Long-life replacement lamps for the incandescent lamp have been evaluated with regard to their cost effectiveness. The replacements include the use of energy buttons that extend lamp life as well as an adaptive fluorescent circline lamp that will fit into existing incandescent lamp sockets. The initial, operating, and replacement costs for one million lumen hours are determined for each lamp system. It is found that the most important component lighting cost is the operating cost. Using lamps that are less efficient or devices that cause lamps to operate less efficiently are not cost-effective. The adaptive fluorescent circline lamp, even at an initial unit cost of $20.00, is the most cost-effective source of illumination compared to the incandescent lamp and lamp systems examined.

The tandem mirror device (TMX) exhibits gross stability to both MHD and microinstability modes. The end-cell plasmas provide the tandem with average minimum-B stability, while the efflux of plasma from the central cell maintains the end cells (plugs) at marginal stability to loss cone modes. For some operating conditions, a residual level of plug ion cyclotron fluctuations is detected. These oscillations dominate the fluctuation frequency spectra in both the plugs and the central cell. The presence of plug ion cyclotron fluctuations in the central cell leads to resonance heating of some of the central cell ions. This heating degrades the confinement of the central cell ions; thereby increasing the amount of warm plasma stream flowing through the plugs.

LLNL made ultrahigh-frequency (450-MHz) electromagnetic borehole-to-borehole transmissions in the Stripa Mine near Guldsmedshyttan, Sweden, in April 1979. Transmission loss measurements were made between four sets of 76-mm boreholes 30 m long, located at the end of a drift. Distances between the boreholes varied from 2 to 22 m. More than 25,000 data points were taken. A geotomograph was constructed to show the variation of attenuation between boreholes. The observed spatial variation of electromagnetic attenuation may be related to the expected stress relief created by the mine. Transmission loss measurements were also made between two converging boreholes drilled from the surface to points near the mine. Data taken at 21 MHz show a nearly uniform attenuation within this sampled region. These experiments demonstrate that geotomographic data collection/interpretation provides high-resolution images of the underground environment and can provide useful input to those charged with providing the detailed site characterizations needed for both short- and long-term monitoring of underground nuclear waste repositories.

This report details the criteria that are employed in making reasonable charge determinations.

Currently two simple theories are heavily used in laser-fusion research: the Thomas-Fermi-Dirac statistical model, and an atomic ionization model based on screened hydrogen like energy levels. Recent improvements in these theories are summarized. We show representation calculations of thermodynamic properties, ionization, x-ray emission rates and fast-ion stopping powers, and give a brief sketch of the major unresolved scientific questions.

Interpretation of ultrasonic inspection data from stainless steel welds is difficult because the signal-to-noise ratio is very low. The three main reasons for this are the granular structure of the weld, the high attenuation of stainless steel, and electronic noise. Averaging in time at the same position in space reduces electronic noise, but does not reduce ultrasonic noise from grain boundary scattering. Averaging wave-forms from different spatial positions helps reduce grain noise, but desired signals can destructively interfere if they shift in time. If the defect geometry is known, the ultrasonic waveforms can be shifted before averaging, ensuring signal reinforcement. The simplest geometry results in a linear time shift. An averaging algorithm has been developed which finds the optimum shift. This algorithm computes the averaged, or composite waveform as a function of the time shift. The optimum occurs when signals from a reflector become aligned in time, producing a large amplitude composite waveform. This algorithm works very well, but requires significant computer time and storage. This paper discusses this linear shift averaging algorithm, and considers an implementation using frequency domain techniques. Also, data from several weld defects are presented and analyzed.

The effect of beam-generated positive ions on the beam-breakup instability in linear electron accelerators is calculated using simple models. The strongly nonlinear dependence of the ion focusing force on radius makes a complete suppression of the mode growth possible, in contrast to solenoidal focusing. The predicted gas pressures for significant stabilization of the mode growth in a machine configuration like ATA is relatively low (10/sup -5/ to 10/sup -4/ torr), even for high-Q modes.

Document issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, Mark White, regarding a legal question submitted for clarification; Whether government employees may carry a handgun while hunting and trapping predatory animals and rodent pests.

Document issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, Mark White, regarding a legal question submitted for clarification; Whether or not a county clerk may assess the fees prescribed in article 1604, Code of Criminal Procedure, in a case in which the proceedings have been deferred and ultimately dismissed pursuant to article 6701d, section 143A.