natural U in thorium by MnO2 precipitations. The Pa233 will then be allowed to decay to U233 which in turn will be isolated from the remaining Th and partially decayed Pa233 by ether extraction.

None

Field measurements were made on a fighter airplane to determine the approximate magnitude of the horizontal tail loads in accelerated flight. In these flight measurements, pressures at a few points were used as an index of the tail loads by correlating these pressures with complete pressure-distribution data obtained in the NACA full-scale tunnel. In addition, strain gages and motion pictures of tail deflections were used to explore the general nature and order of magnitude of fluctuating tail loads in accelerated stalls.

"Field measurements were made on a fighter airplane to determine the approximate magnitude of the horizontal tail loads in accelerated flight. In these flight measurements, pressures at a few points were used as an index of the tail loads by correlating these pressures with complete pressure-distribution data obtained in the NACA full-scale tunnel. In addition, strain gages and motion pictures of tail deflections were used to explore the general nature and order of magnitude of fluctuating tail loads in accelerated stalls" (p. 351).

This document provides the analytical reports on the aluminum-silicon alloy, tin and copper analytical reports are also provided.

"A method is presented for predicting the amplitude and frequency, under certain simplifying conditions, of the hunting oscillations of an automatically controlled aircraft with lag in the control system or in the response of the aircraft to the controls. If the steering device is actuated by a simple right-left type of signal, the series of alternating fixed-amplified signals occurring during the hunting may ordinarily be represented by a "square wave." Formulas are given expressing the response to such a variations of signal in terms of the response to a unit signal" (p. 487).

This document contains information about the sampling program at Columbia River during May 5, 1944. Topics discussed include: securing representative samples; analysis of the samples looking at temperature, bacteriological content, dissolved oxygen, and physical tests; and the method and equipment used in the sampling procedure.

None

Abstract: "The advantages of high scaling ratios in counting random pulses are discussed. The mechanism of the basic circuit used in the Columbia University scaling circuits is described. The difficulties experienced in the performance of the earlier circuits are indicated and modified circuits to eliminate these difficulties are given. Precautions that must be observed in carrying out the constructional details are suggested. The complete circuit and specifications are given in detail for a Scale of 128 for use with linear-amplifier systems" (p. 1).

From Introduction: "The present paper deals with control surfaces having plain-overhang and Frise balances."

From Introduction: "As a part of the general lateral-control investigation by the NACA, the large amount of two- and three-dimensional data on the rolling effectiveness of ailerons without exposed overhang balance is collected and analyzed in the present paper."

From Summary: "This paper deals with the single problem if circular shell-supported frames subjected to concentrated loadings. A mathematical attack is developed and presented in the form of nondimensional-coefficient curves."

From Summary: "The results of an analytical investigation to determine the qualitative effects of elevator-fabric distortion on the stick-force characteristics of an airplane are presented. These results indicate that serious alteration of intended stick-force characteristics can be produced by elevator-fabric distortion."

Report presenting a device that automatically analyses the data from a 45 degree strain rosette. The rosette strains are properly combined by means of an electric circuit to yield a direct meter reading of maximum shear strain and major and minor principal strains.