"This report is the fourth of a series presenting the results of strength tests on thin-walled cylinders and truncated cones of circular and elliptic section; it includes the results on 100 thin-walled Duralumin cylinders of circular section with ends clamped to rigid bulkheads. The tests show that as the ratio of moment to shear varies from small to large values the failure changes from a shear to a bending type. In the report a chart is presented that shows the corresponding changes in strength" (p. 1).

"The main purpose of this investigation is to make available to the designer useful information with regard to the aerodynamic drag of various types of flying-boat hull models. The present report is the first in a series covering investigation in this field. Through close cooperation between hydrodynamics and aerodynamics divisions it is hoped that results leading to improvements in hull design obtained" (p. 1).

General methods of theoretical analysis of airplane spinning characteristics have been available for some time. Some of these methods of analysis might be used by designers to predict the spinning characteristics of proposed airplane designs if the necessary aerodynamic data were known. The present investigation, to determine the spinning characteristics of wings, is planned to include variations in airfoil sections, plan forms, and tip shapes of monoplane wings and variations in stagger, gap, and decalage for biplane cellules.

Report discussing tests performed on two different wings to determine the increase in lift obtainable by removing the boundary layer and power required for the blower. The results for the stub wing were more favorable than the large-span wing.

"This report describes and gives the results of tests made to determine the effect of lateral inclination of the propeller thrust axis to the direction of flight. A wing-nacelle-propeller combination with the nacelle axis located successively parallel to and at 15 degrees to the perpendicular to the leading edge of a wing was tested with the combination at several angles of yaw. Tests of the wing alone at the same angles of yaw were also made" (p. 1).

This document discusses the types of commercial planes ordered by Air France. Characteristics of the Wibault 670, the Dewoitine D.620, Bloch 300, and the Potez 620 airplanes are included. Pictures and diagrams of these aircraft are also included.

"This report gives the characteristics of a wing with an auxiliary airfoil mounted near its trailing edge and used as a flap. The tests were made with a 10 by 60 inch Clark Y main airfoil and an NACA 0012 flap having a chord equal to 15 percent of the main wing chord. The axis of the flap in all cases was on the flap chord and 20 percent back from its leading edge. The optimum location of the flap axis relative to the main wing for maximum lift was found to be 1.25 percent of the main wing chord behind the trailing edge and 2.5 percent below the chord" (p. 1).

This report presents the results of performance test conducted on a six-cylinder commercial fuel-injection pump that was adjusted to give uniform fuel distribution among the cylinders at a throttle setting of 0.00038 pound per injection and a pump speed of 750 revolutions per minute. The throttle setting and pump speed were then varied through the operating range to determine the uniformity of distribution and regularity of injection.

From Summary: "An investigation was made to determine whether a sufficient amount of hydrogen could be efficiently burned in a compression-ignition engine to compensate for the increase of lift of an airship due to the consumption of the fuel oil. The performance of a single-cylinder four-stroke-cycle compression-ignition engine operating on fuel oil alone was compared with its performance when various quantities of hydrogen were inducted with the inlet air. Engine-performance data, indicator cards, and exhaust-gas samples were obtained for each change in engine-operating conditions."

Annual report submitted by the Boy Scouts of America to Congress describing highlights from 1934, activities, service reports, finance, organizational leadership, and other information about scouting programs.