The results of analyses of the airborne gamma radiation and total magnetic field survey flown for the region identified as the Bozeman National Topographic Map NL12-8 are presented in Volume I and II of this report. The airborne data gathered are reduced by ground computer facilities to yield profile plots of the basic uranium, thorium, and potassium equivalent gamma radiation intensities, ratios of these intensities, aircraft altitude above the earth's surface, total gamma ray and earth's magnetic field intensity, correlated as a function of geologic units. The distribution of data within each geologic unit, for all surveyed map lines and tie lines, has been calculated and is included. Two sets of profiled data for each line are included with one set displaying the above-cited data. The second set includes only flight line magnetic field, temperature, pressure, altitude data plus magnetic field data as measured at a base station. A general description of the area, including descriptions of the various geologic units and the corresponding airborne data, is included also.

On the basis of time-integrated emittance measurements, several different types of field emitter diodes were characterized at 1 to 3 kA, 1 MeV. These measurements were part of the design effort for the injector system of a linear induction accelerator, to be used as a flash x-ray source at Lawrence Livermore Laboratory. The experimental parameters were the cathode type, the anode mesh texture, the diode spacing and voltage, and the level of collimation of the emerging beam. Experimental results are presented that show that over a wide range, the emittance was proportional to the level of collimation. For any one diode, with the spacing left fixed, the emittance was found to be essentially independent of the diode voltage and current. Differential focusing of different energy beam components affects most strongly the peripheral components of the beam, and strong collimation was found to minimize the effects of momentum spread on the emittance. The lowest emittances (30 to 40 mr-cm at 400 A) were obtained with a foil-type cathode in a ball-over-plane configuration, using an etched tungsten mesh anode, and collimating the beam to one quarter of the total current.

Using a pair of lasers near 6000 A, the J = 6 ground state is excited to a J = 6 intermediate level and then to a J = 5 upper state. Non-resonant fluorescences from both excited states are separately detected. Results of a set of model calculations are tabulated. Level 3 average populations are always very small, since the system decays rapidly into inaccessible metastable states. This means that chemistry experiments are difficult. The differences between parallel and perpendicular polarization are modest. The fluorescence dips converge to a value near 50%. The level 3 populations do not approach a common value. This means that the most reliable experimental measurement does not determine the level populations. The most striking changes appear in the last two, most exact, models. The difference between the models is that one includes, for the first time, the linear frequency chirp produced by the fanlike spread of the focussed laser beams. This seemingly innocuous change halves the population left in the ground state. It appears that analogues of adiabatic passage and adiabatic rapid passage respectively are being observed.

In an effort to upgrade outdated instrumentation and to take advantage of current and imminent technologies the Nuclear Chemistry Division at Lawrence Livermore Laboratory is about to undertake a major upgrade of their low level radiation counting and analysis facilities. It is expected that such a project will make a more coordinated data acquisition and data processing system, reduce manual data handling operations and speed up data processing throughput. Before taking on a systems design it is appropriate to establish a definition of the requirements of the facilities. This report examines why such a project is necessary in the context of the current and projected operations, needs, problems, risks and costs. The authors also address a functional specification as a prelude to a system design and the design constraints implicit in the systems implementation. Technical, operational and economic assessments establish necessary boundary conditions for this discussion. This report also establishes the environment in which the requirements definition may be considered valid. The validity of these analyses is contingent on known and projected technical, scientific and political conditions.

Efforts of this task indicate that powerplant productivity is a complex issue that has to take into account economic factors, equipment limitations, and system-loading characteristics as well as external constraints such as regulatory requirements. Among the specific findings are: (1) utilities in Illinois use the industry-wide measures of performance such as capacity factor, availability factor, forced outage rates etc.; equivalent availability as a measure is not in common practice; (2) several unit performance statistics are collected on a routine basis such as the daily unit status, component outage data, monthly production figures etc.; (3) identifying major causes of lost productivity appears to be a relatively simple task, but finding economically and technically acceptable corrective actions are generally more difficult; (4) selection of improvement projects, as well as evaluating their future impacts, is mostly based on operating experience and engineering judgement, with no use of formal analytical/statistical models; (5) there generally is a group in every utility - typically called the power production department - with routine responsibilities for upkeep of unit productivity; and (6) recently the Commonwealth Edison Co. has developed a procedure for utilizing the Edison Electric Institute outage data base for analyzing productivity-related questions at nuclear plants; this …

Weekly report of the Texas Crop and Livestock Reporting Service on turkey poult numbers in Texas and compared with other states. It includes compiled statistics across six consecutive weeks during two years for turkey eggs set and poults hatched.