9 Matching Results
Results open in a new window/tab.
Results:
1 - 9 of
9
Three-Region Reflector-Moderated Critical Assembly With End Products. Experimental Results with CA-21-2. Reduced Concentration
None
Date:
April 12, 1956
Creator:
Scott, Dunlap; Lynn, J. J.; Sandin, E. V. & Snyder, Stuart
System:
The UNT Digital Library
Air-Cooled Condenser Steam System. Hr Engineering Test Procedure v 5
None
Date:
April 12, 1956
Creator:
Gory, J. L. & Williamson, H. E.
System:
The UNT Digital Library
The Development of a Thermal-Neutron-Flux Measuring Instrument
None
Date:
April 12, 1956
Creator:
Smith, C. K.; Weaver, C. V.; Chastain, J. W. & Fawcett, S. L.
System:
The UNT Digital Library
The Fire Properties of Metallic Uranium
None
Date:
April 12, 1956
Creator:
Smith, R. B.
System:
The UNT Digital Library
RESULTS OF PRELIMINARY NUCLEAR CALCULATIONS FOR A HOMOGENEOUS RESEARCH REACTOR
Critical mass, fuel concentration, power, maximum power density, and wall power density were obtained for bare spherical reactors having diameters of 8, 10, 11, and 12 ft, operating at 20, 100, 2OO, and 300 deg C. (L.T.W.)
Date:
April 12, 1956
Creator:
Nestor, C. W. Jr.
System:
The UNT Digital Library
PHASE III FUEL SAMPLE IRRADIATION. IRRADIATION REQUEST ORNL-21
None
Date:
April 12, 1956
Creator:
Neill, F.H. & Waugh, R.C.
System:
The UNT Digital Library
Antimony-125 in Thorex Streams
This report addresses the analyses for fission-product antimony-125 made on samples of selected Thorex streams. The results are summarized in Table I
Date:
April 12, 1956
Creator:
Handley, T. H. & Reynolds, S. A.
System:
The UNT Digital Library
Chemical development status report for week ending April 6, 1956
None
Date:
April 12, 1956
Creator:
Blanco, R. E. & Ferguson, D. E.
System:
The UNT Digital Library
FABRICATION OF HEATER TUBE FUSES
Various methods were investigated to produce a heater tube fuse. Utilizing powder metallurgy techniques, fuel tubes with an I.D. of 0.045 inch, O.D. of 0.075 inch, and length of 11/16 inch, containing various compositions of copper + UO/sub 2/, were fabricated. Fabrication methods consisted of compacting the tubes in quarter-length units, sintering under optimunn conditions, coining on a tinplated inner tube with tin washers between units, and then heat treating to obtain a proper bond. By these techniques, 33 unis containing various compositions of copper + U/sup 235/O/sub 2/ were fabricated and shipped to Atomics International for testing. In addition, work was performed on the brazing facet of the trigger element assembly, joining the copper + UO/sub 2/ fuel tube to a type 347 stainless steel thermal resistance pad and block. (auth)
Date:
April 12, 1956
Creator:
Kalish, H. S. & Megeff, S. I.
System:
The UNT Digital Library