From Introduction: "The purpose of this paper is to outline a suggested form of presentation of the results of a stability and control investigation in terms of flying qualities as defined in reference 1 and to systematize and review briefly the analytical work required for this type of presentation. No effort is made to specify definite test procedures."

Report issued by the Bureau of Mines over diesel engine operations. As stated in the introduction, "it is the purpose of this report to present such data and to reemphasize the importance of adequate maintenance for diesel engines used underground" (p. 2). This report includes tables, and illustrations.

"These tests were run to determine the effect that mixing engine exhaust gas with engine intake air has on fuel knock limit, specific fuel consumption, and air consumption." Information about the effect on pressure, air consumption, and fuel consumption is detailed.

Report presenting an investigation in the NACA 15-foot free-spinning tunnel to determine the effect of wing leading-edge slots on spin and recovery characteristics. The results indicate that recovery will generally be slower with the slots open than with them closed and the spin will be flatter and at a lower rate of descent.

Report presenting testing to study the effects of a typical nacelle on the characteristics of a thick low-drag airfoil that was shown to be subject to separation difficulties due to leading edge roughness. This testing confirmed the results of previous tests which indicated that the airfoil was unconservative with respect to separation difficulties. Results regarding the internal-flow measurements and corresponding drag increments, external drag, leading-edge roughness and nacelle combination, and section lift comparisons are provided.

"In the present paper an investigation is made of two stages of a multistage turboblower having a vaneless diffuser behind the impeller and guide vanes at the inlet to the nest stage. The method employed was that of investigating the performance of the successive elements of the blower (the impeller, vaneless diffuser, ets.) whereby the kinematics of the flow through the blower could be followed and the pressure at the different points computed. The character of the flow and the physical significance of the loss coefficients could thereby be determined so as to secure the best agreement of the computed with the actual performance of the blower" (p. 1).

"The stability characteristics of a glider towed by twin parallel towlines have been studied in the NACA free-flight tunnel. A preliminary theoretical analysis of the stability of a glider restrained from yawing was followed by an experimental investigation of the stability of a model towed from fixed tunnel points in such a way as to simulate tow in level flight. The results of the tests confirm the theoretical analysis and indicate that a pilotless, stable, towed-glider system is possible when twin parallel towcables are used" (p. 1).

Report presenting a flight investigation of the flying qualities and stalling characteristics of a North American XP-51 airplane. The short-period longitudinal oscillation disappeared within one cycle in all conditions tested. Requirements for satisfactory stalling characteristics were met in all respects except for stall warning.

Report presenting tests in the free-flight tunnel to determine the effect of the fuselage length and the aspect ratio and size of the vertical tail on lateral stability and control. Fuselages of two different lengths and various vertical tail surfaces were used on a powered model in the investigation. Results regarding the test conditions, flight tests, and force tests are provided.

"The few available test data on the heat dissipation of wholly or partly heated airfoil models are compared with the corresponding data for the flat plate as obtained by an extension of Prandtl's momentum theory, with differentiation between laminar and turbulent boundary layer and transitional region between both, the extent and appearance of which depend upon certain critical factors. The satisfactory agreement obtained justifies far-reaching conclusions in respect to other profile forms and arrangements of heated surface areas. The temperature relationship of the material quantities in its effect on the heat dissipation is discussed as far as is possible at the present state of research, and it is shown that the profile drag of heated wing surfaces can increase or decrease with the temperature increase depending upon the momentarily existent structure of the boundary layer" (p. 1).

Report presenting the thermal and pressure drop performance data of a slotted-fin Stewart-Warner exhaust gas and ventilating air heat exchanger. Three different crossflow air shrouds were used in testing. The rate of heat transfer was about the same for each shroud, but the static pressure drops varied greatly.

Report presenting observations made of the air flow around a Martin PBM-3 flying boat. The observations are part of an analysis to aid in the determination of possible methods of reducing the air drag of the airplane. The behavior of the tufts on the hull and tip floats at various airplane speeds by still and moving pictures taken from an accompanying airplane.

Report presenting an investigation of oscillations in the laminar boundary layer on a flat plate and their relation to transition to turbulent flow. The characteristics of boundary-layer oscillations were studied most successfully when the oscillations were artificially produced by a vibrating ribbon placed in the boundary layer near the surface. A review of theory regarding laminar-boundary-layer oscillations is provided.

This is an account of an investigation in which oscillations were discovered in the laminar boundary layer along a flat plate. These oscillations were found during the course of an experiment in which transition from laminar to turbulent flow was being studied on the plate as the turbulence in the wind stream was being reduced to unusually low values by means of damping screens. The first part of the paper deals with experimental methods and apparatus, measurements of turbulence and sound, and studies of transition. A description is then given of the manner in which oscillations were discovered and how they were found to be related to transition, and then how controlled oscillations were produced and studied in detail.

Report presenting compressibility phenomena under flight conditions on the XF2A-2 airplane, which was subjected to a series of dives and pull-outs at speeds up to 550 miles per hour corresponding to Mach numbers of 0.74. Results regarding time histories, pressure data, drag coefficient, and elevator control force are provided.

Report presenting data constituting a summary of the physical properties of 120 samples of metal alloys, representing 86 different compositions which have been investigated for their suitability as turbosupercharger wheel materials. Some of the reported data include the chemical composition, fabrication procedure, tensile-test and hardness values at room temperature, and tensile and rupture-test characteristics at 1200 degrees Fahrenheit.

Report and corollary maps on the Coyote Mesa District, Dolores Plateau Area, Colorado

Report presenting the results of flight tests of the performance and cooling characteristics of three NACA D cowlings and of a conventional NACA C cowling on the XP-42 airplane. The D cowling is, generally, characterized by the use of an annular inlet and diffuser section for the engine-cooling air. An increase in maximum speed was noted in the XP-42 airplane due to the change from a C cowling to a D cowling.

Map displays soil types along with creeks, lakes, rivers, tanks, ranches, roads, railroads, power transmission lines, Texas Agricultural Experiment Stations, towns, and Texas Land Office blocks and surveys. Includes legend and symbols. A polyconic projection, 1927 North American Datum. "Horizontal control by U.S.G.S. and U.S. C. and G. S. 10000 foot grid based upon Texas (South-central) system of plane coordinates."

Text describes climate, agriculture, soils, and crops of Dimmit County, Texas.

"The variation in the necessary aileron control and in the time required to bank to 45 degrees and 90 degrees with altitude and radii of gyration for a typical fighter or a pursuit airplane have been computed and are presented herein." The lateral motions and impact pressure for several conditions of flight are provided. The report concludes that "the aileron system...should be designed for rolling-moment requirements at high altitude and the hinge-moment limitations at low altitude".

Document issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, Gerald Mann, regarding a legal question submitted for clarification;Under the facts submitted what disposition should be made of excess money received at a tax sale in Jim Wells County Texas?

Newsletter of the University of Texas Bureau of Business Research outlining statistics and research related to business in Texas.

Monthly magazine discussing natural resources, parks, hunting and fishing, and other information related to the outdoors in Texas.