Memorandum presenting the effects of wing modification and stability augmentation on the computed longitudinal behavior in the pitch-up region and probable pilot opinion of the pitch-up characteristics of two current fighter airplanes. An exploration of the addition of a wing-leading edge is included. Results regarding computed pitch-up behavior and probable pilot opinion are provided.

From abstract: This paper presents the results of a study of the error in radio interferometer measurements of near sources attributable to the use of asymptotic formulae, valid for distant targets.

The neocuproine colorimetric method was applied to the determination of copper in yttrium metal. From 5 to 80 - g of copper was determined in the presence of as much as 5OO mg of yttrium with a coefficient of variation of 2%. Copper was reduced to copper (I) with hydroxylamine and complexed with neocuproine (2,9-dimethyl-1,10-phenanthroline). The colored complex was extracted into chloroform and its absorbance measured, after dilution with ethanol, at 457 m - . (auth)

A method for the direct determination of uranium in a cyclohexane solution of tri-n-octylphosphine oxide (TOPO) is presented. The adduct, UO/sub 2/ Cl/sub 2/ x 2TOPO, that is formed when uranium(VI) is extracted from hydrochloric acid solutions by tri-n-octylphosphine oxide absorbs light in the ultraviolet region. This absorbance is measured at 230 m mu vs. a TOPO-cyclohexane solution that was contacted with hydrochloric acid of the same concentration as that in the test aliquot. The molar absorbance index is 5500. The method is not selective; of the elements that are extracted by TOPO from hydrochloric acid, iron(III), zirconium, molybdenum, tin and thorium, only thorium can be tolerated. (auth)

A brief survey of decarboxylation reactions and carboxylation reactions that are known or presumed in biological systems will be presented. While a considerable number of amino acid decarboxylations are known, their mechanisms will not be included in the present discussion but will be reserved for a later paper in the symposium. The remaining decarboxylation reactions may be subdivided into oxidative and nonoxidative decarboxylations. In most cases, these reactions are practically irreversible except when coupled with suitable energy-yielding systems. The carboxylation reactions which are useful in the formation of carbon-carbon bonds in biological systems seem to fall into two or three groups: those which exhibit an apparent ATP requirement, and those which exhibit a reduced pyridine nucleotide requirement, and those which exhibit no apparent ATP requirement. Of the first group at least four cases, and possibly six or seven, are known, and one interpretation of them involves the preliminary formation of 'active' carbon dioxide, generally in the form of a carbonic acid-phosphoric acid anhydride. Those exhibiting no apparent ATP requirement seem to be susceptible to classifications as enol carboxylations in which the energy level of the substrate compound is high, rather than that of the carbon dioxide. There appear to be …

Uranium dioxide pellets sealed in Type 316 stainless steel containers with a helium gas were irradiated in helium and in C0/sub 2/ in thermal fluxes or the order of 1 x 10/sup 13/ n/(cm/sup 2/)(sec). Cladding-surface temperatures were reportedly between 1200 and about 1800 F. The hot-cell examination performed by BMI showed that there were no obvious effects of the irradiation on the specimen tested in helium. However, the specimen irradiated in the presence of C0/sub 2/ exhibited severe cladding-CO/sub 2/ reaction and possible central melting of the UO/sub 2/. Although comparisons between pre- and postirradiation data were difficult because of involved fabrication history of the specimens, the tests did further establish the fact that helium is a satisfactory coolant gas for stainless steel cladding material at a temperature of 1200 F. The data obtained from the specimen tested in the presence of C0/sub 2/ indicate that at temperatures in the range of 1600 to 1800 F Type 316 stainless steel is not compatible with C0/sub 2/. (auth)

This report addresses air-core strong focusing synchrotron.

This document details activities of the irradiation processing department during the month of March, 1959. A general summary is included at the start of the report, after which the report is divided into the following sections: Research and Engineering Operations; Production and Reactor Operations; Facilities Engineering Operation; Employee Relations Operation; and Financial Operation.

This report was written to describe briefly several possible variations of such systems along with probable cost estimates. Previous work has been shown that the application of scintillation detectors is the simplest and most reliable means for such monitoring. By proper detector selection and measuring methods, the system can be of an approximate gamma dose-rate with gamma energy independence above about 100 Kev. The same system using detector change only is directly applicable to beta, gamma, slow neutron and fast neutron detection. Any type of alarming device desired can be incorporated.

Several hollow uranium cores of "C" size I & E diameters were fabricated by cold extrusion (550 to 750 F) at Hunter Douglas Aluminum Corporation. Results show diameter control and reproducibility are excellent. Preferred orientation induced by this process is completely removed by a single standard beta heat treatment.