At the time the first UO{sub 3} from so-called ``full-level`` Redox runs was shipped from 224U, the % U{sub 235} as determined in 222-S appeared high when compared with theoretical values from the burn-out curve. Close agreement between the 222-S results and % U{sub 235} determined by K-25 on lots 007, 008, and 009, however, indicated that a considerable heel of cold uranium in Redox had been blended with the first ``full level`` material. This explanation has been verified by data collected over the past weeks and provided this report. It has also been verified by the % U{sub 235} found in lots later than 010* (after most of cold uranium flushed out of Redox) which ranged from 0.66% to 0.64%.

None

This describes a test program to establish the in-situ material properties of the reinforced concrete in Building 221-U for comparison to the original design specifications. Field sampling and laboratory testing of concrete and reinforcing steel structural materials in Building 221-U for design verification will be undertaken. Forty seven samples are to be taken from radiologically clean exterior walls of the canyon. Laboratory testing program includes unconfined compressive strength of concrete cores, tensile strength of reinforcing steel, and petrographic examinations of concrete cores taken from walls below existing grade.

We have shown that, despite funding delays since the passage of the Magnetic Fusion Engineering Act of 1980, fusion development could still be carried to the point of a demonstration plant by the year 2000 as called for in the Act if funding, now about $365 million per year, were increased to the $1 billion range over the next few years (see Table I). We have also suggested that there may be an economic incentive for the private sector to become in accelerating fusion development on account of the greater stability of energy production costs from fusion. Namely, whereas fossil fuel prices will surely escalate in the course of time, fusion fuel will always be abundantly available at low cost; and fusion technology poses less future risk to the public and the investor compared to conventional nuclear power. In short, once a fusion plant is built, the cost of generating electricity mainly the amortization of the plant capital cost - would be relatively fixed for the life of the plant. In Sec. V, we found that the projected capital cost of fusion plants ($2000 to $4000 per KW/sub e/) would probably be acceptable if fusion plants were available today.

This report discusses the anxieties within Congress in the wake of the Enron scandal. Moreover, the report notes that the 108th Congress is not likely to pass legislative reform as extreme as the 107th Congress, but will still confront issues of accounting reform. The report also highlights what the 108th Congress plans to reform.

The authors briefly summarize the development of, and test experience with, an initial data interface between the structural mechanics code Diablo and the SHARP reactor simulation system data hub MOAB. That interface has been exercised both to write MOAB databases from Diablo, and then also to use such a database to read in part of a simulation definition for a subsequent Diablo execution. All enhancements are integrated into the central Diablo source repository. The SHARP software system for advanced simulation of nuclear reactors and power plant systems is sponsored by DOE's Nuclear Energy Advanced Modeling and Simulation (NEAMS) program. SHARP has been architected as a federation of single-physics simulation tools to permit flexibility in programming langugages and leveraging of past and on-going investments. Solution of multi-physics problems will be coordinated by, and data passed through, a central 'hub'. SHARP's hub implementation is utilizing MOAB: a Mesh-Oriented datABase. This same data hub approach is also intended to enable multi-resolution simulations, e.g, lower-dimension plant-scale simulations can be informed by high-fidelity 3D models of particular critical components.

Comprehensive understanding of chemical transport in response to fluid flow and diffusion in geologic processes requires thermodynamic and transport properties of a wide variety of aqueous species at the temperature and pressure of interest, as well as mass transfer computer codes that provide simultaneously for fluid flow, diffusion, dispersion, homogeneous chemical reactions, and mineral solubilities. As a result of research carried out with support from DOE in prior years of this grant, considerable progress has been made in developing computer codes to calculate advective-dispersive-diffusional transport at both high and low pressures and temperatures. These codes have become highly sophisticated, but their application to geochemical processes is limited by the availability of thermodynamic and transport data for the major solute species in the aqueous phase. Over the past three years, research has been directed primarily toward characterizing the thermodynamic behavior of concentrated supercritical aqueous electrolyte solutions and predicting the diffusion coefficients of organic species in oil field brines. Related research has been concerned with characterizing the growth rate of hydrothermal alteration zones and assessing the relative importance of aqueous diffusion and heterogeneous reactions at mineral surfaces in geochemical processes. 103 refs., 12 figs.

