Front: Text describes action on various war fronts: Allied Council, North Africa, Western Europe, Solomons, New Guinea, Wake, Russia, Aleutians. Includes ten photographs. Large world map is keyed to text and illustrates time zones around the world. Inset maps show North Africa and Russia. Back: "Soviet Infantry." Two posters by Glen Mitchell show Soviet infantry in action. Also included are images of Soviet uniform insignia and Soviet weapons.

Front: Text describes action on various war fronts. Large world map is keyed to text and illustrates time zones around the world. Inset maps: [Rostov area] ; [Tunisia coast]. Includes 8 photographs. Back: The World at War map indicates points where U.S. forces are stationed.

Front: Text describes action on various war fronts: Command, Solomons, North Africa, New Guinea, Russia. Large world map is keyed to text and illustrates time zones around the world. Inset maps of Guadalcanal; Russian front. Photographs: Heads down [under the barbed wire]; Jap navel gun; Near the end [fighting in Papua]; North Africa; Poles in Iraq; Vital supply: water for the Eighth Army; German mortar. Back: Poster illustrates uniforms and insignia of the German Army.

Front: Text describes action on various war fronts: Russia, New Guinea, Solomons, China, Pacific and Far East, French fleet, North Africa. Large world map is keyed to text. Includes table: Great Circle Distances in Statute Miles. Inset maps show Tunisia and Russia. Includes 8 photographs. Back: Poster provides recognition cues and front and profile drawings of Allied and Axis light tanks and self-propelled weapons. Includes range scale.

"This supplement outlines in detail the methods for plotting of observation data, for entry of analysis, and for preparation of supplementary maps, charts, and diagrams for all Army Air Forces weather stations."

From Summary: "A portable device for calibrating dynamic strain gages is described. The device contains a motor-driven cam, which applies alternating tensile loads to a metal strip 5/8 inch wide and 6 1/4 inches long. The cam is designed to produce a nearly sinusoidal variation of strain with time. Dynamic strain gages with gage lengths up to 5 inches may be calibrated by mounting them on the strip and by changing the frequency and the amplitude of the tensile load. The frequency may be varied from 15 to 30 cycles per second and the strain amplitude from 0 to 10x10-4 in steps of 2x10-4."

Report presenting the pressure distribution on the fuselage of a midwing airplane model measured in the 8-foot high-speed wind tunnel at a range of speeds and lift coefficients. The primary purpose of the investigation was to provide data showing the air pressures on various parts of the fuselage for use in structural design.

Characteristics are determined for various modifications of 0.155-chord blunt-nose aileron on semispan model of tapered fighter plane wing. Ailerons with 40 percent nose balance reduced high-speed stick forces. Increased balance chord increases effectiveness and reduces high-speed stick forces. Increased balance chord increases effectiveness and reduces adverse effects of gap at aileron hose. Increase of nose radii increased negative slope of curve hinge-movement coefficient plotted against deflection. Extended deflection range decreased aileron effectiveness for small deflections but increased it at large deflections. Peak pressures at noses of ailerons are relatively high at moderate deflections.

"The measurement of pressure distribution may be accomplished rapidly for any number of locations deemed necessary in model or full-scale investigations by use of the 'belt' method. Reasonable accuracy may be obtained by careful use of this method" (p. 1).

Report presenting an investigation to find a means of obtaining undiluted exhaust-gas samples from a Wright R-2600-B aircraft engine equipped with short individual stacks. Preliminary tests to aid in determining the best design, location, and orientation of orifices ranging in size. Results regarding the Briggs & Stratton engine tests and Wright aircraft engine tests are provided.

Report presenting an analysis of the pressure drop that is required to cool a typically baffled radial engine, which shows that a total pressure drop of 58 pounds per square foot is necessary at sea level and 112 pounds per square foot is required at an altitude of 40,000 feet.

Report presenting an investigation of the effect of wing loading, power loading, and aspect ratio on the performance of pursuit airplanes. The study is based on data combined from specifications, wind-tunnel, and flight tests of various airplanes and presented in graphs.

Report presenting testing of the flutter characteristics of the SB2U-2 airplane. The secondary purpose of the test, which ended up being the primary purpose, was to study the behavior of the airplane just below the flutter speed. Results regarding flutter amplitude, frequencies, and energy-absorbing qualities are provided.

Report presenting general formulas for determining the jet-boundary corrections to the angle of attack, the drag coefficient, the downwash, the pitching, rolling, and yawing-moment coefficients of complete powered yawed models, and to the increments of rolling and yawing-moment coefficients due to the ailerons on yawed models.

Report presenting tests on a scale model of a four-engine cargo airplane, which was tested in the high-speed wind tunnel. The high-speed characteristics of the airplane, particularly the longitudinal stability and control in dives were investigated. Test results indicated that no important changes in longitudinal stability or controllability occurred until the speed exceeded the predicted maximum level-flight speed by more than 38 percent.

Report presenting a series of models of flying-boat hulls tested to determine the effects of the angle of dead rise and the angle of afterbody keel on resistance and spray characteristics. Three angles of dead rise and three angles of afterbody keel were investigated. The results are expressed in nondimensional coefficients.

Report presenting a thermal ice-prevention system for the B-24D airplane. The report includes a description of the design and an outline of the method of design analysis. Results of performance tests of the installation will be presented in a supplementary report.

Report presenting tests in the propeller research tunnel to determine the characteristics at low blade angles of propellers for which high blade angles are already available.

From Summary: "Results are presented of measurement of the pressure drop in ducts produced by two equal 90 degree elbows arranged at three different angular positions to each other, placed adjacent to each other, or separated by straight ducts of various lengths. The measured pressure drops have been analyzed and correlated, and the results are summarized in the form of curves adapted for design computations of pressure drop in compound-duct bends."

Report presenting a method utilizing the Doppler effect on radio signals for determining the speed and distance traveled of an airplane. The method is called the NACA radio ground-speed system and uses the standard radio transmitter already found in most aircraft. Flight tests were made in which the method was used and the results were consisted with calibrated airspeed indications and stop-watch measurements.

Report presenting a detailed account of approximately half of the work planned for a specified contract. The work called for fatigue tests on three simple but basic types of spot-welded test pieces made from 24S-T alclad. The primary purpose of the investigation was determining the mechanism of fatigue failures in the different types of test pieces.

"A method that utilizes the Doppler effect on radio signals for determining the speed of an airplane and the distance traveled by the airplane has been developed and found to operate satisfactorily. In this method, called the NACA radio ground-speed system, standard readily available radio equipment is used almost exclusively and extreme frequency stability of the transmitters is not necessary. No complicated equipment need be carried in the airplane, as the standard radio transmitter is usually adequate" (p. 1).

"Preliminary data are presented on the variation of the maximum lift coefficient with Mach number. The data were obtained from tests in the 8-foot high-speed tunnel of three NACA 16-series airfoils of 1-foot chord. Measurements consisted primarily of pressure-distribution measurements in order to illustrate the nature of the phenomena. It was found that the maximum lift coefficient of airfoils is markedly affected by compressibility even at Mach numbers as low as 0.2" (p. 1).

"The exploration of the processes accompanying engine combustion demands quick-responding pressure-recording instruments, among which the piezoelectric type has found widespread use because of its especially propitious properties as vibration-recording instruments for high frequencies. Lacking appropriate test methods, the potential errors of piezoelectric recorders in dynamic measurements could only be estimated up to now. In the present report a test method is described by means of which the resonance curves of the piezoelectric pickup can be determined; hence an instrumental appraisal of the vibration characteristics of piezoelectric recorders is obtainable" (p. 1).