Following a summary of the multiplicity of domestic and foreign floats and a brief enumeration of the requirements of floats, the essential form parameters and their effect on the qualities of floats are detailed. On this basis a standard float design is developed which in model families with varying length/beam ratio and angle of dead rise is analyzed by an experimental method which permits its best utilization on any airplane.

This report contains a description of a new spinning-test arrangement wherein the otherwise customary rotation of the model about a fixed axis is abandoned in favor of a corresponding rotation of the air stream. The advantage of this method lies in the fact that the model is at rest while the spin is recorded. In this manner it is possible to secure systematic results with little loss of time while employing 3- or 6-component wind-tunnel balances. The troublesome equalization of the mass forces is eliminated and the flow phenomena are accessible to direct observation.

This report presents some of the problems concerning tests of helicopters, such as forced landings, controllability and stability, general safety, piloting maneuvers, performance, servicing, and the production of lift of a propeller. Test flights are described including a 67.67 mph flight by Hanna Reitsch.

The flame photographs obtained with combustion-chamber models of engines operating respectively, with turbulence chamber and air-storage chambers or cells, provide an insight into the air and fuel movements that take place before and during combustion in the combustion chamber. The relation between air velocity, start of injection, and time of combustion was determined for the combustion process employing a turbulence chamber.

The object of the present report is to ascertain the relationship of the circulation distribution over the wing and of the lift to the height and position of the end plate. The side forces and moments on the end plates were also determined. It is found that moving an end plate of certain length up from the symmetrical position, is followed by a slight increase of the total lift.

"This paper reports on 4-component balance measurements with and without angle of sideslip made on an airfoil with end plate at one tip. In addition, pressure distribution measurements on the end plate served as a basis for the determination of the forces on the end plate and for the bending moments" (p. 1).