From Wing Thickness: "A brief review of the effect of wing thickness and thickness distribution on the high-speed performance and stability characteristics of a representative configuration is presented."

Sub-Saharan Africa has been far more severely affected by AIDS than any other part of the world. The United Nations reports that 26.6 million adults and children are infected with the HIV virus in the region, which has about 10% of the world's population but more than two-thirds of the worldwide total of infected people. This report discusses this issue in detail, including the cause of the African AIDS epidemic, the social and economic consequences, response and treatment, and U.S. policy.

This report documents the findings from an onsite audit of the John Seiberling Federal building located in Akron, Ohio. The Federal landlord for this building is the General Services Administration (GSA). The focus of the audit was to identify various no-cost or low-cost energy efficiency opportunities that, once implemented, would reduce in either electrical and gas consumption and increase the operational efficiency of the building. This audit also provided an opportunity to identify potential capital cost projects that should be considered in the to acquire additional energy (electric and gas) and water savings to further increase the operational efficiency of the building.

The demand plot has a 5-set, modified pump decay curve; it shows that 20,000 gpm emergency flow would be required within 80 seconds of complete pump power failure. Bases for the demand curve are constant bulk inlet temperature of 2 C, constant bulk outlet temperature of 95 C, K-3 I&E fuel elements, and initial reactor flow of 188,000 gpm.

Since the emerging of second generation sequencing technologies, the evaluation of different sequencing approaches and their assembly strategies for different types of genomes has become an important undertaken. Next generation sequencing technologies dramatically increase sequence throughput while decreasing cost, making them an attractive tool for whole genome shotgun sequencing. To compare different approaches for de-novo whole genome assembly, appropriate tools and a solid understanding of both quantity and quality of the underlying sequence data are crucial. Here, we performed an in-depth analysis of short-read Illumina sequence assembly strategies for bacterial and archaeal genomes. Different types of Illumina libraries as well as different trim parameters and assemblers were evaluated. Results of the comparative analysis and sequencing platforms will be presented. The goal of this analysis is to develop a cost-effective approach for the increased throughput of the generation of high quality microbial genomes.

From Summary: "In order to provide a basis for judging the relative importance of wing failure by fatigue and by single intense gusts, an analysis of wing life for normal cruising flight was made based on data on the frequency of atmospheric gusts. The independent variables considered in the analysis included stress-concentration factor, stress-load relation, wing loading, design and cruising speeds, design gust velocity, and airplane size. Several methods for estimating fatigue life from gust frequencies are discussed."

From Introduction: "The purpose of this report is to present the results of the analysis and to compare them with the experimental results of the transonic turbine."

An investigatiori of the annealing of the radioinduced carrier concentration change in Sb-doped Ge in the range 370 to 455 l K was made. The irradiations were conducted at liquid nitrogen temperature using Co/ sup 60/ gamma irradiation. A model that explains the observed behavior is presented. On the basis of the model, the observed annealing consists of vacancy diffusion simultaneously to impurity sites and annihilation centers. Analysis of the activation energy for the annealing process yields values of 0.8 to 1.4 ev in agreement with the range of energies that were attributed to vacancy motion but that cannot be resolved into unique components. The complex activation energy is explained by the model in terms of the impurity concentration. It was observed that the change in carrier concentration saturates before complete annealing is achieved. The saturation, which is stable for further annealing at higher temperatures, is also explained in terms of the model. The vacancies are considered to diffuse to annihilation centers, such as dislocation lines, and to the site adjacent to an Sb atom. Those that go to an Sb are trapped. The Sb- vacancy complex can break up to supply a vacancy back to the system or can …

An archaeological evaluation of proposed pipeline system improvements in northern Milam County.

Argonne National Laboratory founded the Laboratory Computing Resource Center (LCRC) in the spring of 2002 to help meet pressing program needs for computational modeling, simulation, and analysis. The guiding mission is to provide critical computing resources that accelerate the development of high-performance computing expertise, applications, and computations to meet the Laboratory's challenging science and engineering missions. In September 2002 the LCRC deployed a 350-node computing cluster from Linux NetworX to address Laboratory needs for mid-range supercomputing. This cluster, named 'Jazz', achieved over a teraflop of computing power (1012 floating-point calculations per second) on standard tests, making it the Laboratory's first terascale computing system and one of the 50 fastest computers in the world at the time. Jazz was made available to early users in November 2002 while the system was undergoing development and configuration. In April 2003, Jazz was officially made available for production operation. Since then, the Jazz user community has grown steadily. By the end of fiscal year 2007, there were over 60 active projects representing a wide cross-section of Laboratory expertise, including work in biosciences, chemistry, climate, computer science, engineering applications, environmental science, geoscience, information science, materials science, mathematics, nanoscience, nuclear engineering, and physics. Most important, many …

This report provides a background and overview of arsenic-treated wood.

