Report presenting comparative drag measurements at zero lift at transonic speeds for two sharp-leading-edge airfoils using the NACA wing-flow method. One airfoil had a symmetrical circular-arc section and one had a symmetrical double-wedge section. The primary difference in the drag characteristics of the two airfoils at zero lift is the earlier drag rise of the double-wedge section.

Report discussing the results of flight tests to determine the drag at zero lift of a swept-back wing of inverse taper using an NACA 65-009 airfoil. The data was compared to untapered wings with a similar degree of sweepback. The tapered wing was found to have a lower drag coefficient than the 34-degree swept-back untapered wing but a higher drag coefficient than the 45-degree swept-back untapered wing.

Report discussing three fuels conforming to AN-F-58 specification were investigated in order to determine the influence of boiling temperatures and aromatic content on altitude performance in single combustor of a 4600-pound-thrust turbojet engine.

An investigation by the transonic-bump technique of the static longitudinal aerodynamic characteristics of a series of thin, low-aspect-ratio, highly tapered wings has been made in the Langley high-speed 7- by 10-foot tunnel. The Mach number range extended from about 0.60 to 1.18, with corresponding Reynolds numbers ranging from about 0.75 x 10(6) to 0.95 x 10(6). The angle of attack range was from -10 degrees to approximately 32 degrees.

"The XF-12 airplane was designed by Republic Aviation Corporation to provide the Army Air Forces with a high performance, photo reconnaissance aircraft. A series of air-stream surveys were made n the vicinity of the empennage of a 1/8.33-scale powered model of the XF-12 airplane in the Langley 19-foot pressure tunnel. Surveys of the vortical-tail region were made through a range of yaw angles of plus or minus 20 degrees at a high and low angle of attack" (p. 1).

"As part of a program to determine the feasibility of using a fighter airplane as a parasite in combination with a Consolidated Vultee RB-36 for long-range reconnaissance missions (project FICON), an experimental investigation has been made in the Langley free-flight tunnel to determine the dynamic stability and control characteristics of a 1/17.5-scale model of a Chance Vought F7U-3 airplane in several tow configurations. The investigation consisted of flight tests in which the model was towed from a strut in the tunnel by a towline and by a direct coupling which provided complete angular freedom. The tests with the direct coupling also included a study of the effect of spring restraint in roll in order to simulate approximately the proposed full-scale arrangement in which the only freedom is that permitted by the flexibility of the launching and retrieving trapeze carried by the-bomber" (p. 1).

Report presenting free-fall testing of the airplane configuration described in the title to evaluate certain new testing techniques for near sonic speeds. Results regarding the drag measurements and pressure data are provided. The data obtained from this test is also compared to free-fall tests in the high-speed tunnel and for a rocket-powered free-flight model, and the results show generally satisfactory agreement.

Report presenting an investigation at transonic speeds of the control balancing characteristics of three tabs on a full-span flap on an aspect-ratio-3, 45 degree sweptback wing. The results indicated that all the tabs tested, inset, attached, or detached, would balance the flap hinge moments throughout the speed range.

Memorandum presenting the application of the concept of indicial functions to the analysis of the aerodynamic phenomena associated with the short-period pitching mode of wings in subsonic and supersonic flight. Simple physical relationships are pointed out and are used to study the effect on the rotary-damping-moment coefficient of changes in center-of-gravity position, Mach number, aspect ratio, plan form, frequency, and thickness.

Memorandum presenting an investigation in the supersonic blowdown tunnel to determine the effects of span and spanwise and chordwise location on the control characteristics of spoilers on a 6-percent-thick, 50 degrees sweptback wing of aspect ratio 2.5 and taper ratio of 0.625. The results of the investigation indicate that the inboard spoilers located at the rearward chordwise station produce the highest rolling-moment effectiveness.

Memorandum presenting the effect of magnesium particles of various equivalent diameters on the apparent viscosity, sedimentation ratio, and redispresibility of petroleum-stabilized magnesium-JP-4 slurries. Powders of the following equivalent diameters were investigated: 2.8, 3.8, 7.2, 9.3, 12.0, and 14.8 microns. An analysis of the experimental error and reproducibility of values of apparent viscosity, sedimentation ratio, and redispersibility of the slurries was also made.

Report presenting testing of a circular scoop inlet located far forward on a parabolic body of revolution at a range of Mach and Reynolds numbers and mass-flow ratios. The inlet had an area equal to 8 percent of the body frontal area. Results regarding total and base drag coefficients, external drag coefficients, and inlet total-pressure recovery are provided.