The Engineered Barrier System (EBS) represents one system in the performance of the Yucca Mountain high-level radioactive waste (HLW) repository to isolate and prevent the transport of radionuclides from the site to the accessible environment. Breached Waste Package and Drip Shield Experiments (BWPDSE) were performed at the Department of Energy's National Nuclear Security Administration Nevada Support Facility in North Las Vegas, NV in the A-1 lowbay between May 2, 2002 and July 25, 2002. Data collected from the BWPDSE will be used to support the flux splitting model used in Analysis and Modeling Report ANL-WIS-PA-000001 REV 00 ICN 03 ''EBS Radionuclide Transport Abstraction'' (BSC 2001a). Tests were conducted by dripping water from heights representing the drift crown or wall on a full-scale section of a drip shield with both smooth and rough surfaces. The drip shields had machined square breaches that represent the general corrosion breaches or nodes in the ''WAPDEG Analysis of Waste Package and Drip Shield Degradation'' AMR (CRWMS M&O 2000d). Tests conducted during the BWPDSE included: initial tests to determine the splash radius distances and spread factor from the line of drip impact, single patch tests to determine the amount of water collected in target breaches from …

This document provides the results of the acceptance test procedure performed under document number: HNF-2501, Rev 0. This Acceptance Test Procedure has been prepared to demonstrate the Hanford Site Emergency Alerting System functions as required by Specification WHC-S0454, Rev. 1 and project criteria.

This Final Report covers the work executed by Plug Power from 8/11/03 – 10/31/07 statement of work for Topic 2: advancing the state of the art of fuel cell technology with the development of a new generation of commercially viable, stationary, Back-up/Peak-Shaving fuel cell systems, the GenCore II. The Program cost was $7.2 M with the Department of Energy share being $3.6M and Plug Power’s share being $3.6 M. The Program started in August of 2003 and was scheduled to end in January of 2006. The actual program end date was October of 2007. A no cost extension was grated. The Department of Energy barriers addressed as part of this program are: Technical Barriers for Distributed Generation Systems: o Durability o Power Electronics o Start up time Technical Barriers for Fuel Cell Components: o Stack Material and Manufacturing Cost o Durability o Thermal and water management Background The next generation GenCore backup fuel cell system to be designed, developed and tested by Plug Power under the program is the first, mass-manufacturable design implementation of Plug Power’s GenCore architected platform targeted for battery and small generator replacement applications in the telecommunications, broadband and UPS markets. The next generation GenCore will be …

The U.S. wood products industry is a leader in the production of innovative wood materials. New products are taking shape within a growth industry for fiberboard, plywood, particle board, and other natural material-based energy efficient building materials. However, at the same time, standards for clean air are becoming ever stricter. Emissions of volatile organic compounds (VOCs) and hazardous air pollutants (HAPs) during production of wood products (including methanol, formaldehyde, acetylaldehyde, and mercaptans) must be tightly controlled. Conventional VOC and HAP emission control techniques such as regenerative thermal oxidation (RTO) and regenerative catalytic oxidation (RCO) require significant amounts of energy and generate secondary pollutants such as nitrogen oxides and spent carbon. Biological treatment of air emissions offers a cost-effective and sustainable control technology for industrial facilities facing increasingly stringent air emission standards. A novel biological treatment system that integrates two types of biofilter systems, promises significant energy and cost savings. This novel system uses microorganisms to degrade air toxins without the use of natural gas as fuel or the creation of secondary pollutants. The replacement of conventional thermal oxidizers with biofilters will yield natural gas savings alone in the range of $82,500 to $231,000 per year per unit. Widespread use of …

This report discusses the federal budget for fiscal year 2005.

This report identifies and briefly summarizes the 20 budget reconciliation measures enacted into law during the period covering 1980, when reconciliation procedures first were used by both chambers, through 2010, the last year of the 111th Congress.